8449 FG Tuning-brake set for brake 97
€49.99
Currently unavailable
Product information "8449 FG Tuning-brake set for brake 97"
The set contains FG no.: 6042/05, 6044/05, 7041/05 and 8456/05.
Is used to optimize the rear brake (FG no. 7497).
Contents:
- 1 set
Login
Accessories / Spare parts
Genuine FG spare/option part. For gear plates 7039/1 oder 7474. Only for use with single brake disc on the layshaft.Contents:1 piece
Customers also bought
Genuine FG spare/option part.Current version for brake with one large disc.Contents:1 piece
High quality flexible fuel line in your choice of blue, red, yellow, orange and green. Size:Length: approx. 1 meterOuter diameter: approx. 6.3 mmInner diameter: approx. 3.2 mmDiameters are 100% identical to the Zenoah Tygon hose #7352!
Genuine FG spare/option part.Suitable for all 1:5 models.Dimensions:Diameter 63 mmWidth 15.5 mmTooth width 12 mmModule: m=1,5Contents:1 piece
Genuine HT spare/option part.This adaptor allows you to install all MadMax/HPI tire/rim combinations on FG, Carso, Smartech 2WD/4WD and other cars with the same wheel shaft configuration. Losi 5ive tires can be used as well, but they hey have to be mounted on MadMax/HPI rims because Losi rims are too thick at the center. The adapter is drilled for 8 mm wheel shafts (FG, Smartech/Carson and many more!), hex size of wheel drive and wheel nut is 24 mm hex with M18x1.0 thread (same as HPI).Please note:FG wheel shafts come with either M6 or M8 thread size. It can even happen that a vehicle has different thread sizes front and rear! Therefore, please make sure which version is required before placing an order.Converting your car takes only a couple of minutes with this easy to install adaptor. just see picture "installation instruction" for a schematic installation.Contents:2 pieces
Item-No.: 69246/01Throttle rods 1:5 4WD, 530, Set
Shim rings to compensate the axial play of the shaft, to use as washers a.s.o.Part is delivered in silver or black color from vendor!
Customers also viewed
Genuine FG spare/option part.Improved rear brake for Marder, Beetle Off-Road, Beetle On-Road and Pajero as well as EcoLine, not for Formula 1. Big epoxy brake disk (diameter 52 mm) for more brake power. Gear carrier is not included in the set. Only in connection with 7039/01or 7474.Contents:1 set
Genuine FG spare/option part. The set will shipped without gear carrier plate. Contents:1 set
Genuine FG spare/option part. For gear plates 7039/1 oder 7474. Only for use with single brake disc on the layshaft.Contents:1 piece
Genuine FG spare/option part. Stock aluminum version for single disc brake.Also available in hardened steel.Dimensions:Height: 14 mmBore: 10 mmSquare: 18 mmContents:1 piece
Genuine Losispare/option part. Mechanical brake for retrofitting in an electric powered Losi 5ive-B or 5ive-T 2.0. An additional servo and a 3-channel remote control are required.If you run the maximum operating voltage approved for an ESC, there is a risk - especially in large scale cars - that under certain circumstances the reverse currents generated by the motor when braking will destroy the esc.For this reason, we recommend using a mechanical brake (as with gas powered vehicles).Please note that Reverse is no longer possible with this configuration!In the ESC settings, you must select the Forward/Brake operating mode. The brake by the controller must be deactivated or set to the lowest possible value. For this job a program card suitable for the ESC is usually required!Set includes: TLR252011 TLR Brake Disc, Pad and Screw Set 5ive-B LOSB3230 Losi Brake Cams & Bushings 5T, TLR 5ive-B and Mini LOSB5901 Losi Throttle/Brake Linkage Set 5T, TLR 5ive-B and Mini Servo mount for throttle / brake servoLosi Servo HS901T Contents:1 set
Suitable for alloy brake caliper, high stopping power.With glued pads.Measures:Length approx. 50 mmWidth approx. 10 mmThickness approx. 3.8 mmMounting hole distance 40 mm
Low priced retrofitable front axle disk brake for all FG 1:5, 1:6, Off-Road 2WD and all 4WD models. also suitable for the 2-damper front axle and the Mono-Shock axle. The disk brake prevents a breaking-out of the rear, has a very sensitive adjustment and is optically very effective. You are able to run this disk brake with the gas servo, but make sure the servo has a minimum regulating power of 6kg. We deliver the disk brake without uprights. Link to the part scout!Content 6020 8093 6105/05 8455 8457/02 8458 8459/01 8461 8461/01 8462/01 8462/02 8462/06 8462/07 8462/05 8463 8464/01 8465