y1008 CFH gas

€3.50*

Available

Product number: y1008

EAN: 4001845521039

Product information "y1008 CFH gas"

Genuine HT spare/option part.

Propan/Butan gas mix for the torch above, similar units and cigarette lighters.

Contents:

1 piece / 100 ml

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

Display reviews in current language only.

No reviews found. Share your insights with others.

Customers also bought

6036 FG Ceramic ball bearings, sealed 10x19x7 mm

Genuine FG spare/option part. Why ceramic? Besides corrosion and wear resistance ceramic balls are smoother and have a better shape stability; resulting in less drag from the bearing itself.Are used in all FG and Carson models for bearing the gearshaft.Contents:2 pieces

€20.90*

6040 FG Ceramic ball bearings 10x22x6 mm

Genuine FG spare/option part. Why ceramic? Besides corrosion and wear resistance ceramic balls are smoother and have a better shape stability; resulting in less drag from the bearing itself.Are used in all FG and Carson models for bearing the clutch bell.Contents:2 pieces

€23.90*

6730/05 FG Allen Grub screw M5x5 mm, 15 Stück

Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Content:15 pieces

€3.40*

7427 FG Plastic gearwheel 40 teeth

Genuine FG spare/option part.Suitable for all 1:5 models.Dimensions:Diameter 63 mmWidth 15.5 mmTooth width 12 mmModule: m=1,5Contents:1 piece

€17.90*

7439 FG Alloy gear carrier 52mm - 1pce.

Item N° 7439 Alloy gear carrier 52mm - 1pce.For 44T - 39T spur gears.For 10 mm diameter shafts.

€41.90*

6051 FG Dampening rubber

Genuine FG spare/option part. Rubber pucks for all standard design FG spur gear carriers.Dimensions:Outside diameter: 16 mmInner diameter: 7 mmHeight: 6 mmContents:4 pieces

€8.90*

This product is currently not available.

Customers also viewed

y1013 Motul Air filter oil for foam filters

Genuine Motul spare/option part. High-cling oil for foam cartridge air filters, especially for offroad and street use. The oil reinforces the the air filter'e efficiency and retains dirt, mud and sand particles, which will greatly extend the life of the engine. The blue tint makes it easier to control even oil application to the filter.Apply oil to filter generously and work the foam vigorously by hand to ensure complete oil penetration. Press foam slightly to remove excessive oil when done.Contents:1 piece / 400 ml

Content: 400 Milliliter (€47.25* / 1000 Milliliter)

€18.90*

50353021 Support Blocks for the Lightscale Droop Gauge 35 mm rear, 1 pcs.

Item N° 50353021Support Blocks for the Lightscale Droop Gauge 35 mm rear, 1 pce.This is an Alloy Support Block anodized in black colour with 35mm height.The Support Block is manufactured as a rectangle and so can used as a 30mm as well as a 35mm, depending on which side you choose.The front block uses a single point of support while the rear one comes with two of those. Due to this 3 point support it is assured that even a little tweak in your chassis (none of them is 100% straight) will not affect the result of your measurement. Remove the wheels and tyres from your car and put the car onto the support blocks. Ideally the rear block is positioned to the back of car and the front one just where the servo saver is fixed to the chassis. The car is now propped on the support blocks safely and cannot bounce. Please make sure that no dirt or rubber is trapped between the Support blocks and the chassis.Now you can easily and correctly measure the droop of each axle and adjust the cars` tweak.To do so please use the Lightscale Droop Gauge (50835400)The use of Lightscales` Droop Gauge Support Blocks prevents incorrect measurements and therefore is absolutely reliable. Measurements which are done using a flat surface where the chassis is resting on, like you would use in the pits are usually incorrect due to a slightly tweaked chassis because dirt underneath the chassis will falsify the measurement and lead to a irregular setup. The use of Support Blocks which are based on 4 support points will result in the same incorrect results and downgrade the performance of your car which is why we 100% recommend the use of our support block because as racers ourselves we know all about the problems you may face.

€29.90*

y1007 CFH Diamant M50 gas torch

Genuine HT spare/option part. Powerfull high quality soldering torch with piezo igniter, runs on standard lighter gas. Great for removing bolts that have been installed using thread locking compound. Removable safety base for convenient hands-free operation., adjustable flameTechnical data:Flame temperature: approx. 1.300 °COperating temperature: approx. 650 °CTank capacity: approx. 26 g ButaneConsumption: approx. 20 g/hFlame adjustement: from 12 mm to 32 mmIgnition system: piezo ignition (like electronic lighters)Please note: due to shipment regulations the torch is not filled with gas when delivered!Contents:1 piece

€39.90*

TT1530/350 Top Tuning 5000 mAh LiPo battery 3S, 11,1V 60C Offer

Regular price: [ITEMPRICE]SELF[ENDITEMPRICE] EUROffer of the month price: [ITEMDISCOUNTPRICE]SELF[ENDITEMDISCOUNTPRICE] EURTypical featuresLow inner resistance with high MPVHigher energy density with lower weightLonger lifecycle under proper usage, up to 200 timesFor LiPo batteries, the peak amp rate is usually twice the continuous crateCan be charged with 3C when time is criticalRecommended charge with 2 3CConnectors: EC5, XH-balancer.Dimensions: Length +/- 5 mm: 138,5 mmWidth +/- 1,5 mm: 47 mmHeight: +/- 1,5 mm: 36,5 mmWeight +/- 10g: 363gContents:1 piece

€79.90*

Configure now