Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

y0425/01 Y-harness, silicone insulated, universal/JR

Product information "y0425/01 Y-harness, silicone insulated, universal/JR"

Genuine HT spare/option part.

The Y-harness is required for running two servos on a single receiver channel. Top quality heavy gauge 0.5 mm² cable with silicone insulation, 150 mm long, suitable for all rc-systems.

Content:
  • 1 piece

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Customers also bought

Average rating of 0 out of 5 stars

y6479 HT rear alloy upright
Genuine HT spare/option part.Alloy upright for a ball fastening at the upper wishbone. Adjustable at the lower wishbone (hinge pin), too. Fits the rear axle of all FG and Carson / Smartech 1/6 scale cars.Comes with adjustment clips and grub screws for the hinge pins included.Dimensions:Bearing seats: 22 x 7 mmHinge pin bore: 6 mmDistance wheel shaft/hinge pin: 25 mm Contents:2 pieces

€89.90*

Average rating of 0 out of 5 stars

y1046 Clemps for hydraulic brake lining 4 mm
Genuine rc-car-online spare/option part. Clemps for hydraulic brake linings with a outside diammeter of 4mm. e.g Colari, Magura II and Mecatech.Contents:8 pieces with mounting screws

€9.50*

Average rating of 0 out of 5 stars

DYNE1240 Dynamite Large Scale Safety Kill Switch
Genuine Dynamite spare/option part.Key Features:Kills your 2-cycle gas engine on command, loss of radio signal, low battery, or total battery power lossComes ready to install no soldering requiredOptically Coupled to isolate your ignition system from your radio systemBuilt-in LED for easy-to-spot operational status3-Channel Radio System RequiredNot Compatible with AVC-Equipped ReceiversContents:1 piece

€39.99*

Average rating of 0 out of 5 stars

6022 FG Flexible antenna short 190 mm
Genuine FG spare/option part. Tube measures:Inner diameter: 2,2 mmOutside diameter: 4 mmLength: 190 mmContents:2 pieces

€4.30*

Average rating of 0 out of 5 stars

y1036 HT rose joints with conical spacers
Genuine HT spare/option part. Dimensions:A = 5 mmB = 6 mmC = 8 mmD = 13 mmContents:2 pieces rose joints4 pieces conical spacers

€24.90*

Average rating of 0 out of 5 stars

y1045 hydraulic brake lining 4mm - 1 St
hydraulic brake linings with a outside diammeter of 4mm. e.g Colari, Magura II and Mecatech.Length: 1 meterDimensions:Inner diameter: 2 mmOuter diameter: 4 mm

€4.90*

Customers also viewed

Average rating of 0 out of 5 stars

y0735 Safety clip for Universal / JR / Futaba connectors
Genuine HT spare/option part. Protects the mated connection to prevent them from coming apart accidentally. Particularly recommended for direct power supply cords, as a tensile load on the cable can remove the link unnoticed and then you would perhaps think of a servo failure in the first place.The small size usually allows the installation even inside the receiver box.Also suitable for securing the connection of the receiver battery; the use of this clip means a big improvement in safety with little effort.Contents:1 piece

€1.50*

Average rating of 0 out of 5 stars

y0037/04 Screw for throttle lever, high strength, 4-40 UNC x 1/8“, 3 pices
High strength mounting screw for the throttle lever on all Walbro carbs (included with ball-raced carbs). 1/16" Allen key size.Content:3 pieces

€4.90*

Average rating of 0 out of 5 stars

66271/06 FG ball bearing 17x26x7 sealed, 2 pcs.
Genuine FG spare/option part.

€15.50*

Average rating of 0 out of 5 stars

Servo direct power supply cable, 1 pce.
servo_strom_ohne Application: y0364 - 2 servos, battery connector universal,+ 2EUR
Servo direct power supply cable, 1 pce.With this cable the servos get their current directly from the battery without straining the receiver circuit board.Silicone insulated wires with 0.5 mm² cross section

Variants from €12.90*
€14.90*
Loading...
Upload in progress, please be patient ...
Shopware-Theme Development Shopware-Plugin Development