7379/08 FG Choke lever for CY / Zenoah / Fuelie
€4.50
Available
Product information "7379/08 FG Choke lever for CY / Zenoah / Fuelie"
Contents:
- 1 piece
150-2 Kitado, Minabe-cho, Hidaka-gun
645-0006 Wakayama
Japan
Login
Customers also bought
Genuine FG spare/option part.Splash water proofed ball bearings for front and rear uprights. Wheel bearing suitable for all FG and Carson models.Contents:2 pieces
Genuine FG spare/option part. New version clutch bell for all FG cars except Formula 1. Contrary to the previous version 6049 the flat areas for the pinion set screws are angled at 90° instead of 180° (see pic).Dimensions:Shaft diameter 10 mmShaft length 38,2 mmOverall length 61 mmAouter diameter bell 58 mmInner diameter bell 56 mmContent:1 pieces
To ensure the required cooling for current 1/5 and 1/6 engines the flywheels have fins on both sides. Therefore the fan housing has large openings on the crankcase side for the required air supply. However, the risk of foreign objects (grass, sand, or even stones!) entering here Is very high! As a result, broken fins on the flywheel occur frequently. This leads to reduced cooling efficiency and - even more critical vibrations from a flywheel which is out of balance due to missing fins. Therefore, this kind of flywheel protection is highly recommended, especially for offroad use. The product video explains the handling in detail! Note:It is essential to thoroughly clean and degrease the crankcase prior to attaching the hook-and-loop tape (OKS2661)!For installation on Chung-Yang and Zenoah engines in FG cars, the crankcase cover must be slightly modified in two places where the engine mount is attached (see Figure 6 and 7). Furthermore the fit of the fabric must be as tight as possible in the region of the layshaft pinion (in front of the differential ring gear!) (see Figure 8).Set includes:Special tailored fabric with sewed on hook-and-loop tapehook-and-loop tape for installation to the crankcaseAdhesive for securing the hook-and-loop tape
Keeps cool air coming to your engine by keeping dirt and grass from clogging up the pull starter area. Easily wipe off anything not deflected away. Installs on the starter cover with hook & loop tape. With metal cable management.If using a FG monster / stadium model an additional hole for the support of the lateral carrier plate has to be cut out.
Suitable for FG CY23, CY26, Zenoah G230RC, G230RC 04, G260RC, G240, G270, G290, ZG22 as well as Solo engines.
Customers also viewed
Genuine FG spare/option part.The set contains FG no.: 6042/05, 6044/05, 7041/05 and 8456/05. Is used to optimize the rear brake (FG no. 7497).Contents:1 set
Genuine FG spare/option part. Wheel / trigger type transmitter with ergonomic designRubber coated non-slip wheelLarge LCD display for easy settings10 model memoriesFHSS ModulationFailsafeDual rate on channels 1, 2 and 3Trims on the 3 channelsLow voltage (9,5V)7573/01 FG receiver 2,4 GHz fpr FG-RS3Contents:1 piece
GRP tire chart from the current series divided into 3 categories 1) Parking lot / hobbyThe durability of the tire is the main focus here.2) Race track / hobbyHere you will find the tire that offers a compromise of durability and performance.3) Race track / competitionHere the racer will find the tires for best lap times on a race track and to win races.Note:The harder a tire compound - the longer it lasts, but the more moderate the performance.The softer a tire compound - the better the performance, but the lower the durability. Hint!As a rule, the same tires can be used for front and rear.If the vehicle tends to oversteer, this can be avoided by using a harder front tire!In wet conditions you should use a rain tire which offers maximum grip under these circumstances.With the use of Magic Rain, a tire traction compound, the grip can be further improved.Check your tires after driving! It can happen that a tire starts to detach from the rim, in this case you should glue this spot immediately with our tire repair kit (y0067), otherwise the tire could detach completely from the rim.So find out which tire is the best for you!New structure conceptIn the new line of tyres, the Belt, Insert an Wheel have also been improved to further improve performance in every race situation and at any temperature of use. Vulcanized Beld with new specific weaves angles. Insert with new variable deformation foam material. Wheel made by Dupont (R) plastc material resistant to high temperatures and flexible at low temperatures.Extraordinary GripThe new tyres of this line provide an incredible Durability even on abrasive asphalt tracks, where the previous compounds lasted less.The difference in Duration is very big with an increase of 35%.Incredible DurationThe new tyres of this line provide an incredible Durability even on abrasive asphalt tracks, where the previous compunds lasted less.The difference in Duration is very big with an increase of 35%.Regularity and PerformanceThe new tyres of this line provide Regularity of abolute performance with each subsequent use, compared to competing tyres.The difference is very big because Performance remains 100% even with each subsequent use, and remains 100% until the tyres is finished. Dimension: Outside diameter: approx. 116 mm Width: approx. 65 mm Rims: 18 mm square driveContent2 pieces / 1 pair
Genuine Zenoah G320RC clutch housing.Modified (milled) clutch housing for installation of a Zenoah G320RC engine in all HPI Baja 5 largescale cars.
Genuine Mielke spare / option part.Spare part for Mielke 6061.Contents:1 piece
TURBO-TWIST, 325 mm long screw driver in top quality.Allows easy access to hard-to-reach screws in any 1/5 & 1/6 car.Features:Soft Grip handlesExtra long 325 mm shaftChrome Vanadium hardened and tempered bladesBlackened magnetic tipsVersions:y1366/01 - Phillips No. 0 / PH0y1366/02 - Phillips No. 1 / PH1y1366/03 - Phillips No. 2 / PH2y1366/04 - Flat 1.2 x 8 x 325 mm