The FID electric starter comes pre-assembled and suitable for all HPI Baja and Losi 5ive-T also 5ive Mini cars. With the FID starter unit you can start and stop the engine using your remote control system (a free channel is required!). We created detailed installation instructions which you can download here. We also translated a video tutorial which was made by FID.The transmitter must have a 3-position switch (preferred) or a linear control for the 3rd channel (start - run - stop)! We know that the following transmitters provide this option:Spektrum DX4C / DX4S / DX4R pro / DX3R pro / DX3CSanwa M12 / M11X / M11Futaba 4PLS, 4PK, T7PXThere may be other transmitters which meet these requirements. If in doubt, the appropriate transmitter's instruction manual should be consulted.If a transmitter provides only a two-position switch for the aux channel, you can still use the remote starter; however you have to go without the remote killswitch feature.From our current range of tuned pipes the Samba and Mielke fit the Losi; all pipes will fit the HPI. The genuine Losi pipe can be installed with some bending to the pipe's bracket!The installation with other tuned pipes may be possible, but it's necessary to check at your own discretion.Attention:Does not fit HPI Baja in combination with stock exhaust can and Losi 5ive-T AVC, 5ive Mini WRC, MTXL with stock air filter. Use Losi airfilter instead.Additional content of set FID046/01:Adapter cable (y1303/02)Screws and washersMounting bolts for the controller boxOf course, you will also find all for the FID starter unit in our online shop!
Conversion kits to convert a front or rear disk brake to a Tuning disk brake for front or rear axle.Kit 06250/08 fits all rims from Ø100mm.Kit 08450/08 fits all rims up to Ø90mm.
Genuine FG spare/option part. The rear disk brake is suitable for 1:5 models, Race-Trucks, the current version from Evo, 1:6 Off-Road and Monster models. The disk brakes prevent a breaking-out of the rear, have a very sensitive adjustment and are optically very effective. You can run the front disk brake with the gas servo, but make sure the servo has a minimun regulating power of six kilograms. We recommend to steer over two servos if you install front and rear disk brake. We deliver the disk brakes without uprights. In combination with the rim 6105/01 also suitable for Marder, Beetle and Pajero.Additional equipment for front and rear tuning disk brake:8472/01 Flexible bowden cables8474/05 Alloy bowden cable holder8469 Alloy guiding plate with ball bearing8479 Steel bush8448 Stud bolt for brake lining8458/02 Lasered tuning disk brake8457/03 Competition brake lining