10450 FG Front disk brake for F1 - set

€99.99*

Available

Product number: fg_10450

EAN: 3410564526552

Product information "10450 FG Front disk brake for F1 - set"

Retrofitable bowden cable disk brakes for Formula 1 Sportsline and Competition models. Essentially improved brake power compared to the standard brake, sensitive adjustment.

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

Display reviews in current language only.

No reviews found. Share your insights with others.

Accessories / Spare parts

y1337 Epoxy P-R-M Race brake discs for FG / Smartech / Carson

Top quality epoxy P-R-M Race brake discs with 10 dirt slots for removing dirt and abrasion, which will be transferred to the outside by the discs rotation. The epoxy P-R-M Race brake disc provides an optimal deceleration of the car without the unwanted fading (poor braking performance due to increased heat buildup)! The best braking action when using the epoxy P-R-M Race brake disc is achieved by the combination of the epoxy brake discs and steel brake pads (8456 or y19218). The epoxy P-R-M Race brake discs fit mechanical front and rear brakes on FG / Smartech / Carson cars with brake pads 8456 recommended for these applications.1 pair (2 pieces) Dimensions: Outer diameter: 60 mm Thickness: 2 mmsocket for 18 mm square wheel drive

€22.90*

Similar products

10455 FG Polyamide front spoiler for F1

Genuine FG spare/option part.Solid front spoiler produced in impact resistant polyamide for the FG Formula 1 models. The complete front spoiler and side parts are manufactured in one piece. The ground colour is black and can be painted over restrictively. This front spoiler is specially suited for the use at competitions. Standard equipment of F1 Competition.Contents:1 piece

€37.00*

10437/01 FG Hexagon nut M7 left-handed thread

Genuine FG spare/option part. Specially produced small hexagon nuts with left-hand thread to fix the steel ball-and-socket joints with the wishbone thread rods M7.Maße:Hex size: 8 mmThickness: 3 mmPart is delivered in silver or black color from vendor!Contents:2 pieces

€5.30*

10450/01 FG Bowden cable for front disk brake for F1 - set

Cable: 465 mmSheath: 385 mmSpare part for .

€19.70*

10451/01 FG Bowden cable for rear disk brake F1 - 1pce.

Cable: 690 mmSheath: 580 mmSpare part for .

€23.90*

10466/06 FG Foam filter inserts oiled - 2pcs.

Spare part for and .

€7.90*

10451/05 FG Servo rods for rear disk brake F1

Genuine FG spare/option part. Spare part for .Content:2 pieces

€7.90*

10466/01 FG Cover for FG inlet silencer - 1pce.

Spare part for and .

€25.90*

10437 FG Hexagon nut M7 right-handed thread

Genuine FG spare/option part. Specially produced small hexagon nuts with right-hand thread to fix the steel ball-and-socket joints with the wishbone thread rods M7. Dimensions:Hex size: 8 mmThickness: 3 mmPart is delivered in silver or black color from vendor!Contents:1 piece

€5.30*

10435/01 FG Steel ball-and-socket joint F1 Ø4/M7 left

Genuine FG spare/option part. Solid steel ball-and-socket joints with 4mm boring in the steel ball and M7 left handed thread. Clearance- and maintenance-free. Useable for the F1 front and rear axle instead of the plastic ball-and-socket joints 10mm 10027 and 10027/07.For mounting the wishbone thread rods M7 and hexagon nuts M7 with left-handed thread 10437, 10437/01 are necessary.Dimensions:A = 4 mmB = M7 l/hC = 14.5 mmD = 16.5 mmE = 45.7 mmContents:2 pieces

€29.90*

10436 FG Steel ball-and-socket joint F1 Ø5/M7 right

Genuine FG spare/option part. Solid steel ball-and-socket joints with 4mm boring in the steel ball and M7 right handed thread. Clearance- and maintenance-free. Useable for the F1 front and rear axle instead of the plastic ball-and-socket joints 10mm 10027 and 10027/07.For mounting the wishbone thread rods M7 and hexagon nuts M7 with right-handed thread 10437, 10437/01 are necessary. Dimensions:A = 5 mmB = M7C = 14.5 mmD = 16.5 mmE = 45.7 mmContents:2 pieces

€29.90*

10457/01 FG Clutch flanged bearing - 1pce.

Spare part for .

€87.95*

10465 FG Alloy ball-and-socket joint F1 - 40pcs.

Alloy ball-and-socket joint with surface coating, 70% less weight, easy-running and resistant to wear.

€45.90*

Customers also viewed

TT0990 Top Tuning Failsafe with kill switch and status LED for all transmitters

Genuine TT spare/option part.The new and improved failsafe modul.This kill switch module works with most FM and 2.4 GHz rc-systems. Not compatible with AVC-equipped receivers! You must have a free channel on your rc-system in order to install the module! This means at least a 3-channel radio for standard 1-servo brake/throttle setups or a 4-channel radio for dual brake servos driven by the radio's mixer function. With this module you can stop the engine with your radio. Additionally the module features a failsafe function which stops the engine when the rx-battery's voltage drops below a certain level or the rc-system has a glitch. A kill switch module fulfils two tasks. On the one hand, as a safety device, it is intended to shut off an engine with magneto ignition in case of failure of the remote control, and on the other hand, the engine can be stopped at any time by remote control.While the latter is mainly used for convenience, the safety aspect is what really matters.The failsave circuit integrated in all modern remote controls may brake the vehicle in the event of a radio interference, but this feature is dependent on the basic functionality of the receiver system and its power supply. However, if the receiver, the gas servo or the power supply fails completely, the failsave of the remote control can no longer do its job. The vehicle may be running haywire at full throttle.In these cases, the kill switch will cut the ignition of the engine and the vehicle will roll out without power.Features:Ready to install no soldering requiredRemote LED for easy-to-spot operational status (ignition live/killed)Optically coupled to isolate the ignition from the radio systemThreshold value for undervoltage protection (4V, 5V, 6V) adjustable with jumpers allows adaptation to the rx-battery type (LiPo, LiFePo, NiMH, NiCd)Contents:1 piece

€54.90*

Details

6205221 Roadies F1 Slick tyres Formel 1, front, ready glued on rims, white

Roadies Formular 1 tire chart from the current series divided into 3 categories 1) Parking lot / hobbyThe durability of the tire is the main focus here.2) Race track / hobbyHere you will find the tire that offers a compromise of durability and performance.3) Race track / competitionHere the racer will find the tires for best lap times on a race track and to win races.Note:The harder a tire compound - the longer it lasts, but the more moderate the performance.The softer a tire compound - the better the performance, but the lower the durability. Hint!As a rule, the same tires can be used for front and rear.If the vehicle tends to oversteer, this can be avoided by using a harder front tire!In wet conditions you should use a rain tire which offers maximum grip under these circumstances.With the use of Magic Rain, a tire traction compound, the grip can be further improved.Check your tires after driving! It can happen that a tire starts to detach from the rim, in this case you should glue this spot immediately with our tire repair kit (y0067), otherwise the tire could detach completely from the rim.So find out which tire is the best for you!Genuine Roadies spare/option part. 2015 ROADIES Tyres are improved and based on our successful experiences of the last couple of years, in which our tyres won the European Championships 2012/2013 and 2014. The complete four Tyre set weights about 1320 g and the reduced diameter eliminates rotating mass at the outer edge of the tyre which is more effective than saving weight closer to the rotating axle, plus the tyres` lower profile make steering more precise especially through fast chicanes. After winning the 2012, 2013 and 2014 European Championship we can promise you a winning capable Tyre for 2015 without having to change it throughout the season.The all new F1 compound is super soft and especially developed for cold temperatures like 0° to 20° Celsius while the F2 compound is to be compared to our 2014 Pro Tyre. This one works best from 10° to 25° Celsius. F3 is our 2015 code for the 2014 Option Tyre and works best from 15° to 40° Celsius.Contents:2 pieces

€47.90*

7058/01 FG Body screws Torx with stop nuts, 15 pieces

Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Set includes:15 x Torx body screws M3 x 10 mm15 x Washers15 x M3 Hexagon nut

€7.50*

6250/03 FG Front disk brake for Monster-Truck - set

Front disc brake hop-up for monster and stadium models with dual shock front axle. Significantly improved braking preformance without rear axle lock-up.Attention!!Can only be installed in connection with the alloy uprights .

€99.50*

8179 FG Body set BMW M3 ALMS with M Power painting for 530/535 wheelbase

The Set contains the front body, the main body, the rear body, the spoiler-set and the body screws. The body shell is vac-formed from 2 mm Lexan.The body shell does not come with drilled mounting holes to make it possible to fit any 1/5 car with 530/535 mm wheelbase. The set is delivered as shown.Required body mounts:Mount front: FG 7020/12 Front bumperRear body mount: FG 7152/01 Rear body mount Side body mount front: FG 7014 Body mountsSide body mount rear: FG 7014 Body mountsMeasures:Length: 890 mmWidth: 392 mmHeigth: 260 mmWheelbase: 530 mm

€299.50*