These sets fit FG Monster Truck, FG Stadium Truck and Carson Comanche. Content of delivery is always 2 tires, 2 foam inserts and 2 genuine FG rims. The tires are available in soft or medium, the rims in white or chrome.You can get the tires mounted and glued for an additional ? 20.- /pairDiameter 165 mmWidth 85 mm
Mammoth Supergrip complete gluedMammoth Supergrip for 1/6 and 1/5 offroad carsParking lot / race tires for your offroad car.VersionWidthOuter diameterFront64 mm153 mmRear78 mm153 mmGlued on genuine FG rims (rear tires using extension rings), with foam rubber inserts included. Rim has 18 mm square drive with reinforcement ring.Please note: based on experience we recommend against using other manufacturers rims and extensions. Since the Mammoth tires provide very good grip the rim and the bonding must withstand high loads. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.The Mammoth Supergrip is available in in the following compounds: Super softSoftMediumHardFront tirey0581y0582y0583y0584Rear tirey0591y0592y0593y0594General recommendation:The dirtier the track or the lower the ambient temperatures, the stickier (softer) the rear tires should be.Hint regarding the front tires: 2WD cars should use them one or two grades harder then the rears. 4WD cars usually like the same compound all around.Of course, the softer the tire the higher the wear rate; and this applies to Mammoth Supergrip onroad tires as well.The tires have a special onroad thread pattern but will still provide ideal traction after the pattern has been worn out. The white lettering on the tires has been applied for presentation purpose only. The tires will be delivered with black sidewall.Prices per unit: FrontRearMammoth Supergrip:Pair44,90 EUR49,90 EURTire inserts:Pair13,00 EUR13,00 EURFG rim:Pair14,90 EUR14,90 EURFG extension ring:Pair--.-- EUR14,90 EURMounting:Pair13,00 EUR13,00 EURPrices Total:85,80 EUR105,70 EUR / Set= 191,50 EURHT prices Total:82,70 EUR86,90 EUR / Set= 169,90 EUR================================Also suitable for:With the following wheel adapter: y1183 Rim adapter
Servo HS-1000 SGT Hitec - 138110, usedThe servo was tested in our workshop!It was installed in a Losi 5ive-TDelivery includes the aluminum servo mounts and aluminum servo lever for Losi 5Ive-T.The first servos with this performance, not only for industrial applications, but also for XXL large-scale models. Equipped with a hand-wound brush motor for maximum reliability and durability. Aluminum housing against electromagnetic interference, an indestructible steel gearbox and digital servo electronics (not programmable) are further special features of these servos.Servo HS-1000 SGT Hitec - 138110Actuating force 11.1V: 84.0 kgcmActuating time 11.1 V: 0.26 sec/60 degreesActuating force 14.8 V: 110.0 kg/cmActuating time 14.8 V: 0.19 sec/60degreesDimensions: 64 x 33 x 73 mmWeight: 363 grControl: DigitalBall bearing: YesGear: MetalLength approx: 64 mmWidth approx: 33 mmHeight approx: 73 mmWeight approx: 363 gInput voltage: 11.1-14.8 VoltCondition see photos.
1 piece Samba steel for DBXL 2.0 with engines up to 32 cm³ in titanium look. Top quality and optimum performance across the entire rev range of your engine.The resonance pipe is supplied with manifold and complete mounting material.See photos for scope of delivery and condition.