B69021 Brake

Top quality epoxy P-R-M Race brake discs with four dirt slots and 12 4-mm holes for removing dirt and abrasion, which will be transferred to the outside by the discs rotation. The epoxy R-P-M Race brake disc provides an optimal deceleration of the car without the unwanted fading (poor braking performance due to increased heat buildup!)! With an extremely heavy car like the Losi 5ive-T and Mini exceptionally good braking effect is especially important, of course! The epoxy R-P-M Race brake discs for the Losi 5ive-T/Mini are a direct replacement for the original aluminum brake discs. Dimensions: Outer diameter: 60 mm Thickness: 3 mm socket for the stock Losi 5ive-T/Mini drive cup Weight: 383 grams/ pair

Genuine HT spare/option part.These heavy duty differential drive cups for the center differential in a Losi 5ive-T/2.0/B or MINI WRC are made of 300M / Böhler V132 steel and are characterized not only by high hardness, but also simultaneously toughness. The service life is therefore much higher than for the stock cups. Replaces stock parts LOSB3214 and TLR252008.300M steel is used in motorsport and aviation for high strength parts. As a highly pure material, it is significantly more expensive than conventional steels, its high basic strength and toughness make the machining a time-consuming task.The 300M steel center diff drive cup has the same dimensions as the stock part.Contents:2 pieces of 300M steel HD differential drive cup, center diff application2 pieces of 4x18 drive pins

Genuine HT spare/option part. The spool replaces the center differential and keeps the speed of both output shafts the same. As a result, especially the acceleration of the vehicle is significantly increased.The spool is nicely made of high-quality burnished steel and very strong. Its total length is the same as a normal differential housing with gasket. The gasket is no longer used with the spool. The driving pin of the front output shaft is secured by an O-ring. The screws for the connection with the spur gear are secured with nylock nuts. This eliminates the need for waiting for the curing of a thread locking compound and makes the removal of screws with damaged head much less critical.The spool would physically fit front and rear applications as well; however, its use here makes no sense to driving dynamics.Scope of delivery:Spool2 x Driving pin 4 x 20 mmO-ring4 x Steel nylock nut M4

One pieces of steel ball joint with 5 mm bore in ball and M8 r/h or l/h thread.Suitable for most every 1/5 and 1/6 car!Replaces FG plastic ball joints # 6029/08 and # 6081/01 in conjunction with the conical spacers # 4429/02.Replaces Smartech # 32409 and # 32446 as well.

Sintered steel clutch for Zenoah and many other rc-car engines from 23 cm³ to 32 cm³. incl. clutch spring!Note: The sintered steel clutch needs a break in period of at least half an hour run time after their first installation. Only then the clutch surface reaches the desired grip and provides the necessary friction. After that the clutch will show consistent operation and extremely low wear!With 80 grams the weight of the clutch is about the same as the usual OEM clutches.As with all non-adjustable clutches a periodic monitoring of the clutch spring is recommended. By changing the spring, it is also possible to match your car to the track conditions, i.e.: the harder the spring, the higher the stall speed of the clutch.If not on hand, for installation of the sintered steel clutch a clutch spring, the Zenoah screw set # 7318 and the original Zenoah clutch mount # 7315 are required!

Genuine Losi spare/option part. Contents:2 pieces