6204210 ROADIES Formula 1 rain tires Magic Compound, front, glued

Formular 1 tire chart from the current series divided into 3 categories 1) Parking lot / hobbyThe durability of the tire is the main focus here.2) Race track / hobbyHere you will find the tire that offers a compromise of durability and performance.3) Race track / competitionHere the racer will find the tires for best lap times on a race track and to win races.Note:The harder a tire compound - the longer it lasts, but the more moderate the performance.The softer a tire compound - the better the performance, but the lower the durability. Hint!As a rule, the same tires can be used for front and rear.If the vehicle tends to oversteer, this can be avoided by using a harder front tire!In wet conditions you should use a rain tire which offers maximum grip under these circumstances.With the use of Magic Rain, a tire traction compound, the grip can be further improved.Check your tires after driving! It can happen that a tire starts to detach from the rim, in this case you should glue this spot immediately with our tire repair kit (y0067), otherwise the tire could detach completely from the rim.So find out which tire is the best for you!Item N° GWK55E Ellegi Formula 1 extra soft rain front tires, glued - 2pcs.Typ GWK55E the rain tire for the front axle The most driven Formula 1 tires of the past years were modified for an better tire-to-wheel adhesion. The double tire adhesion on the outside is no longer necessary, only one tire lip has to be glued at this new series. Instead of the optical tire lip a plastic ring has to be glued on. The tires offered as ?glued? are professionally glued from GRP on the wheels and ready to drive. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.Different type of tires:- Type GWK55A, the high grip front tire for warm ambient temperatures and fine to medium grit tarmac.- Type GWK55B, the medium grip front tire for medium to low ambient temperatures and coarse grit maybe soiled tarmac.- Typ GWK55E the rain tire for the front axle.Diameter: 140 mmWidth: 60 mmGlued on black rims.Glued by GRP on original Ellegi rim with 18 mm wheel square fits FG, Harm, RS5, Carson, Smartech, Nutech a.s.o

Spare part for the Leopard 2010 2WD/4WD versionMeasures:Diameter: 160 mmWidth: 64 mmsquae 18mmThe Mini Block tires are developed for slightly loose underground. They are excellent as front tire for the 2WD models in connection with the Mini Pin tires on the rear axle. The tires are glued ready to run on the widened 1:6 wheels.These wheels are suitable for the FG Marder, Beetle, Off-Road Buggy and the monster models. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.

Genuine rc-car-online spare/option part.The optimal parking lot or race tires for your FG Racetruck an Offroad models with 18 mm Square mount.- On race trucks, the rim extension rings for the rear tyres must be glued on the inside. - On off-road models, the rim extension rings for the rear tyres are glued on the outside.Type Width Outer diameterFront 64 mm 153 mmRear 78 mm 153 mmGlued on original FG-Racetruck rims (rear tire with extension to the inside), incl. foam rubber insert,FG rim with 18 mm square drive and reinforcement ring.Attention: From experience we warn against using rims and extensions from another manufacturer.Since the Mammoth tires provide a very good grip, the rim and bonding are extremely stressed. Due to the high torque load in relation to the bonding of tires on large models, an occasional check in this regard and possibly a repair of the bonding (y0067) is inevitable.As a recommendation:The dirtier the track or the colder the temperature, the softer the rear tire should be.Reference for the front tire: With 2WD models this should be one to two stages harder than the used rear tire. On 4WD models, a tire combination with the same shore hardness front and rear is often good to drive.Of course, with Mammoth Supergrip Racetruck tires, the softer the tire, the higher the wear.The Mammoth Supergrip Racetruck tires have a special onroad tread. Whereby these still have an optimal grip after the wear of the tread, and can still be driven for a long time.

Genuine HPI spare/option part. Baja 5SC/Front/Bead Lock System / -4mm OFFSETStyle up the Baja 5SC and 5T with TR-10 Wheels, mimicing the style used in full-size short course racing!These 10-spoke beadlock wheels not only look amazing, they also grip the tyres in place securely and hold it in place in all sorts of tough racing conditions. The tire is held on with bead lock rings to keep the tire securely mounted on the wheel without the need for messy super glue. Made from tough high-impact nylon with metal reinforcements around the hex hubs for extra durability, these wheels are available in your choice of white, black, gunmetal and shiny chrome to help you match your paint scheme and add a custom look to your truckContents:2 pieces

Wheel nut front for F1 Cars using M6 Thread on the axle.The Lightscale wheelnut is used in combination with the Lightscale lexan disc to convert F1 rims to an up to date and modern look.Thereby the Lightscale wheel nut works just like a real one in present f1 racing. It is tightened with a 22 open end spanner or socket wrench. Alternatively one may use the special Lightscale tool to tighten or loosen the wheel nut.Due to the use of rifled and conical washers a locking effect is achieved.The kit contains 2 wheel nuts as well as 4 rifled conical washers.Optional parts: Tool for Lightscale wheel nuts item code 50100000, Lightscale lexan disc item code 51009500 and spare rifled conical washers item code 881200058801. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.