23 cc Zenoah engine for large scale cars!The engine will be delivered with pull starter, carb and spark plug / spark plug cap. Genuine Zenoah air filter and / or complete clutch and / or ball beard carburetor are optionally available at additional charge.Compatibility Zenoah / Losi 5ive-T:Please note that for installation in a Losi 5ive the fan cover must be swapped for a Losi or CY cover #5341 in order to fit the chassis" bolt pattern.If you want to install a Zenoah engine into the Losi 5ive, you usually have to use a fan cover from the CY engine.However, there is a workaround to maintain Zenoah fan cover.The adjustment is done via the pinion specific mounting plates for the engine. The change always affects only the rear, outer (carburetor side) plate under the fan cover. This is rotated by 180°; so that the embossed number on this plate faces the exhaust side of the engine!18T pinion: use 20T plate, rotated 180°19T pinion: use 19T plate, rotated 180°20T pinion: use 18T plate, rotated 180°On the plus side you gain the opportunity to easily mount a Zenoah engine keeping the original fan cover. On the other hand there will be the disadvantage of the necessity to combine two different sets of engine mounting plates when installing any pinion other than the stock 19T version. Therefore we do not recommend this workaround for everyday use. Nevertheless it works perfectly should ever the need arise. Attention! We recommend to run exclusively fully synthetic 2-stroke engine oil, like y0813 Motul 800 racing oil.
Genuine FG spare/option part. Axially displaced front uprights, the thread for the upper ball is relocated for 3mm towards the center of the car. This increases negative camber and changes the scrub radius during turns. Fits all touring car and race truck models, does not fit offroad and GT-models with wide front axle.Contents:2 pieces
Genuine HPI spare/option part. Spare part for #15448 Baja 5B High Response Clutch Shoe/Spring Set. When used as standard, the clutch will engage at 8000RPM, which is great for low-grip or muddy surfaces. If used with #15440 Clutch Shoe/Spring Set, the clutch will engage at 7000RPM, ideal for high-grip surfaces.Content:2 piece
Manufactured in high-strength alloy. Free from play, twisting-firm with exchangeable ball-type nipple. For mounting the wishbone threaded rods , , , or are needed as well as one ball-type nippe each wishbone.