y804 HT-flange sealer 518, 50 ml up to 200°C
€26.90
Available
Product information "y804 HT-flange sealer 518, 50 ml up to 200°C"
Temperature resistant from -55 °C to +200 °C. Resistant to water, mineral oils, synthetic lubricants, fuels, organic solvents and refrigerants.
info:
- Hand tight: 10 - 20 min
- Ready to use: 1 - 3 hours
- Gap fill: 0.5 mm
- Content: 50 ml
Notes for usage:
This surface seal is not for use as the sole sealant, it should always be applied in combination with a paper gasket.
The HT-surface sealing agent should be sparsely applied over the entire surface, with care being taken that the sealant does not enter the devices internals (e.g. crankcase, differential a.s.o.) during the assembly.
Login
Customers also bought
Item N° y19281 HT-tire adhesive 4000, 1pce.1 piece / 20 grammsHT-tire cement, specially formulated for rubber/plasticContent:20 gr bottle
Content: 20 Gramm (€345.00 / 1000 Gramm)
Fully synthetic oil, available in three blends. 1-liter bottle.The optimal 2-stroke oil for 23-30 cm³ engines/cars Motul Racing Oil is available in three different blends: On-Road for high revving onroad cars Off-Road for cars with high torque enginesMixing ratio for 1/5 & 1/6 applications: We recommend a mix with about 4% oil, which means 200 cc of oil to 5 litres of gas (1:25 ratio). With one litre of Motul oil you can mix about 25 litres of optimal fuel for your 1/5 or 1/6 car. That's enough for well over 20 hours of driving fun! Oil / Gas Oil percent Oil per 1 liter of gasoline Oil per 2 liter of gasoline Oil per 3 liter of gasoline Oil per 4 liter of gasoline Oil per 5 liter of gasoline 1:20 5% 50 ml 100 ml 150 ml 200 ml 250 ml 1:25 4% 40 ml 80 ml 120 ml 160 ml 200 ml 1:30 3,33% 33 ml 67 ml 100 ml 134 ml 167 ml 1:33 3% 30 ml 60 ml 90 ml 120 ml 150 ml 1:35 2,86% 29 ml 58 ml 86 ml 115 ml 143 ml 1:40 2,5% 25 ml 50 ml 75 ml 100 ml 125 ml 1:50 2% 20 ml 40 ml 60 ml 80 ml 100 ml
The pump will fill and empty the fuel tank within seconds.The pump has a vent valve to avoid overpressure. Do not store gasoline for longer than 60 minutes in the gun.Occasionally lubricate the rubber seal of the piston with some grease. To do this, the handle-side cap of the cylinder can be unscrewed and the pump can be disassembled.The clear hose has been blackened in the picture for presentation purpose only.Color: blue.Filling capacity:500 mlContent:1 piece
Item-No. 69265plastic-wishbone front bottom 2WD/4WD, 530, 2 pcs.Original plastic-wishbone, front bottom.For older 2WD models that are not based on the 4WD models, please refer to Sportsline 2008. or if an RC plate is no longer fitted, check Sportsline 13 in Parts Scout.There you will find the right spare parts for your vehicle.
Genuine Mielke spare/option part. Contents:1 piece
Genuine FG spare/option part.New version with more steering.Contents:2 pieces
Customers also viewed
Product Safety DangerCauses serious eye irritation.Highly flammable liquid and vapour.May cause drowsiness or dizziness.Repeated exposure may cause skin dryness or cracking.Marston Universal blue is the leading non-setting gasket and sealing compound in use world-wide. The product is used by many of the world?s major automotive manufacturers and by several Formula 1 teams.Features- Non hardening and non setting- Unlimited assembly time- Vibration resistant- Allows metal to metal contact- Resistant to combustion products, water, engine coolant, petroleum, lubricating oils, kerosene and fluorocarbon refrigerants- Seals surface imperfections- Withstands rapid variations in temperature80 ml tube
Content: 80 Milliliter (€123.75 / 1000 Milliliter)
Hazard and Precautionary StatementsHazard Statements (H-Code)H222Extremely flammable aerosol.H229Pressurized container: may burst if heated.H319Causes serious eye irritation.H336May cause drowsiness or dizziness.Precautionary Statements (P-Code)P210Keep away from heat, hot surface, sparks, open flames and other ignition sources. No smoking.P251Do not pierce or burn, even after use.P305P351P338IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.P337P313IF eye irritation persists: Get medical advice/attention.P403P233Store in a well-ventilated place. Keep container tightly closed.P410P412Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.Supplemental hazard information.EUH066Repeated exposure may cause skin dryness or cracking.Farbe:Lexan SprayInhalt:150mlProduct information "RC - Paint Lexan special colors, spraycan (Offer) Buy 3 get 4"For every 3 cans purchased you will get 1 can for free.For example: if you select 4 cans our shop will charge them all when putting in the basket, but deduct one can during the check-out procedure later.RC - Paint is a special paint for lacquering RC-Car Lexan (Polycarbonate) body shells. The ultra-fine mist provides optimal coverage!Through an optimized atomizer valve an outstanding painting result is guaranteed.RC-Paint Lexan color is produced in a particularly environmentally friendly.The composition of colors (color pigments) was placed on the lowest possible heavy metal content and the best possible environmental compatibility of the solvent and propellent gas value.Contents:1 piece / 150 mlThe content of the can is 150ml and suffices - depending on the intensity of the painting, - for one 1/8 or two 1/10 body shells. Two to three cans are needed for a 1/5 or 1/6 body shell.
Bindulin liquid rubber - very high elasticitySuitable for additional sealing of tuned pipes and exhaust / manifold connections .Temperature resistant from -60 ° to + 180 ° CResistant against diluted acids.Also for sealing threaded joints, electric lines and cable lead-throughs in receiver boxes.The surfaces must be clean, grease free and dry (brake cleaner).Contents:1 piece / 45 grams
Content: 45 Gramm (€331.11 / 1000 Gramm)
Original Zenoah 32 cm³ Rebuilt kit Top quality with Zenoah warranty!Set includes the following parts: CylinderPistonPiston ringCylinder foot gasketPiston pinPiston pin clipThrust washer for needle bearingCover for transfer portAttention: For the assembling of the covers enclosed please use the HT-flange sealer y804 and pay attention to the assembling instructions enclosed.Please note:It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. We also recommend:y0804 HT-flange sealer 518 y0994 Marston sealery0807 MD-Sil RTV silicone sealer
Genuine HT spare/option part.Available as 272 high strength and heat resistant, 270/1 high strength or 241 medium strength.The strength of 272 and 270/1 is comparable, but 272 can handle temperatures up to 230°C vs. 150°C for 270/1. It is therefore the perfect choice for applications like exhaust or clutch pinion bolts. However, curing of 272 takes at least twice as long as 270/1.An excellent recommendation for removal of screws treated with threadlocking compound:CFH Diamant M50 Gasbrenner, y1007 Contents:1 piece / 10 gram
Content: 20 Gramm (€690.00 / 1000 Gramm)
New ignition system for RC Car race engines with air baffles, special 62 mm balanced flywheel, modified ignition coil mount and special Löhin tuning ignition (#1361). For Zenoah G230/240/260/270/290/320 und CY / Fuelie / Losi engines.A much smaller and lighter flywheel, in conjunction with the special air baffles, ensures that the engine gets more cooling air then with previously available modified flywheels! The fan from the CIS-ignition with fins on both sides is about 30% lighter (!) than the stock version! Needless to say an engine equipped with such a flywheel revs considerably faster and significantly higher, of course. This in itself is nothing new, because modified flywheels, even though not 30% lighter, are pretty common on modified engines. However, the problem with these modified flywheels is maintaining sufficient cooling for the engine, which is absolutely mandatory for a reliably running engine! The 20% smaller in diameter flywheel is primarily responsible for the very substantial performance increase by the SPEED TEC CRANK ignition . The lower inertia, which is quite crucial for engine performance, allows for an extremely fast and higher revving engine! The air baffles of the CIS-ignition ensure that the path of the cooling air is matched to the reduced diameter of the CIS-fan wheel and the engine gets more cooling! As our product video shows, the stock engine gained near 2,000 rpm through installation of the SPEED TEC CIS-ignition ! But perhaps the optimized torque is even more convincing. This for 30% reduced and 20% more centrally positioned flywheel mass gives your engine a stunning power increase. Other benefits of SPEED TEC CIS - ignition system: Fits all Zenoah, as well as HPI, Losi-, CY 1/5 & 1/6 engines (incl. Zenoah G320) No modifications to the cylinder or the ignition coil mount required! No assembly of the flywheel, thus 100% exact fit and running true The enclosed Löhin ignition system is designed for speeds up to 25,000 rpm! The baffles protect the flywheel from debris (stones, etc.) Complete with Löhin ignition and all necessary parts in a nice special bag Easy installation: Remove the stock ignition system - install the CIS-ignition - done! The color of the ignition cable and the spark plug cap may vary.