5116/01 FG 3-unit tunned pipe for 510 mm and 465 mm wheelbase
€124.95
Available
Product information "5116/01 FG 3-unit tunned pipe for 510 mm and 465 mm wheelbase"
Stock tuning pipe for all 1/5 scale cars and Trucks models with engine in horizontal position. Now in noise-limited three-chamber version.
Contents:
- 1 piece
Lebacher Strasse 4
66113 Saarbrücken
Germany
Login
Accessories / Spare parts
Is need for mounting all FG tuning pipes.2 pieces 16 - 27 mm, 1 piece 40 - 60 mm
Genuine FG spare/option part. Recommended accessory for installation of tuned pipes using teflon tube connectors. Contrary to standard hose clamps this version is self-readjusting down until 20 mm inner diameter!Width 12 mm.Content:2 pieces
Genuine HT spare/option part. RC Tech Pipe Protect protects your exhaust against oil and rubber deposit while racing. A clean exhaust gives better resonance, which means better performance from your engine. Thanks to RC Tech Pipe Protect your exhaust system can evacuate the temperature better.Direction of useSpray a relatively thick layer of Pipe Protect from a close distance; +/- 15/20 cm on your new or just-cleaned and preferably polished exhaust pipe. After each ride clean the exhaust pipe with a clean cloth, if necessary slightly sprayed with some Pipe Protect. Treat the exhaust pipe again before each race.Contents:1 piece / 400 ml
Content: 400 Milliliter (€24.75 / 1000 Milliliter)
Especially for installation of all engine gaskets. Temperature resistant from -55 °C to +200 °C. Resistant to water, mineral oils, synthetic lubricants, fuels, organic solvents and refrigerants. info: Hand tight: 10 - 20 minReady to use: 1 - 3 hoursGap fill: 0.5 mmContent: 50 ml Notes for usage: This surface seal is not for use as the sole sealant, it should always be applied in combination with a paper gasket.The HT-surface sealing agent should be sparsely applied over the entire surface, with care being taken that the sealant does not enter the devices internals (e.g. crankcase, differential a.s.o.) during the assembly.
Content: 50 Milliliter (€538.00 / 1000 Milliliter)
Customers also bought
Genuine FG spare/option part. Steel brake rotor for single disc brake, only for use in combination with competition brake pads.Dimensions:Diameter: 52 mmSquare size: 18 mmContents:1 piece
Genuine FG spare/option part.Current version for brake with one large disc.Contents:1 piece
Is need for mounting all FG tuning pipes.Wire diameter 2 mm
Genuine FG spare/option part. Suitable for CY / Zenoah G230/240/260/270.Contents:1 piece
Genuine FG spare/option part. Rigid plastic rear plate. Fits all FG 2WD cars except Evo/Competition and Formula 1.Content:1 Piece
Genuine FG spare/option part. For single disc brake only.Measures:Length: 91 mmDiameter: 6 mmThread: M3Contents:1 set
Customers also viewed
Original FG product The 3-chamber tuning resonance pipe is supplied without manifold and mounting supplied. 1 piece
Suitable for FG and all 1:5 models with horizontal Zenoah or Solo engine in combination with a tuning pipe.
Genuine FG spare/option part. Contents:1 piece
Complete tuned pipe system, will be delivered as shown with manifold, hose with clamps and variable mount. Fits FG and Carson touring cars / GTs with long wheel base.The tuned pipe is for a 535 wheelbase. The diameter is 51 mm and the complete length is about 300 mm.
