General 1:5 / 1:6

6229/07 FG Monster Truck tires H, glued, 2 pcs.

Rim with 18 mm square drive. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.1/6 monster truck tires, hard, glued on chromed FG Monstervrim. Outer Ø 210mm, width 120mm, fits FG Marder, Off-Road Buggy, Beetle and Monster cars. Fits other makes of 1/6 cars as well, wheel square size must be checked prior to installation. Installation of tires with a different diameter may require a change in gear ratio as well.Also suitable for:With the following wheel adapter: y1183 Rim adapter

€115.95*

8600/13 FG Shim 8x17x0,5 mm

Genuine FG spare/option part.Spare part for FG 8603.Part is delivered in silver or black color from vendor!Contents:4 piece

€5.70*

TT0990 Top Tuning Failsafe with kill switch and status LED for all transmitters

Genuine TT spare/option part.The new and improved failsafe modul.This kill switch module works with most FM and 2.4 GHz rc-systems. Not compatible with AVC-equipped receivers! You must have a free channel on your rc-system in order to install the module! This means at least a 3-channel radio for standard 1-servo brake/throttle setups or a 4-channel radio for dual brake servos driven by the radio's mixer function. With this module you can stop the engine with your radio. Additionally the module features a failsafe function which stops the engine when the rx-battery's voltage drops below a certain level or the rc-system has a glitch. A kill switch module fulfils two tasks. On the one hand, as a safety device, it is intended to shut off an engine with magneto ignition in case of failure of the remote control, and on the other hand, the engine can be stopped at any time by remote control.While the latter is mainly used for convenience, the safety aspect is what really matters.The failsave circuit integrated in all modern remote controls may brake the vehicle in the event of a radio interference, but this feature is dependent on the basic functionality of the receiver system and its power supply. However, if the receiver, the gas servo or the power supply fails completely, the failsave of the remote control can no longer do its job. The vehicle may be running haywire at full throttle.In these cases, the kill switch will cut the ignition of the engine and the vehicle will roll out without power.Features:Ready to install no soldering requiredRemote LED for easy-to-spot operational status (ignition live/killed)Optically coupled to isolate the ignition from the radio systemThreshold value for undervoltage protection (4V, 5V, 6V) adjustable with jumpers allows adaptation to the rx-battery type (LiPo, LiFePo, NiMH, NiCd)Contents:1 piece

€34.90* €42.90* (18.65% saved)

6534/02 FG Throttle pivot post

Item N° 6534/02 Throttle pivot post 3.1mm - setRevised set for 2 mm linkages, but with 3.1 mm pivot bore to prevent linkage seizing. Can be used for throttle or brake applications.Set collars have 2.1 mm inner diameter.

€7.90*

TT1040 Top Tuning 24 mm hex wheel drives for Losi Super Baja Rey / 2.0 and Super Rock Rey / plastic spindles

Genuine Top Tuning spare/option part.TopTuning 24mm hex wheel drives are required if you want to run wheel combos with the standard 24mm hex drive (such as Losi 5ive-T/B; DBXL; HPI-Baja etc.!) on your Losi Super Baja-Rey and Super Rock Rey.The stock Super Baja-Rey / Super Rock Rey20 mm hex drives (# LOS252077) will be swapped for the TopTuning 24 mm version. No additional parts are required for installation of the 24 mm hex wheel drivers. The Losi Super Baja-Rey's fake brake discs and calipers must be removed prior to assembly.Attention: For the attachment of the wheels you also need wheel nuts with M18x1.5 thread (i.e. AT-5T004), which are also offered in our shop's option menu!Please note: The adapters only fit in combination with the standard plastic steering knuckles or wheel bearing carriers. The aluminium versions have a slightly larger bearing distance, which then prevents the drive pin from being fitted.As already mentioned in the Losi instruction manual, the gearing should be adjusted depending on terrain and tire tread.Depending on tire size the rear of the fenderwells will need some cutting.This applies in particular to aggressive tread large diameter off-road tires and demanding terrain. In this case we recommend the profile regraded, nitrided 15T pinion # TT1021/07 from the TopTuning.Weight per piece 28 grams (original LOS25077 weighs 23 grams).Contents:2 pieces of 24 mm hex wheel drives, machined from 7075 aluminum2 pieces of hardened drive pins 3x23,8 mm

€24.90*

2012-185 Mecatech Ball for servo saver steering

Genuine Mecatech spare/option part for the FW01.Content:1 piece

€7.50*

This product is currently not available.

2012-148 Mecatech Rear Body Mounting

Genuine Mecatech spare/option part for the FW01.Content:1 piece

€9.20*

2012-65 Mecatech Steering and rear antiroll bar plastic joint

Genuine Mecatech spare/option part for the FW01.Content:2 pieces

€5.50*

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

2012-14 Mecatech Front body Mounting

Genuine Mecatech spare/option part for the FW01.Content:1 piece

€9.90*

7337 FG Carburetor gasket for CY / Zenoah / Fuelie

Genuine FG spare/option part.For Zenoah G230/G240/G260/G270/G290/G320Applications:Click here!Actual product may be of different color. We have no bearing on this since we are not the manufacturer.Please note:It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. We also recommend:y0804 HT-flange sealer 518 y0994 Marston sealery0807 MD-Sil RTV silicone sealerContents:1 piece

€5.90*

y1218 Springs for drive shafts

Genuine HT spare/option part. The best solution for drive shaft positioning, can be used with ball drives or regular "dog bones" as well.The springs will be simply inserted into the drive cups.DImensions:Diameter: 11 mmHeight: 8 mmContents:4 piece

€4.90*

7335 FG Insulator gasket for Zenoah / CY / Fuelie

Genuine FG spare/option part.For Zenoah G230/G240/G260/G270/G290Applications:Click here!Actual product may be of different color. We have no bearing on this since we are not the manufacturer.Please note:It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. We also recommend:y0804 HT-flange sealer 518 y0994 Marston sealery0807 MD-Sil RTV silicone sealerContents:1 piece

€4.30*

6350/01 FG Rubber gaskets.

Genuine FG spare/option part.Suitable for FG 6350.Contents:2 pieces

€4.70*

7154 FG Body mount adjustable, 1 pce.

Adjustable body mount with heigt-adjustable body support.Measures:Length 110 mmDiameter 8 mm10 mm at the baseFor all cars and body shells.

€9.95*

7427 FG Plastic gearwheel 40 teeth

Genuine FG spare/option part.Suitable for all 1:5 models.Dimensions:Diameter 63 mmWidth 15.5 mmTooth width 12 mmModule: m=1,5Contents:1 piece

€17.90*

HT Car Bag for all models

car_bag_alle_fga Version: y0550 HT Car Bag for 1/5 scale cars

y0550 HT Car Bag for 1/5 scale cars (Fits FG, HPI, Mecatech FW01, Smartech/Carson a.s.o.)Fits for all 1/5 models for example: FG-: HPI-; Mecatech FW01-; Carson-; Smartech-; Conrads-; Harm-; RS5-; Lauterbacher a.s.oMade from extremely durable fabric, easily washable; with wrap-around shoulder belts and zipper closure.No dirt in the car boot!Dimensions:Length: 95 cmWidth: 50 cmHeight: 30 cmy0551 HT Car Bag for 1/6 scale cars (Fits FG, Smartech/Carson a.s.o.)Fits for all 1/6 models for example: FG Offroad-; Monster/Stadium-; Racetruck-; Carson-; Smartech-; Reely Carbon Fighter; Losi Super Rock Rey, Super Baja Rey, Axial Jeep and any more models. Made from extremely durable fabric, easily washable; with wrap-around shoulder belts and zipper closure. No dirt in the car boot! Dimensions: Length: 70 cm Width: 50 cm Height: 40 cm y0558 HT Car Bag XXL for LOSI 5ive-T, Mini 5ive WRC and Desert Buggy XL and many moreThe XXL version is especially made for the Losi 5ive-T, Mini 5ive WRC, Desert Buggy XL; Arrma Outcast/Kraton; Axial Honcho, Traxxas X-Max/XRT; UFRC GR1/Big Bully. Of course, other 1/5 and 1/6 large scale cars will fit into this bag as well; however, in this case the XXL bag gives you plenty of room for additional accessories. Made from extremely durable fabric, easily washable; with wrap-around shoulder belts and zipper closure. No dirt in the car boot! Dimensions: Length: 100 cm Width: 57 cm Height: 39 cm

€39.90*

y0735 Safety clip for Universal / JR / Futaba connectors

Genuine HT spare/option part. Protects the mated connection to prevent them from coming apart accidentally. Particularly recommended for direct power supply cords, as a tensile load on the cable can remove the link unnoticed and then you would perhaps think of a servo failure in the first place.The small size usually allows the installation even inside the receiver box.Also suitable for securing the connection of the receiver battery; the use of this clip means a big improvement in safety with little effort.Contents:1 piece

€1.50*

2012-94 Mecatech Clutch Flange Spacer

Genuine Mecatech spare/option part for the FW01.Content:1 piece

€7.50*

y0550 HT Car Bag for 1/5 scale cars (Fits FG, HPI, Mecatech FW01, Smartech/Carson a.s.o.)

Hobbythek car bag for 1/5 carsFits for all 1/5 models for example: FG-: HPI-; Mecatech FW01-; Carson-; Smartech-; Conrads-; Harm-; RS5-; Lauterbacher a.s.oMade from extremely durable fabric, easily washable; with wrap-around shoulder belts and zipper closure.No dirt in the car boot!Dimensions:Length: 95 cmWidth: 40 cmHeight: 30 cm

€39.90*

10455 FG Polyamide front spoiler for F1

Genuine FG spare/option part.Solid front spoiler produced in impact resistant polyamide for the FG Formula 1 models. The complete front spoiler and side parts are manufactured in one piece. The ground colour is black and can be painted over restrictively. This front spoiler is specially suited for the use at competitions. Standard equipment of F1 Competition.Contents:1 piece

€34.90*

This product is currently not available.

7373 FG Pump for CY / Zenoah

Genuine FG spare/option part.Contents:1 piece

€9.90*

7332 FG Silencer gasket for CY / Zenoah / Fuelie / PT

Genuine FG spare/option part.For all Zenoah / CY / Fuelie / PT engines.Applications:Click here!Actual product may be of different color. We have no bearing on this since we are not the manufacturer.Please note:It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. We also recommend:y0804 HT-flange sealer 518 y0994 Marston sealery0807 MD-Sil RTV silicone sealerContents:2 pieces

€4.90*

Hitec Servo HS-1100WP Waterproof IP67

Genuine Hitec spare/option part.Waterproof Power IP67 for large models and many industrial applicationsServo HS-1100WP is the most powerful and 100% waterproof servo Hitec large assortment! Thus, it is ideally suited for industrial applications and also for XXL large-scale models. Equipped with a hand-brush motor for maximum reliability and durability, and which protects from the full milled aluminum housing perfectly against electromagnetic interference. Another special course (not programmable) to call the virtually indestructible steel gears and a digital servo electronics IP67 classification.The Servo HITEC HS-1005SGT delivers maximum and constant performance and with its data also a favorite for industrial applications such as UAV, robotics and special effects. Technical data:Width: 33 mm Height: 73 mm Length: 64 mm Weight: 0340 kg Power Type: Mega Features: operating voltageFrom 11.1 to 14.8 volts, Amendment leads possible (Optional) Engine type servos: brushed Transmission: steel Operating voltage in V: 11.1 to 14.8 volts Actuating time s / 60 ° at 11.1 volts: 0:26 Setting time s / 60 ° at 14.8 volts: 12:19 Torque in kg cm at 6.0 volts: 84 Torque in kg cm at 7.4 volts: 110 Teeth: Mega Ball bearings: Yes, 2 times MR148 Waterproof: Yes Flight recommendation: YES Recommendation Heli: YES Recommendation Car: YES Recommendation boat: YES Temperature range: -20 ° to 60 ° CFeatures:Highest force Enormous holding power Indirect long-life potentiometer, 1 million cycles Steel gears Bearings, 2-MR148 Aluminum housing Separate signal and power supplyContents:1 piece

€639.90*

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

2012-106 Mecatech Aluminium Washer for Engine Fastening

Genuine Mecatech spare/option part for the FW01.Content:4 pieces

€8.30*