y0735 Safety clip for Universal / JR / Futaba connectors
Genuine HT spare/option part. Protects the mated connection to prevent them from coming apart accidentally. Particularly recommended for direct power supply cords, as a tensile load on the cable can remove the link unnoticed and then you would perhaps think of a servo failure in the first place.The small size usually allows the installation even inside the receiver box.Also suitable for securing the connection of the receiver battery; the use of this clip means a big improvement in safety with little effort.Contents:1 piece
TT1499 Top Tuning Safety Bag for LiPo batteries
Genuine Top Tuning spare/option part.For secure transport and storage of LiPo batteries. For batteries up to approx. 175 x 75 x 70 mm.Contents:1 piece
y1564/18 No-wire adapter EC5 male to EC8 connector female
Genuine HT spare/option part.Space-saving no-wire adapter, just 61 mm long.Contents:1 piece
6544/01 FG Charging cable EC8 with gold contacts
Genuine FG spare/option part.Contents:1 piece
y1564/17 No-wire adapter EC8 male to EC5 connector female
Genuine HT spare/option part.Space-saving no-wire adapter, just 61 mm long.Contents:1 piece
y0362 Servo direct power supply cable, 1 pce. selection
Servo direct power supply cable, 1 pce.With this cable the servos get their current directly from the battery without straining the receiver circuit board.Silicone insulated wires with 0.5 mm² cross section
6545 FG gold contact plug-in system 2mm - 2pcs.
Item N° 6545 FG gold contact plug-in system 2mm - 2pcs.Reverse battery protected gold contact plug-in system. A further great advantage of our plug-in system is the fixing of a plug on the receiver box or rc-plate with screws. This makes the connection of plug and bush easier.
6547 FG Receiver cable FG gold contact/Futaba - 1pce.
Receiver cable, ready-made with FG gold contact plug-in system for Futaba plug.total length 20-25cm
y1303/12 EC8 female connector
Genuine HT spare/option part.Two-pole, reverse-polarity protected socket with very high current capacity. The opening in the contact for the cable has a diameter of 6.5 mm, which is suitable for stranded cables up to about 16 mm² (~ 5 AWG). The easy to grab housing ensures easy disconnection.For assembly, the contact with a soldered cable is press fitted into the housing from the front, where it snaps into place.When used without the blue housing, the contacts are also compatible with the 8 mm bullet connectors found on many larger brushless motors.Contents:1 piece
y0425/01 Y-harness, silicone insulated, universal/JR
Genuine HT spare/option part. The Y-harness is required for running two servos on a single receiver channel. Top quality heavy gauge 0.5 mm² cable with silicone insulation, 150 mm long, suitable for all rc-systems.Content:1 piece
y1303/11 EC8 male connector
Genuine HT spare/option part.Two-pole, reverse-polarity protected plug with very high current capacity. The opening in the contact for the cable has a diameter of 6.5 mm, which is suitable for stranded cables up to about 16 mm² (~ 5 AWG). The easy to grab housing ensures easy disconnection.For assembly, the contact with a soldered cable is press fitted into the housing from the front, where it snaps into place.When used without the blue housing, the contacts are also compatible with the 8 mm sockets found on many larger ESCs.Contents:1 piece
y1303/08 EC5 charging cable
Genuine HT spare/option part.Charging cable for batteries with ES5 connector, length approx. 30 cm, silicone insulated cable with gold-plated connectors.Contents:1 piece
F003/2 Carson Universal On/Off Switch
Genuine Carson spare/option part. Contents:1 piece
TT1000 Top Tuning Electronic 20 Amp Bigscale high voltage 30 Volt switch
Genuine Top Tuning spare/option part. Top Tuning The 20-amp Bigscale switch allows for a maximum input voltage of 30 volt. It is specifically designed as a receiver switch for use in combination with the Hitec HS-1005SGT servo and 4s receiver battery. The switch can also be used for other applications at your discretion with batteries up to 6S.Note: Top Tuning the electronic 20 amp Bigscale high voltage switch delivers the batterys full voltage. It does not replace a voltage regulator! The components which follow down the line (voltage regulator / servos / receiver) must be matched to this voltage! Using the latest MOSFET technology allows the 20 amp Bigscale high voltage switch to handle extreme loads, despite its small size. A blue LED status light clearly displays the activated mode. The 20 amp Bigscale high voltage switch is dust-and splash protected. He has an extremely low internal resistance and very low power consumption in off mode. Nevertheless it is recommended to unplug the battery when the model will not be used for an extended period. Properties:Voltage range: 3 to 30 VLoad: 20 ampsStandby consumption: 17 µAOperating temperature: - 15 ° C to +50 ° CCable length:Battery side 250 mmReceiver side 130 mmWeight: 13 gramsDimensions:Length: 29 mm Width: 13 mmHeight: 12 mmContents:1 piece
6545/01 FG gold contact plug-in system 2mm - 10pcs.
Item N° 6545/01 FG gold contact plug-in system 2mm - 10pcs.Reverse battery protected gold contact plug-in system. A further great advantage of our plug-in system is the fixing of a plug on the receiver box or rc-plate with screws. This makes the connection of plug and bush easier.
y1564/04 No-wire adapter EC5 male to XT60 female
Genuine HT spare/option part.Space-saving no-wire adapter, just 50 mm long.Contents:1 piece
y1564/12 JR/Futaba/Universal Patch cable
Genuine HT spare/option part.JR/Futaba/Universal female to female extension, Length approx. 10 cm.Useful for wiring of the receiver inside the UFRC GX1 RX-box or similar applications. Contents:1 piece
y1564/01 XT60 connector male / female
Genuine HT spare/option part.Wählbare Versionen: y1564/01S - Male connector y1564/01B - Female connector y1564/01SB - One each male and female connectorContents:1 piece
Receiver switch, universal connectors, F1408 - 1pce.
Futaba / universal type connectors for both battery and receiver.
Receiver switch, BEC connectors, cs503024 - 1pce.
BEC type connectors for both battery and receiver.
y1544 LiPo CellMeter 3 in 1 Tester, balancer and discharger, with servo tester
Genuine rc-car-online spare/option part. Compatible with up to 8S lithium batteries. In addition to the LiPo Tester, the CellMeter also has a built-in servo tester. This makes it possible to check at any time whether the servos are working properly.Technical data:High visibility LCD displayBalancer functionDischarge functionVery accurate battery checkSuitable for Li-Ion, LiPo, LiFe, LiHv, NiCd, NiMh batteries (up to 8 cells)Battery type and Zellenanzahl will be recognized automaticallyVoltage displayed individually for every cellWeight: 48gDimensions LxWxH: 84 mm x 52 mm x 15 mmContents:1 piece
y1564/16 No-wire adapter XT90 male to EC8 connector female
Genuine HT spare/option part.Space-saving no-wire adapter, just 58 mm long.Contents:1 piece
y1564/06 No-wire adapter EC8 male to XT90 female
Genuine HT spare/option part.Space-saving no-wire adapter, just 56 mm long.Contents:1 piece
6544 FG Charging cable for receiver battery with FG plug
Genuine FG spare/option part. Polarized and gold plated connector system.Content:1 piece