LOS251053 Losi Roll Cage, Flip, Complete, DBXL-E

€119.99*

Prices incl. VAT plus shipping costs

Available

Product number: losi_los251053

EAN: 605482048993

Product information "LOS251053 Losi Roll Cage, Flip, Complete, DBXL-E"

Genuine Losi spare/option part.

Contents:

1 set

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

Display reviews in current language only.

No reviews found. Share your insights with others.

Similar products

LOS252017 Axle Boot Set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:10 pieces

€29.99*

LOS252009 Differential Rebuild Kit Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€8.99*

LOS250055 Losi Wing, FOX Racing, DBXL-E 2.0

Genuine Losi spare/option part. Contents:1 piece

€29.99*

LOSA99172 Camber Gauge

Genuine Losi spare/option part. Contents:1 piece

€19.99*

LOS252006 Front/Rear Differential Outdrive Set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:2 pieces

€29.99*

LOS250016 Body Set, Screened, black, DBXL-E

Genuine Losi spare/option part. Contents:1 set

€169.99*

LOS251012 Radio tray & gas tank mount Losi DBXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€59.99*

Details

LOS250019 Losi LED Light Bar set, complete, DBXL-E

Genuine Losi spare/option part. Contents:1 piece

€59.99*

LOS251045 Losi Wing Mount, Complete, DBXL-E

Genuine Losi spare/option part. Contents:1 set

€39.99*

LOS252001 Driveshaft & Axle Dogbone Losi DBXL 1/5 4WD

Genuine Losi spare/option part. Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:2 pieces

€39.99*

LOS252004/01 Differential bevel gears set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€32.90*

Details

LOS252005 Front & Rear Gear Box Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€25.99*

Details