Skip to main content
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

LOSR5031 Losi Exhaust Gasket, for Losi 23/26/29 cm³

Product information "LOSR5031 Losi Exhaust Gasket, for Losi 23/26/29 cm³"

Genuine Losi spare/option part.

Replacement part for Losi 23/26/29 cm³ engine with item number: LOSR5001.

Contents:
  • 2 pieces

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Alternatives

Average rating of 0 out of 5 stars

ST-EWP21D SPEED TEC 0,30 mm EWP207 Silencer gasket for CY / Zenoah gasket
Genuine Speed-Tec spare/option part. For all Zenoah / CY / Fuelie / PT engines with 2 and 4 Bolt.EWP207 is a gasket material based on NBR-bonded synthetic and organic fibres. It therefore has very good oil and fuel resistance and does not swell like other gaskets.EWP207 is ideally suited for sealing against cold and hot oils, greases and fuels. Features Oil resistant Heat repellent Does not swell Contents:1 piece

€4.50*

Average rating of 0 out of 5 stars

ST-AN21D SPEED TEC 0,25 mm EWP207 Silencer gasket for CY / Zenoah AN - expansion sealing gasket
Genuine Speed-Tec spare/option part. For all Zenoah G230/240/260/270/290/320 / CY / Fuelie / PT / Losi / CarsonAN - expansion sealing gaskets are in use in the 2-stroke motor sports for years and are based on NBR-linked cellulose fibers. They are especially used for sealing hot oils, greases and fuels! The sealing material is compressed during assembly, and as soon as it comes into contact with fuel, it swells again. Thus it is i.e. possible to make up for irregularities in the sealed surfaces (i.e. cylinder / crankcase) and seal them properly! The material of the SPEED TEC AN - expansion sealing gaskets guarantees a very good dimensional accuracy and is often the solution for leaks on your engine! Technical data of the material in contact with fuel:- Rebound ASTM G > 30%; increase in thickness < 5%; weight gain < 55%;- Compressibility ASTM F36 G 22.5% +/- 2.5 27.5% +/- 7.5Contents:1 piece

€3.50*

Customers also bought

Average rating of 0 out of 5 stars

305209, s054064 Fuel lines Carson / Smartech 4x4, set
Item N° 305209, s054064 Fuel lines Carson / Smartech 4x4, set

€17.90*

Average rating of 0 out of 5 stars

AR-023 Fuel line hose clamps
For a secure fit of the fuel line. The self-adjusting clamps are suitable for diameters from 6 to 7 mm.Contents:10 pieces

€8.90*

Average rating of 0 out of 5 stars

TT1530/260 Top Tuning 6000 mAh LiPo receiver battery 2S, 7,4V 5C
Typical featuresLow inner resistance with high MPVHigher energy density with lower weightLonger lifecycle under proper usage, up to 200 timesFor LiPo batteries, the peak amp rate is usually twice the continuous crateRecommended charge with 1CSpezification:Tension: 2S / 7,4VCapacity mAh: 6000Case: SoftCable cross section: 12AWG/3,3Length +/- 5 mm: 142 mmWidth +/- 1,5 mm: 44 mmHeight: +/- 1,5 mm: 18 mmWeight +/- 10g: 243 mmCont. current: 5C (30A)Connectors: Universal and EC3, XH-balancer. Battery color may vary!Contents:1 piece

€59.90*
%

Average rating of 0 out of 5 stars

y1409/100B GIANT GRIP tires belted with MadMax Extreme rims/inlays for Losi and HPI Offer
Special version with vulcanized fabric reinforcement belt for extreme torque loads. GIANT GRIP belted 190 x 70 with black colored MadMax Extreme rims, 20-fold screwed, very tough, with 24 mm hex drive and reinforced beadlock rings for Losi 5ive-T and Desert-Buggy XL as well as all HPI Baja 5 B/T cars.The GIANT GRIP provides giant traction through 96 about one cm² wide and 5 mm high strong lugs, getting ample grip even on loose surfaces like sand and soil.Due to the extreme strain caused by the GIANT GRIP tires the MadMax rim with reinforcement ring had to be optimized once more.The GIANT GRIP tires come with strong special tire inserts which allow to transfer the power without canting, even on heavy cars like the Losi 5ive-T.Dimensions:Outer diameter: 190 mmTire width at bead 70 mmTread width 80 mmReinforced 24 mm hex wheel driveThe MadMax Giant Grip tires use 60 mm wide rims ( y1415/01 or y0761/01).The video shows the 18 mm square drive version. Also available with 24 mm hex. Some off-road tires knowledge can be found here!

€99.90* €119.90* (16.68% saved)

Average rating of 0 out of 5 stars

4832 Samba BIG BELLY Titan tuned pipe for Losi 5ive-T/2.0 up to 32 cm³
Genuine Samba spare/option part.The Samba 5ive T tuned pipe from the 1/5 world champion!At the 1/5 World Championship were place 1 to 10 (!) equipped with a samba tuned pipe system.A proof of competence without equal!BiG BELLY, special version for the 5ive-T / Monster Truck XL with engines up to 32 cm³ engine. Comes with complete hardware for installation.Top quality and optimized performance across the entire rpm range of your engine.The pictures of the installed pipe, they show you the steel version with the order no.: A proof of competence without equal!BiG BELLY, special version for the 5ive-T / Monster Truck XL with engines up to 32 cm³ engine. Comes with complete hardware for installation.Top quality and optimized performance across the entire rpm range of your engine.The pictures of the installed pipe, they show you the steel version with the order no.: 4822, are for presentation purpose only.Contents:1 set

€419.90*

Average rating of 0 out of 5 stars

LOS45023 Losi Tire Set, Firm, 5ive-T 2.0
Genuine Losi spare/option part. Contents:2 pieces

€59.99*

Similar products

Average rating of 0 out of 5 stars

6061 Mielke pull starter with hybrid starter function
Genuine Mielke spare / option part.Starting by pull starter or by cordless screwdriver or electric starter is possible.Pull starter with hybrid starter function. Who does not know it? A torn starter rope, blisters on your finger from constant pulling or a defective starter pawl. All these problems are a thing of the past with the hybrid starter.With the help of a cordless screwdriver the engine can be started very easily and if the battery of the cordless screwdriver is empty, the engine can be started by using the conventional way with the pull-rope starter.Please note:The starter shaft for electric start is inserted in a straight line in extension of the crankshaft. No part of the vehicle must be in the way here. On a model with a longitudinally mounted engine (e.g. Losi 5ive or DBXL vehicles) the rear axle will usually prevent the use of the electric start. The normal pull start by cable remains possible.Contents:1 piece

€114.90*

Average rating of 0 out of 5 stars

7323/08 FG Complete pull start unit for CY / Zenoah / Fuelie / Losi engines
fg_7323_08 Zenoah Label: Without label
Genuine FG spare/option part. Complete starter unitPull start unit for CY / Zenoah G230/240/260/270/290/320.Contents:1 piece

€39.90*

Average rating of 0 out of 5 stars

6062 Mielke clutch nut for E-start shaft
Genuine Mielke spare / option part.Spare part for Mielke 6061.Contents:1 piece

€24.90*

Average rating of 0 out of 5 stars

7340/09 FG Rubber cap for kill switch
Genuine FG spare/option part.Protects the switch against dirt and splashes. Highly recommended for off-road use.Contents:1 piece

€3.90*

Average rating of 0 out of 5 stars

LOSR5033/01 Losi CarbMntingGasket, for Losi 23/26/29 cm³
Genuine Losi spare/option part. Replacement part for Losi 23/26/29 cm³ engine with item number: LOSR5001.Contents:1 piece

€3.90*

Average rating of 0 out of 5 stars

6061/01 Mielke Zenoah Hybrid starter, pullstart unit only
Genuine Mielke spare / option part.Spare part for Mielke 6061.Contents:1 piece

€69.90*

Average rating of 0 out of 5 stars

7354/08 FG Spacer plate for CY / Zenoah / Fuelie
Genuine FG spare/option part.Installs between carb and air filter/airbox to assure choke flap clearance.Contents:1 piece

€10.70*

Average rating of 0 out of 5 stars

LOSB5039 Losi Clutch Shoes & Spring, 8,000 RPM. 5T, Mini, DBXL+MTXL
Genuine Losi spare/option part.Fits Losi 5ive-T and 5ive Mini.Contents:1 pieces

€69.99*

Average rating of 0 out of 5 stars

Carburetor Walbro WT 813
y0251 Performance carburetor with accelerator pump type: WT-813Walbro WT-813A carb with accelerator pump, improves low end response when the engine is tuned for maximum performance. 15.88mm bore, 12.7mm venturi. Ready for installation with modified shaft already installed. Fits Zenoah G230/240/260/270 engines and their CY/HPI Fuelie clones as well. Fits all Zenoah G230/240/260/270 and 290 engines as well as the respective Chung-Yang (CY) versions, also Losi and HPI Fuelie, Smartech, Carson PT engines, and many others.

€79.90*

Average rating of 0 out of 5 stars

LOSR5033 Losi Insulator Gasket, for Losi 23/26/29 cm³
Genuine Losi spare/option part. Replacement part for Losi 23/26/29 cm³ engine with item number: LOSR5001.Contents:1 piece

€9.99*

Average rating of 0 out of 5 stars

LOSR5026 Losi Muffler screws for 26 cm³
Genuine Losi spare/option part. Replacement part for Losi 23/26/29 cm³ engine with item number: LOSR5001.Measures:Length: 65 mmDiameter: M5Part is delivered in silver or black color from vendor!Contents:2 pieces

€7.99*

Average rating of 0 out of 5 stars

LOSR5025 Losi Hardware Set, for Losi 23/26/29 cm³
Genuine Losi spare/option part.Fits Losi 5ive-T and 5ive Mini.Replacement part for Losi 23/26/29 cm³ engine with item number: LOSR5001.Part is delivered in silver or black color from vendor!Contents:1 set

€33.99*

Customers also viewed

Average rating of 0 out of 5 stars

TT1003 Top Tuning rear 7075 aluminum chassis brace for TLR/Losi 5ive-B
Genuine TopTuning spare/option part.Rear chassis brace by TopTuning, made of high-strength 7075 aluminum; fits the new racing Buggy TLR/Losi 5ive-B only.The shape of the TLR 5ive-B rear brace with its much steeper angle compared to the 5ive-T and Mini makes the use of aluminum for this application particularly interesting. The standard plastic part cannot provide the desired dimensional stability in the long run. The material strength and temperature resistance of aluminum offer a significant advantage.Inclusive two mounting screw M5 x 14 mm.Contents:1 piece

€24.90*
Loading...
Upload in progress, please be patient ...
Shopware-Agency Shopware-Theme Development