Tools
The Lightscale Camber Gauge is a black anodised alloy block that features 8 different angled planes in 0.5° steps from 0.5° to 4° on different surfaces.
The gauge is to be layed down beside a tyre for negative camber angles and any 90° part is put on one of the planes an pulled towards the tyre. Doing so you can easily check the camber of your tyres. To check positive camber, just turn around the gauge.
Turning the gauge upside down will make it a 10mm high block to support you measuring the droop of any 1/5, 1/6 and 1/10 scale Electric or nitro car. Those are usually put on 10mm support blocks and beeing measured their droop with a special tool. The Lightscale ride height gauge (50160200) is a droop gauge as well and will do the job for you.
The special tool for Lightscale wheel nuts is simply inserted into the end of a spark plug wrench and is secured there by use of an o-ring. With its 3 hardened pins the tool locates into the wheel nut and may be used to tighten or untighten it. The tool is universally usable for all Lightscale wheel nuts.The kit contains the tool as well as the o-ring and hardened pins. The tool comes ready for use. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.
The Lightscale ride height gauge is a multi tasking tool to measure droop and ride height of your rc/car. On its top side it offers a graded surface to measure ride hight from 2mm to 7mm in steps of 0,5mm and then goes on in steps of 1mm after 7mm. Turning it upside down shows a continuously variable surface with a chart in steps of 0,5mm. The sidewall of the tool furthermore offers a chart which indicates the droop of a 1/5, 1/6 and 1/10 scale electric or nitro car on a 10mm support block.You may also use the tool in combination with Lightscales`camber gauge as the suggested 90° part to measure camber.