LOS252021 Driveshaft rear center Losi DBXL 1/5 4WD

EUR 59,99

piece - + shipping costs
all prices include VAT

Available from stock

Place your order within the next 25.09.23 14:00:00 and we will ship Monday, 25 . September 2023

Description↑

Genuine Losi spare/option part.

Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019:

Remove set screw completely
Open bench vise until the pin just fits between the jaws
Position shaft on vice, held by a second person if necessary
Drive pin out with light hammer blows using a pin punch or a suitable comparable tool
If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible.
When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!

You may consider one of theses alternatives:↑

We recommend the following accessories/spare parts for this item:↑

Customers, who bought this product, also bought the following item(s):↑

more ...

Questions about this item↑

HT-SubmissionForm

Your name:
Your email address:
Your question:
	May we publish your question? Your email address will never be published! Privacy Policy We will archive the entered data and correspondence confidentially and securely for the purpose of service improvement. It will never be given to third parties! I agree with the privacy policy:

Newsletter