Challenge Line 2WD 530E Electric BMW M3 ALMS incl. ESC + Motor

Genuine FG spare/option part. The FG Touring and Sports cars at scale 1:5 are known for their high quality and very detailed bodyshells true to original. Also the technically fully developed chassis are worth mentioning. These models are now available with a high-torque brushless engine. Surface conditions with maximum grip assumed speeds above 100 km/h can be reached and steered controlled. E stands for electric power which is equivalent to extremely high torque, high speed and all this without any engine noise. The Challenge Line models are equipped with a powerful 800 - 1300 kV brushless Motor and a 150A brushless ESC. This control can be regulated simply via transmitter or optionally via the program card.The models are built on a 4mm aluminium chassis with rear wheel drive and double wishbones front and rear. All borings are countersunk. Fully adjustable front and rear double wishbone suspensions.Further equipment points are: differential gear, oil-pressure shock absorbers with volume control and external, adjusting ring for the initial tension of the spring. All rotating parts on ball bearings.Tires are glued on the rims.For all versions of the electric cars, the LiPo batteries and the matching charger, as well as the radio system and the steering servo (RTR) are required. In our shop selection, the RTR set is available for a surcharge.For hassle-free assembly, FG recommends using LiPo batteries 2x 2S or 2x 3S, with a maximum dimensions of 150 mm in length and 50 mm in width. The model comes with the EC8 connector system equipped.

Fully synthetic oil, available in three blends. 1-liter bottle.The optimal 2-stroke oil for 23-30 cm³ engines/cars Motul Racing Oil is available in three different blends: On-Road for high revving onroad cars Off-Road for cars with high torque enginesMixing ratio for 1/5 & 1/6 applications: We recommend a mix with about 4% oil, which means 200 cc of oil to 5 litres of gas (1:25 ratio). With one litre of Motul oil you can mix about 25 litres of optimal fuel for your 1/5 or 1/6 car. That's enough for well over 20 hours of driving fun! Oil / Gas Oil percent Oil per 1 liter of gasoline Oil per 2 liter of gasoline Oil per 3 liter of gasoline Oil per 4 liter of gasoline Oil per 5 liter of gasoline 1:20 5% 50 ml 100 ml 150 ml 200 ml 250 ml 1:25 4% 40 ml 80 ml 120 ml 160 ml 200 ml 1:30 3,33% 33 ml 67 ml 100 ml 134 ml 167 ml 1:33 3% 30 ml 60 ml 90 ml 120 ml 150 ml 1:35 2,86% 29 ml 58 ml 86 ml 115 ml 143 ml 1:40 2,5% 25 ml 50 ml 75 ml 100 ml 125 ml 1:50 2% 20 ml 40 ml 60 ml 80 ml 100 ml

To celebrate the 30th anniversary of the legendary Marder 1/6 scale 2WD buggy, FG Modellsport/T2M releases a special edition, limited to 300 numbered pieces, with the original signature of Franz Gröschl on the sticker sheet as well as a top equipment (G260RC Zenoah engine, hi-capacity low friction aluminum shock absorbers and special aluminum engine mounts). with original 260 Zenoah with Low-Friction Alu shocks with alloy enginemount The Models is built on a 4 mm u-bended chassis. All borings of the lower side are countersunk, therefore the screw heads can't bear out.Double wishbones at font and rear axle as well as 4 bulk oil-pressure shock absorbers guarantee perfect ground adherence. All rotating parts are supported by ball-bearings. Rear gear wheels, differential gears and all driving elements are case-hardened. The side guards protect the model from dirt. With original signature of Franz Gröschl. The model is equipped with a powerfull 26 ccm engine which runs with normal 2-stroke petrol-oil mixture (available at every petrol station). The tank filling of 0,7 liters enables you to drive about 45 minutes. The engine can be started without difficulties through the integrated pull-start. To complete the models all merchantable servos and radio control systems are suitable.You can select the car with complete RTR-equipment from the options menu. RTR-equipment RTR = Ready to Run. The RTR version comes ready to use with the 2,4 GHz rc-system already installed. Transmitter 2,4 GHzReceiverHigh power servo for throttle and brakeLargescale servo for steeringTx-battery, rx-battery

T-FHSS SR (SUPER RESPONSE) AND TELEMETRY T-FHSS:In addition to the T-FHSS telemetry system, we added a T-FHSS SR (Super Response) system that increased processing speed to further improve response. SR system does not support telemetry function. *R304SB and R304SB-E are not compatible with SR system.T-FHSS MINIZ SYSTEM:By changing to the MINIZ system in the receiver setting menu, you can use Kyosho Mini – Z Evo dedicated receiver RA-42. Dedicated Kyosho receiver RA-42 requires purchase separately.FHSS MINIZ SYSTEM:By changing to the MI-FH system in the receiver setting menu, you can use Kyosho Mini – Z FH FS-RM005 module to connect to non-Evo Mini-z.TELEMETRY SYSTEM:The T4PM+ transmitter has adopted the newly developed bidirectional communication system “T-FHSS”.2.4 GHZ SS RADIO COMMUNICATION SYSTEM:Frequency channel setting is unnecessary: Channel shifting takes place within the 2.4 GHz band automatically. This system minimizes the interference from other 2.4 GHz systems.MODEL MEMORY FOR 40 MODELS:Model names can use up to 10 letters, numbers, and symbols, so that logical names may be used. A model memory with different setups can be created by using the model copy function.4-AXIS JOG BUTTON:The (JOG) button can be operated in 4 directions: up, down, left, and right.ESC-LINK FUNCTION (MC-LINK):This dedicated function allows you set up the Link software so that your T4PM can control variable frequency and other data changes in Futaba speed controllers (ESCs): MC970CR, MC850C, MC851C, MC602C, MC402CR, etc.S.BUS SERVO:This is a special function that allows setting of the parameters of our S.Bus servo whose settings are changed by using PC Link software. In addition to the conventional wired system, it can be set wirelessly in combination with the R334SBS or R334SBS-E.STEERING MIXING:Smooth cornering is possible by independent left and right steering servo setting.BRAKE MIXING FOR LARGE CARS (BRAKE):Brake mixing of the front and rear wheel of 1/5 gas power cars and other large cars can be adjusted independently.GYRO MIXING (GYRO MIX):The sensitivity of Futaba car rate gyros can be adjusted from the T4PM.4WS MIXING FOR CRAWLERS AND OTHER 4WS TYPE (4WS):This function can be used with crawlers and other 4WS type vehicles.DUAL ESCS MIXING FOR CRAWLERS CARS (DUAL ESC):ESCs at the front and rear are controlled independently.CPS-1 MIXING (CPS MIX):LED lighting and flashing control using our CPS-1 channel power switch can be matched to steering and throttle operation by switch only.ANTI-SKID BRAKING SYSTEM (TH A.B.S):This function applies the brakes so that the tires of gas powered cars, etc. do not lose their grip on the road even when braking at corners.THROTTLE ACCELERATION (ACCEL):Gas power cars have a time lag before the clutch and brakes become effective. The throttle acceleration function reduces this time lag.THROTTLE SPEED (SPEED):Sudden trigger operation on a slippery road surface will only cause the tires to spin and the model to not accelerate smoothly. By setting the throttle speed function, operation can be performed smoothly and easily. It also suppresses battery consumption.STEERING SPEED (SPEED):When you sense that the steering servo is too fast, etc., the servo operating speed (direction that suppresses the maximum speed) can be adjusted.RACING TIMER (TIMER):The lap timer can record 100 lap times and total time. The timer can also be started automatically by trigger operation. The race time and audible alarm can be set. Re-/fueling time are indicated by an audible alarm. An up timer is also provided.FUNCTION SELECT SWITCH (SWITCH)/DIAL FUNCTION (TRIM DIAL):This assigns functions to 2 switches and dials (digital trim, digital dial). The step amount and operating direction can also be adjusted. Trim positioning at each model call is unnecessary because all the dials are digital.TRIGGER POSITION CAN BE CHANGED:The position of the throttle trigger can be moved forward and backward.TENSION ADJUSTMENT FUNCTION:The tension of the steering wheel and throttle trigger springs can be adjusted from the outside.MECHANICAL ATL ADJUSTMENT:Make this adjustment when you want to decrease the total travel of the brake (push) side of the throttle trigger.YOUR T4PM-PLUS INCLUDES THE FOLLOWING COMPONENTS:T4PM-Plus TransmitterR304SBS ReceiverDry Battery HolderMini ScrewdriverTRANSMITTER SPECS:T-FHSS SR/T-FHSS/S-FHSS SYSTEM, WHEEL TYPE, 4 CHANNELSCOMMUNICATION METHOD: Bidirectional protocolMAXIMUM OPERATING RANGE: 100m (Except the MINIT system) (Optimum condition)FOR SAFETY: F/S, B-F/S, IDTRANSMITTER FREQUENCY: 2.4GHz bandRF POWER OUTPUT: 100mW EIRPPOWER REQUIREMENT: (Dry Cell Battery) Penlight x 3 (4.5 V)CURRENT DRAIN: 150mA or lessTRANSMISSION ANTENNA: 1/2λ di-poleR304SBS Specs:T-FHSS SRSIZE: 33.9 x 22.3 x 11.3 mmWEIGHT: 7.5gOPERATING VOLTAGE: DC 3.7-7.4VR304SB Specs (optional):T-FHSSSIZE: 35.1 x 23.2 x 8.5mmWEIGHT: 6.6gOPERATING VOLTAGE: DC4.8-7.4VR304SB-E Specs (optional):SIZE: 35.1 x 23.2 x 12.5mmWEIGHT: 7.0gRATED VOLTAGE: DC4.8-7.4VOPERATING VOLTAGE: DC4-8.4VNever use the R304SB-E receiver in GP cars/boats

Genuine FG spare/option part. The FG Touring and Sports cars at scale 1:5 are known for their high quality and very detailed bodyshells true to original. Also the technically fully developed chassis are worth mentioning. These models are now available with a high-torque brushless engine. Surface conditions with maximum grip assumed speeds above 100 km/h can be reached and steered controlled. E stands for electric power which is equivalent to extremely high torque, high speed and all this without any engine noise. The Challenge Line models are equipped with a powerful 800 - 1300 kV brushless Motor and a 150A brushless ESC. This control can be regulated simply via transmitter or optionally via the program card.The models are built on a 4mm aluminium chassis with rear wheel drive and double wishbones front and rear. All borings are countersunk. Fully adjustable front and rear double wishbone suspensions.Further equipment points are: differential gear, oil-pressure shock absorbers with volume control and external, adjusting ring for the initial tension of the spring. All rotating parts on ball bearings.Tires are glued on the rims.For all versions of the electric cars, the LiPo batteries and the matching charger, as well as the radio system and the steering servo (RTR) are required. In our shop selection, the RTR set is available for a surcharge.For hassle-free assembly, FG recommends using LiPo batteries 2x 2S or 2x 3S, with a maximum dimensions of 150 mm in length and 50 mm in width. The model comes with the EC8 connector system equipped.

Spare part for .Length 59 mmWidth 264 mm

With this robust and reliable FG chassis, which is equipped with a powerful 26 cm³ combustion engine, you get the ideal entry into the fascinating "royal class" of large scale RC models as well as into the competition.The model has a 530 wheelbase. The models are built on a 4 mm alloy chassis with double wishbones at front and rear axle. All borings of the alloy chassis are countersunk to prevent the screw heads from bearing out. The models are serial equipped with the 2-damper front axle which guarantees an optimal traction of both front wheels. At the front/rear axle you can adjust through track rods or adjusting screws with right-/left-handed thread the king pin angle, trailing effect and toe-in.Further equipment points are differential gear, 24 teeth steel pinion, oil-pressure shock absorbers with volume control and external adjusting ring for the initial spring preload. All rotating parts as shafts, axles and clutch bells a.s.o. are supported by ball bearings.The remote control, the two servos and the receiver battery (RTR set!) are required to operate the FG model. This RTR equipment is available in our shop selection for an additional fee.The body shell is clear, but also available in a painted version in our shop selection for an additional fee.Thanks to the numerous available option parts, you can upgrade your FG Challenge Line as required.You can select the car with complete RTR-equipment from the options menu. RTR-equipment RTR = Ready to Run. The RTR version comes ready to use with the 2,4 GHz rc-system already installed. Transmitter 2,4 GHzReceiverHigh power servo for throttle and brakeLargescale servo for steeringTx-battery, rx-battery Dimensions:Length: 780 mmWidth: 392 mmHeight: 240 mmWheelbase: 530 mm