6102 FG Front wishbone pin

Genuine FG spare/option part. Dimensions:Diameter: 6mmLength: 65mmand hardened steel: Contents:2 pieces

Genuine HT spare/option part.Wheel squares made of high-strength aluminum, hardened, with two M6 mounting threads Suitable for most 1/6 and 1/5 rc-cars. Through the use of two 6 mm screws a significantly higher retention force is achieved. Yet it is still recommended to use medium strength thread lock (link y0114)! The hard anodizing (HART-COAT) guarantees much lower wear of the squares! Especially recommended when using wheel mounted brake discs! Four 3x16 dowel pins per square are included which prevent the squares from spinning in the rim. Press fitting them into the wheel squares is optional. The 12, 14 and 17 mm wide squares feature a groove for inserting a C-clip (link 6106/05), which acts as a guide for the brake disk. The narrow 9.5 mm wide squares dont need a clip; the close sitting rim will guide the disk. Measures18 mm square (wheel drive!)17 mm wide, 8.0 mm diameter axle boretwo M6 mounting threads The set includes 2 pieces of 17 mm wide wheel squares and 4 pieces each of M6 grub screws and 3x16 dowel pins.Contents:2 pieces

Genuine FG spare/option part. The Maxi-Grip tire develops more road grip and has a better balanced driving performance on a very uneven ground according to its bigger tire diameter and the improved rubber mixture. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.Diameter x width: 165 x 65 mmRim with 18 mm square driveContent:2 pieces

Genuine FG manual as included with the car.

Genuine FG spare/option part. Suitable for all 1:6 models except Race-Trucks as well as LeopardContents:1 piece

Genuine FG spare/option part. Suitable for all 1:6 models except Race-Trucks as well as LeopardContents:1 piece