LOS256999 Sealed bearings, complete set Losi DBXL-E 2.0, DBXL+MTXL 1/5 4WD

Genuine Area spare/option part. Spare part for AREA-XL 008 Wheel spacer for using the 5ive-T and HPI wheels with the Losi Desert XL.The O-rings are used as additional retainers fort he drive pins.Content:4 pieces

Genuine Losi spare/option part.Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:1 set

Genuine HT spare/option part.Available as 272 high strength and heat resistant, 270/1 high strength or 241 medium strength.The strength of 272 and 270/1 is comparable, but 272 can handle temperatures up to 230°C vs. 150°C for 270/1. It is therefore the perfect choice for applications like exhaust or clutch pinion bolts. However, curing of 272 takes at least twice as long as 270/1.An excellent recommendation for removal of screws treated with threadlocking compound:CFH Diamant M50 Gasbrenner, y1007 Contents:1 piece / 10 gram

Genuine Futaba spare/option part. This Futaba R304SB-E is very similar to the R304SB (FUTL7680) in that they both feature 4-channels, both feature S.Bus2, both are Telemetry enabled and both cost roughly the same price.However, the two receives differ in two fundamental areas: this R304SB-E is only intended for electric vehicles, the R304SB is electric/nitro/gas, and this R304SB-E features the benefit of having a non-exposed built-in antenna - the R304SB is fully exposed.Features:T-FHSS SystemTelemetry Enabled4-ChannelsBuilt-in Hidden AntennaElectric Vehicle Use OnlySpecifications: Futaba System: T-FHSS S.Bus2: Yes Channels: 4 Range: 70m (230ft) (at best conditions) Power Requirement Rated Voltage: 4.8-7.4V Usable Voltage: 3.5-8.4V Size: 1.38x0.91x0.33" (35.1x23.2x12.5mm) Weight: 0.23oz (6.7g) Contents:1 piece

Genuine Losi spare/option part. Scope of delivery see photos.Contents:1 set