Genuine HT spare/option part. Protects the mated connection to prevent them from coming apart accidentally. Particularly recommended for direct power supply cords, as a tensile load on the cable can remove the link unnoticed and then you would perhaps think of a servo failure in the first place.The small size usually allows the installation even inside the receiver box.Also suitable for securing the connection of the receiver battery; the use of this clip means a big improvement in safety with little effort.Contents:1 piece

Genuine HT spare/option part. Extremely sturdy, fully padded transmitter bag! Fits all popular pistol grip transmitters Top quality; with padded adjustable length retaining straps to secure the transmitter, large zippered flap and adjustable carrying strap. Dimensions: Width: 23 cmHeight: 34 cmDepth: 17 cmContents:1 piece

Genuine Top Tuning spare/option part. Top Tuning The 20-amp Bigscale switch allows for a maximum input voltage of 30 volt. It is specifically designed as a receiver switch for use in combination with the Hitec HS-1005SGT servo and 4s receiver battery. The switch can also be used for other applications at your discretion with batteries up to 6S.Note: Top Tuning the electronic 20 amp Bigscale high voltage switch delivers the batterys full voltage. It does not replace a voltage regulator! The components which follow down the line (voltage regulator / servos / receiver) must be matched to this voltage! Using the latest MOSFET technology allows the 20 amp Bigscale high voltage switch to handle extreme loads, despite its small size. A blue LED status light clearly displays the activated mode. The 20 amp Bigscale high voltage switch is dust-and splash protected. He has an extremely low internal resistance and very low power consumption in off mode. Nevertheless it is recommended to unplug the battery when the model will not be used for an extended period. Properties:Voltage range: 3 to 30 VLoad: 20 ampsStandby consumption: 17 µAOperating temperature: - 15 ° C to +50 ° CCable length:Battery side 250 mmReceiver side 130 mmWeight: 13 gramsDimensions:Length: 29 mm Width: 13 mmHeight: 12 mmContents:1 piece

Genuine TopTuning spare/option part.Top quality lockable aluminum transmitter case in Futaba T7PX design. Case has plastic feet on bottom and back.The case lid features a lock on either side of the handle and a ribbed foam insert on the inside.Comes with 2 keys includedOuter dimensions: length approx. 320 mm Width: approx. 240 mm Height: approx. 160 mm Weight: 1.5 kgContents:1 piece

Genuine TopTuning spare/option part.Top quality lockable aluminum transmitter. Case has plastic feet on bottom and back.The full-surface foam inlay, divided into 15 mm blocks, allows the transmitter case to be individually adapted to each transmitter and its accessories.See example picture with Futaba transmitter!Of course, it is also possible to adapt the pre-cut foam inlay to other high-quality objects.The case lid features a lock on either side of the handle and a ribbed foam insert on the inside.Comes with 2 keys includedOuter dimensions: length approx. 320 mm Width: approx. 240 mm Height: approx. 160 mm Weight: 1.5 kgContents:1 piece

Genuine Spektrum spare/option part. Contents:1 piece

Genuine Spektrum spare/option part. Contents:1 piece

Genuine Spektrum spare/option part. Contents:1 piece

Genuine Spektrum spare/option part. Fits Spektrum DX3R Pro, DX3S and DX2S. Only working with a reciever with telemetry function like the "Spektrum SR3300T reciver".Content1 pieces

The Spektrum™ DX2E ACTIVE™ Speedometer Module is an exclusive add on upgrade that actively displays real time MPH or KPH right in front of the driver. All that is needed is a telemetry capable receiver, such as the TM1500 Telemetry Module, and the easy to install Spektrum RPM Sensor.The Spektrum DX2E ACTIVE Speedometer Module features a simple one touch interface, allowing the driver to easily setup the speedometer and view the top speed at the touch of a button. The DX2E ACTIVE Speedometer Module is pre-configured for the Losi® TENACITY™ SCT, making it an exceptionally simple plug and play upgrade system that adds the immersion of brightly lit, heads up speedometer display to your DX2E ACTIVE Radio. And for other vehicles, setup is as simple as inserting your models motor pole count and tire roll out.1 piece, used

Genuine Spektrum spare/option part. Expand the LED gate/s or replace damaged IR LEDs along your racetrack with this handy string of IR LEDs. Increasing the IR field offers higher sensor accuracy and wider coverage. The SPMLTG5001 connects to the end of the IR LED strip included with the SPMLTG5000 Base Unit.Contents:5 pieces

Genuine Spektrum spare/option part. Only working with a reciever with telemetry function like the "Spektrum SR6000T reciver" or a transmitter with an external telemetry module. Works with all brushless motors for rpm data through SPM telemetry modules and integrated telemetry receivers. Easy installation.Content1 pieces

Genuine Hitec spare/option part. Sensor for detecting temperatures of -40 ° to + 240 ° Celsius. Compatible Sensors AFHSS 2.2 GHz for telemetry HITEC application.Contents:2 pieces

Genuine Spektrum spare/option part. Contents:1 piece

Genuine Futaba spare/option part.Contents:1 piece

Item N° SPM1451 Battery/Motor Temperature Sensor, 1 pce.

Genuine Hitec spare/option part. With the HPP-22 transmitter, RF modules, receiver, and chargers to be updated on the PC and records HiTEC telemetry data shown. Changing the language of the operating system on the transmitter is also done by installing a different firmware.Features:Firmware and software updates for the transmitter, 2.4 GHz RF module, 2.4 GHz receiver and chargers Managing model memories AURORA 9X, AURORA 9, LYNX 4S and OPTIC 6 SportPC interface to view and record telemetry data on the PCMini-USB cable is required but not included!Contents:1 piece

Genuine Futaba spare/option part.Voltage sensor for Futaba S.BUS2. telemetry system.Suitable for use with the Futaba 4PX, 7PX transmitter.Technical data:Range: EXT line Voltage: 0.0V ~ 100.0V / Normal line Voltage: 3.5V ~ 8.4V (It measures to the first decimal place)Length: 870mmWeight: 6.0gVoltage: DC 3.7 ~ 7.4VContents:1 piece

Genuine Spektrum spare/option part. The Spektrum DX2E ACTIVE Speedometer Module is an exclusive add on upgrade that actively displays real time MPH or KPH right in front of the driver. All that is needed is a telemetry capable receiver, such as the TM1500 Telemetry Module, and the easy to install Spektrum RPM Sensor.The Spektrum DX2E ACTIVE Speedometer Module features a simple one touch interface, allowing the driver to easily setup the speedometer and view the top speed at the touch of a button. The DX2E ACTIVE Speedometer Module is pre-configured for the Losi® TENACITY SCT, making it an exceptionally simple plug and play upgrade system that adds the immersion of brightly lit, heads up speedometer display to your DX2E ACTIVE Radio. And for other vehicles, setup is as simple as inserting your models motor pole count and tire roll out.Dimensions:Length: 2.6 in (65 mm)Width: 2.4 in (60 mm)Height: 1.7 in (43 mm)Contents:1 piece

WD-40 SPECIALIST contact spray removes oil, dirt, flux and oxidation residues from sensitive electrical or electronic equipment. The product can be used on electrical equipment, contacts, plastic and rubber.Temperature application range: room temperatureApplication:First disconnect all plugs from equipment to avoid current and allow hot surfaces to cool. Shake the can before use and apply the spray directly on the surface to be treated at a distance of 15 to 20 cm. This will remove any residue that could interfere with electrical contact. Tilt the surface while cleaning and allow excess liquid to dry completely before restoring power. To avoid accidental damage, always check the manufacturer's instructions before applying the product to the equipment. Do not spray product into cavities, openings, crevices or areas of your device where it does not have sufficient airflow to support complete evaporation.Smart Straw - Product Benefits:The integrated spray head allows you to switch between large-area and precise spraying. In this case, the tube remains firmly attached to the spray head and is therefore no longer lost during application. For area spraying, the spray tube is simply folded down. With the spray tube folded out, you can reach small spaces and apply the product there with pinpoint accuracy. The 360° valve allows the can to be held upright or even overhead, making any application possible.WD-40® multifunctional product infiltrates and loosens rusted and stuck screws. It penetrates the threads of hinges and protects against corrosion. WD-40® multifunction product displaces moisture, lubricates and eliminates squeaks. > PRODUCT PERFORMANCE AND FEATURES: Smart Straw® Spray system for area and spot spraying Fast acting and non-conductive Perfect cleaning for electrical/electronic equipment, contacts, plastics or rubber Penetrates quickly without leaving residues Penetrates even the most difficult to reach areas K2 registered #145372 > AREAS OF APPLICATION: Electrical assembly Circuit boards Controls Printers & copiers Switches > USAGE: Shut off unit and allow hot surfaces to cool. Disconnect all plugs from unit to avoid power supply. Shake can before use. Apply spray directly to surface to be treated at a distance of 15 to 20cm to remove all residues that may interfere with electrical contact. Tilt surface during cleaning. Allow excess liquid to dry completely before restoring power. To avoid accidental damage, always check manufacturer's instructions before applying product to equipment. Do not spray into cavities, openings, crevices or areas of your equipment where this product does not have sufficient airflow to support complete evaporation. Tilt the surface during cleaning to allow excess liquid to drain and the product to dry completely before returning it to service and connecting it to the electrical circuit.

Genuine Spektrum spare/option part. Contents:1 piece

Genuine Hitec spare/option part. Sensor for detecting the speed of rotating components, in which the optical rotational speed sensor can not be used.Contents:1 piece

Genuine Spektrum spare/option part. An easy-to-use and accurate lap timing system for flyers and driversNormally costing thousands of dollars, race timing systems tell the cold truth about your setup and your skills. The Spektrum Lap Timer System is a personal lap timing device that is easy to set up, easy to use and costs less than $80 to get started. Unlike other timing systems on the market, infrared technology offers highly accurate results and uses the Spektrum telemetry capability you already have in your transmitter to deliver information instantly and conveniently. Spektrum Gen II/III transmitter users can have the integrated voice alert system call out lap times automatically so you can keep your eyes on the aircraft or vehicle. The lightweight system is versatile enough to handle any number of racers at a time and can be expanded to optimize gate range and encompass a total of ten check points.Spektrum Lap Timer System BenefitsIdeal for practice air and surface racingnot just FPVEasy to power: Uses power from the RC systemno separate battery to chargeEasy to setup: configure everything through your Spektrum transmitterno calibrationsReliable: No Phone/Bluetooth problems inherent in VTX systemsConvenient: no waiting for resultslap times are sent and saved directly to your transmitterExpandable: no pilot count limits and can include up to 10 gatesEasy SetupWhether you drive or fly, the Spektrum Lap Timer System is a low cost setup that lets you enjoy the same thrilling action very similar to what dedicated racers experience at regulation events. Ideal for personal use, use it in your own backyard to significantly hone your skills or just enjoy the thrill. You can also team up with friends or get the club together. The cold hard lap time telemetry the Spektrum Lap Timer System is extremely simple, yet tells you invaluable information that's crystal clear. Without the Spektrum Lap Timer system, knowing if your flight control tweaks, prop/motor changes or new battery make any difference is just a guessing game.The Spektrum Lap Timing System consists of two simple components; the Lap Timing Base unit (SPMLTG5000) and the Lap Timing Receiver (SPMLTT2500) that work together with your Spektrum telemetry DSMX® or DSMR® receiver and telemetry capable transmitter like the DX9 or DX5R.Lap Timer Base UnitThe Spektrum Lap Timer System is an extremely simple to use personal lap timing device that sends lap time information directly on your compatible Spektrum radio. Spektrum Gen II/III transmitter users have the added benefit of using the integrated voice alert system to call out lap times automatically so you never have to take your eyes away from the aircraft or vehicle. The Base Unit is a gate controller that weighs a mere 14.5 grams, is compact in size and easy to setup so that you can create a custom track in a backyard, local track, flying field, etc. Simply assign a gate as a Start and Finish or expand the system to include up to 9 more Base Units. This allows you to know what lap times are possible and what your speed is through a particular section or curve of the track. To take advantage of this valuable race practice tool, a Spektrum Lap Timer Receiver (SPMLTT2500) or IR Sensor (SPMLTT1000, for use with the SPMFCF400) as well as at least one Base Unit with IR LED Strip and a 3S LiPo (1012.6V) is needed.Contents:1 piece

Genuine Spektrum spare/option part. Contents:1 piece