Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

13 products found for "y0473"

Filter products

rc-car-online - Home

Average rating of 0 out of 5 stars

y0473 Needle roller bearings with centring washers for 29 / 30.5 cm³ Big Bore Kit, 1 set
Spare part for the 29 / 30.5 cc big bore kit y0466

€9.90*

Average rating of 0 out of 5 stars

y0443 EC3 charging cord
Heavy gauge (14 AWG / 2 mm²) charging cord with EC3 plug and gold plated contacts. Especially for Losi/Horizon rx-batteries which feature an EC3 connector additionally to the regular rx-connector. The EC3 system can candle much higher charging rates which reduces charging time of high capacity battery packs significantly.Dimensions:Length approx. 20 cm

€8.90*

Average rating of 0 out of 5 stars

y0463 Seal bearing set for the FG 4WD competition models
Genuine HT spare/option part. Complete seal bearing rate with 24 bearings for the FG Competition 4WD models. Quantity / Size / use:4 pieces 6 x 15 x 5 mm - Front Pulley2 pieces 10 x 22 x 6 mm - Clutch Bell6 pieces 10 x 19 x 7 mm - layshaft / belt tensioner4 pieces 15 x 28 x 7 mm - Differentialv6 pieces 8 x 22 x 7 mm - wheel bearings2 pieces 17 x 26 x 7 mm - the inside front wheel bearingsTotal value of stock: 116,25 EUR

€79.90*

Average rating of 0 out of 5 stars

y0673 Carbon fastening strip for FG no. 8418 - 2 pcs.
Use instead of plastic fastening strip FG # 8418/07 (for FG front bumper # 8418).Dimensions:Width: 95,7 mmHeight: 16,8 mmDistance between holes: 75 mmBore diameter: 8 mmThickness: 2 mm

€19.80*

Average rating of 0 out of 5 stars

y0743 Clutch-Safe 10 g, adhesive especially for clutch pads
Special single component epoxy adhesive for bonding clutch shoes; suitable for extreme operating temperatures (up to 200°C!) Important note for processing: For the final cure of the bond Clutch-Safe must be tempered at 170°C for 1 hour! (1 hour at 170°C in the oven!) The extremely high temperature load on the clutch shoes when used in off-road cars caused by increased clutch slippage, the shock of jumps and the combination with sometimes very high vehicle weights (up to 18 kg!) make bonding with Clutch-Safe highly recommended. For later removal/replacement of worn out clutch pads the clutch shoes must be heated as well.Attention:Clutch-Safe adhesive must be stored in the fridge! Content: 10g tube

Content: 10 Gramm (€495.00* / 1000 Gramm)

€4.95*

Average rating of 0 out of 5 stars

y0273 Opel Vectra team decals Valvoline - set
Valvoline team decals for Opel Vectra body shell.Sheet dimensions:500 x 230 mm (3x)230 x 80 mm

€29.00*

Average rating of 0 out of 5 stars

y1473 Extra strong duct tape, 50 mm x 50 meters
Genuine HT spare/option part.50 mm wide, extra strong duct tape, i.e. for repair of cracks in body shells or for preventative taping of RC car body shells.Content:1 piece / 50 meters

€6.90*

Average rating of 0 out of 5 stars

y0453 HT Cask shaped springs for Mecatech Klick-Shocks and Big Bore, green 2,5 mm
These cask shaped springs are especially designed to fit the diameters of Mecatech Klick-Shocks and Mecatech Big Bore shocks.Dimensions:Inner diameter, upper: 20,5 mmInner diameter, lower: 16,5 mmOutside diameter: 29,5 mmLength: 52,5 mmWire diameter: 2,5 mm

€17.90*

Average rating of 0 out of 5 stars

y0472 Piston pin for 29 / 30,5 cm³ big bore kit, 1 pce
Spare part for the 29 / 30.5 cm³ big bore kit y0466

€7.90*

Average rating of 0 out of 5 stars

y0470, 29 / 30,5 cm³ big bore piston, 1 pce.
Spare part for the 30.5 cm³ big bore kit y0466 and for big bore kit 29 cm³ y0484

€24.90*

Average rating of 0 out of 5 stars

Low voltage failsafe module, y0423 - 1pce.
To protect a car from a crash in case the power supply fails is no easy task. The mechanical devices that are used to do the job are either bulky or cause a higher drain from the battery. The failsafe module is a more efficient way.The module controls the battery pack's voltage and takes control of the throttle servo when the voltage goes below 4.7 volts. As an additional feature you can supply a backup battery pack to power the throttle servo in case the main pack falls completely. The failsafe position of the throttle servo is adjustable.

€49.30*

Average rating of 0 out of 5 stars

10473 FG Alloy front axle carrier for F1 - 1pce.
CNC-manufactured alloy front axle carrier for F1 models. Optimal fitting and extremely non-twisting at highest charge as well as at high outdoor temperatures. The borings for the stabilizers are equipped with guide bushes.

€76.30*

Average rating of 0 out of 5 stars

ARA320473 ARRMA Stone Guards
Genuine ARRMA spare/option part. Contents:1 pair

€14.99*
Loading...
Upload in progress, please be patient ...
Shopware-Agency Shopware-Agency