The pump will fill and empty the fuel tank within seconds.The pump has a vent valve to avoid overpressure. Do not store gasoline for longer than 60 minutes in the gun.Occasionally lubricate the rubber seal of the piston with some grease. To do this, the handle-side cap of the cylinder can be unscrewed and the pump can be disassembled.The clear hose has been blackened in the picture for presentation purpose only.Color: blue.Filling capacity:500 mlContent:1 piece
Genuine HT spare/option part. Fits all CY / Zenoah engines. Laser cutted stainless steel.The long design increases stiffness of the carburetor assembly significantly compared to the previous version. Comes with gasket and mounting bolt.Content:1 piece
Genuine FG spare/option part. Made from T7075 aluminum with wide epoxy insulator plates to protect against engine heat transfer. Venturi-shaped bore increases engine performance.For easier installation removing the cylinder shroud is recommended .Contents:1 Set
Genuine FG spare/option part.Solid front spoiler produced in impact resistant polyamide for the FG Formula 1 models. The complete front spoiler and side parts are manufactured in one piece. The ground colour is black and can be painted over restrictively. This front spoiler is specially suited for the use at competitions. Standard equipment of F1 Competition.Contents:1 piece
Genuine FG spare/option part. Specially produced small hexagon nuts with right-hand thread to fix the steel ball-and-socket joints with the wishbone thread rods M7. Dimensions:Hex size: 8 mmThickness: 3 mmPart is delivered in silver or black color from vendor!Contents:1 piece
Genuine FG spare/option part. Specially produced small hexagon nuts with left-hand thread to fix the steel ball-and-socket joints with the wishbone thread rods M7.Maße:Hex size: 8 mmThickness: 3 mmPart is delivered in silver or black color from vendor!Contents:2 pieces
Genuine FG spare/option part. Solid steel ball-and-socket joints with 4mm boring in the steel ball and M7 left handed thread. Clearance- and maintenance-free. Useable for the F1 front and rear axle instead of the plastic ball-and-socket joints 10mm 10027 and 10027/07.For mounting the wishbone thread rods M7 and hexagon nuts M7 with left-handed thread 10437, 10437/01 are necessary.Dimensions:A = 4 mmB = M7 l/hC = 14.5 mmD = 16.5 mmE = 45.7 mmContents:2 pieces
Genuine FG spare/option part. Solid steel ball-and-socket joints with 4mm boring in the steel ball and M7 right handed thread. Clearance- and maintenance-free. Useable for the F1 front and rear axle instead of the plastic ball-and-socket joints 10mm 10027 and 10027/07.For mounting the wishbone thread rods M7 and hexagon nuts M7 with right-handed thread 10437, 10437/01 are necessary. Dimensions:A = 4 mmB = M7C = 14.5 mmD = 16.5 mmE = 45.7 mmContents:2 pieces
Genuine FG spare/option part.The belt stretcher allows an optimal adjustment of the belt tension only through loosering or tightening of a belt stretching screw. For a change of toothed belt or gear disk a moving and adjusting of the engine is not necessary anymore. If you have a F1 Sportsline the belt stretcher can only be mounted in connection with the engine quick fastening, the clutch flange bearing and the clutch bell. The belt stretcher is standard equipment of the F1 Competition.Contents:1 set
Genuine TT spare/option part.The new and improved failsafe modul.This kill switch module works with most FM and 2.4 GHz rc-systems. Not compatible with AVC-equipped receivers! You must have a free channel on your rc-system in order to install the module! This means at least a 3-channel radio for standard 1-servo brake/throttle setups or a 4-channel radio for dual brake servos driven by the radio's mixer function. With this module you can stop the engine with your radio. Additionally the module features a failsafe function which stops the engine when the rx-battery's voltage drops below a certain level or the rc-system has a glitch. A kill switch module fulfils two tasks. On the one hand, as a safety device, it is intended to shut off an engine with magneto ignition in case of failure of the remote control, and on the other hand, the engine can be stopped at any time by remote control.While the latter is mainly used for convenience, the safety aspect is what really matters.The failsave circuit integrated in all modern remote controls may brake the vehicle in the event of a radio interference, but this feature is dependent on the basic functionality of the receiver system and its power supply. However, if the receiver, the gas servo or the power supply fails completely, the failsave of the remote control can no longer do its job. The vehicle may be running haywire at full throttle.In these cases, the kill switch will cut the ignition of the engine and the vehicle will roll out without power.Features:Ready to install no soldering requiredRemote LED for easy-to-spot operational status (ignition live/killed)Optically coupled to isolate the ignition from the radio systemThreshold value for undervoltage protection (4V, 5V, 6V) adjustable with jumpers allows adaptation to the rx-battery type (LiPo, LiFePo, NiMH, NiCd)Contents:1 piece
Genuine Mecatech spare/option part.New design for the Active Diff! It is lighter, smaller and it haven´t the adjustment screw. The inner parts are the same of the standard version.Heavy-duty, torque dependent self-locking differential with various possibilities for adjustment.The use of four satellite gears distributes the load on four ramps, increasing their service life compared to already existing solutions. Needle bearings on the back of the satellite gears ensure smooth operation of the ramp system.For adaption to the grip conditions you can choose from two different pairs of steel and carbon friction disks and ramp bells. The latter have 3 different ramp angles per pair of bells. All versions are included.Differential spur gear and ball bearings are vehicle-dependent and therefore not included.Content:1 x complete Mecatech Active Diff assembled with bell B for high grip2 x bell A for low grip4 x Carbon discs outer diameter 30 mm4 x Steel discs inner diameter 24 mm1 x Bottle of diff oil
€449.90*
This product is currently not available.
This website uses cookies to ensure the best experience possible. More information...