86690 HPI Aluminium exhaust pipe

€194.60*

Prices incl. VAT plus shipping costs

No longer available

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Product number: hpi.h86690

Product information "86690 HPI Aluminium exhaust pipe"

Genuine HPI spare/option part.

Need your Baja to have a bit more 'oomph'? A little more speed? A bit more acceleration? Maybe some more top end? How about a LOT of speed, acceleration and top end? If you've been craving tons more speed out of your Baja 5B, you'll definitely want to check out our new Aluminium Tuned Pipe Set!

Developed specifically for the Baja, this is a truly impressive exhaust system. Featuring ear-splitting performance, you will actually feel the acceleration you gain from bolting this on! You will see the top speed you get as your Baja roars past you! Please note: this pipe set is NOT for driving near residential or city areas. It is very loud!

Contents:

1 set

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

No reviews found. Share your insights with others.

Accessories / Spare parts

y0564 RC Tech Pipe Protect 400 ml

Genuine HT spare/option part. RC Tech Pipe Protect protects your exhaust against oil and rubber deposit while racing. A clean exhaust gives better resonance, which means better performance from your engine. Thanks to RC Tech Pipe Protect your exhaust system can evacuate the temperature better.Direction of useSpray a relatively thick layer of Pipe Protect from a close distance; +/- 15/20 cm on your new or just-cleaned and preferably polished exhaust pipe. After each ride clean the exhaust pipe with a clean cloth, if necessary slightly sprayed with some Pipe Protect. Treat the exhaust pipe again before each race.Contents:1 piece / 400 ml

Content: 400 Milliliter (€24.75* / 1000 Milliliter)

€9.90*

y804 HT-flange sealer 518, 50 ml up to 200°C

Especially for installation of all engine gaskets. Temperature resistant from -55 °C to +200 °C. Resistant to water, mineral oils, synthetic lubricants, fuels, organic solvents and refrigerants. info: Hand tight: 10 - 20 minReady to use: 1 - 3 hoursGap fill: 0.5 mmContent: 50 ml Notes for usage: This surface seal is not for use as the sole sealant, it should always be applied in combination with a paper gasket.The HT-surface sealing agent should be sparsely applied over the entire surface, with care being taken that the sealant does not enter the devices internals (e.g. crankcase, differential a.s.o.) during the assembly.

Content: 50 Milliliter (€498.00* / 1000 Milliliter)

€24.90*

Kunden haben auch gesehen

86632 HPI Set screw M5 x 3 x 22 mm

Genuine HPI spare/option part. Contents:10 pieces

€7.99*

Challenge Line 2WD 530E Electric BMW M4 incl. ESC + Motor RTR

Genuine FG spare/option part. The FG Touring and Sports cars at scale 1:5 are known for their high quality and very detailed bodyshells true to original. Also the technically fully developed chassis are worth mentioning. These models are now available with a high-torque brushless engine. Surface conditions with maximum grip assumed speeds above 100 km/h can be reached and steered controlled. E stands for electric power which is equivalent to extremely high torque, high speed and all this without any engine noise. The Challenge Line models are equipped with a powerful 1100 kV brushless Motor and a 150A brushless ESC. This control can be regulated simply via transmitter or optionally via the program card. Incl. RTR equipment RTR = Ready to Run. The RTR version comes ready to use with the 2,4 GHz rc-system already installed. Transmitter: Reflex Wheel Pro III 2,4 GHzReceiver: Empfänger: Mini BECy1570 CYS S0650 Largescale servo, 55 kg/0,11 secTx-batterys 4 pieces y0660/04 The models are built on a 4mm aluminium chassis with rear wheel drive and double wishbones front and rear. All borings are countersunk. Fully adjustable front and rear double wishbone suspensions.Further equipment points are: differential gear, oil-pressure shock absorbers with volume control and external, adjusting ring for the initial tension of the spring. All rotating parts on ball bearings.Tires are glued on the rims.For all versions of the electric cars, the LiPo batteries and the matching charger, as well as the radio system and the steering servo (RTR) are required. In our shop selection, the RTR set is available for a surcharge.For hassle-free assembly, FG recommends using LiPo batteries 2x 2S or 2x 3S, with a maximum dimensions of 150 mm in length and 50 mm in width. The model comes with the EC8 connector system equipped.

Variants from €949.00*

€1,088.90*

Configure now

R198 UFRC Ball B for anti-roll bar

Genuine UFRC spare/option part. Fits Ghost Rabbit GR1.Contents:2 pieces

€11.90*

DYNB0500 7.4V 5200mAh 2S 15C LiPo Receiver Pack

DYNB500 Dynamite Reaktion Lipo Receiver Pack 5200mAh 2S 7,4V 15C with EC3 and Universal electric wire.Genuine Losi spare/option part.Specifications:Cells: 2SCapacity: 5200 mAhVoltage: 7.4 VLength: 92 mmWidth: 44 mmHeight: 25 mmWeight: approx. 210 gramsBalance connection: XPH (XH) Warning:- Use only under direct supervision of adults- Charge only in a suitable charging bag / protective bag- Do not store battery discharged (at least 50% charge is recommended)

€64.99*

This product is no longer available.

6912/13 FG Countersunk sheet metal screw with Torx 4,2x13 mm, 20 pieces

Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Content:20 pieces

€3.90*

Alloy servoarms, for 25 teeth multi-tooth shaft

y0700 Double sided alloy servoarm: 9,90 EURy0700/01 Single-sided alloy servoarm: 7,90 EURy0701 Double sided split alloy servoarm: 14,90 EURy0701/01 Single-sided split alloy servoarm: 12,90 EURFor y0700, y0700/01, y0701 and y0701/01:Splitted Alloy servoarm for a more protecting screw connection (with a 2,0 mm allen head screw driver) causing stiffness on the servo output shaft Suitable for all servos with an output shaft with 25 teeth multi-tooth shaft, for example:y2006 Digital Big-Scale Servo D-21HVy2007 Digital large scale Brushless Servo CYS9130Nearly all Ribbe/Futaba servosMega Power servoThunder Tiger DS1015And many more!holes for linkage with M3 threadWhen you count the teeth of your servo you can check if this alloy arm will fit to your servo. Alloy servoarm are indispensable by strong digital servos, as used on big scale models for example, to optimize the servo forces being transferred.

Variants from €9.90*

€14.90*