Item N° y0663Sanyo eneloop XX receiver battery 2500 mAh NiMh, 1 pce.Informations about eneloop cells:eneloop XXThe Sanyo eneloop cell eliminates the annoying problem that a charged battery has often lost a high percentage of its storage capacity after just one week. Also, the differences between individual cells in a pack are sometimes significant, reducing the life and performance of the complete pack. Compared to "normal" NiMh cells the Sanyo eneloop cell has a slightly lower capacity and a slightly higher price (in relationship to its capacity), but you get significant advantages in return. With the recently available improved version of the 2005 introduced and widely acclaimed eneloop cell self-discharge for rc-car related time frames is now more or less nonexistent. One could easily charge the cells at New Year?s Eve and use them at Christmas without noticing a significant loss of capacity. Sanyo eneloop cells show a considerably reduced tendency to failure of individual cells in a battery pack. Even after years eneloop cells usually differ by only a few percent. The voltage of the cells is also slightly higher than with normal NiMh cells, so that more volts are available under load. Especially when used in largescale cars with their usually extremely strong servos, this is a particularly important feature! Chargers which are suitable for NiMh cells will also work for eneloop cells. UniversalFGBECHigh currentThe basic features of the eneloop XX version are similar to the standard version, but here the priorities were set slightly different. At the expense of reduced (but easy to cope with for rc-car usage) values for load cycles and self-discharge, capacity could be increased by 25%.- Nominal capacity: 2500 mAh- Maximum number of charge cycles: 500- For cars with up to 3 servos- self-discharge: 25% at 1 yearYou can differentiate the two generations of eneloop cells by checking the model name which is written on each eneloop. The "old" cells have written HR-3UTG (AA) on them, the improved eneloop instead HR-3UTGA (AA)!
Clutch flange bearing for the F1 clutch bell. The clutch bell of the engine is guided through the sparate bedding of the flange bearing. Additional the clutch bell runs centrical to the clutch blocks. The mounting of the flange bearing is only possible in connection with the engine quick fix system and the short F1 clutch bell. Suitable for the F1 Sportsline in combination with Solo and Zenoah engines. Standard equipment of F1 Competition.Shaft size length x diameter: 45 x 10 mm
TAMIYA PS = Polycarbonate spray paints are specially developed for painting unpainted kit body shells. Numerous colour shades are available and allow the individual design of models. Each can contains 100 ml of highly opaque paint, which is oil and fuel resistant, allowing the use on nitro models.The body shell should be degreased and cleaned before use. Best painting results are achieved when thin layers of paint are sprayed on from a distance of approx. 30 cm. Between two spraying processes the paint should dry slightly to avoid "tears".Always follow the painting instructions of models and on the can. Danger warnings: H222 Extremely flammable aerosol. H229 Container is under pressure: may burst when heated. H315 Causes skin irritation. H318 Causes severe eye damage. H335 May cause respiratory irritation. H336 May cause drowsiness and dizziness. EUH066 Repeated exposure may cause skin dryness or cracking. Content: 100 ml spray can with spray headPainting tips: