6540 FG Receiver box
€15.90
Available
Product information "6540 FG Receiver box"
Splash-proofed receiver box for all merchantable small receivers, suitable for all car models 1:12 - 1:5.
Dimensions:
- Length: upper section 92 mm, bottom 69 mm
- Height: 48 mm
- Width: 38 mm
Contents:
- 1 piece
Login
Accessories / Spare parts
Futaba / universal type connectors for both battery and receiver.
Customers also bought
Set not included mounting parts. Replacement part for Frontspoiler No. 10265
Genuine FG spare/option part. Suitable for all FG touring cars with short or medium wheel base.Dimensions:Total length: 225 mmMounting bolt distance: 190 - 210 mmContents:1 piece
Genuine FG spare/option part.For Formula 1 rear tires.Dimensions:Length: 360 mmWidth: 70 mmHeight middle: 12 mmHeight side: 6 mmContents:2 pieces
Genuine FG spare/option part.Suitable for the FG GT1 models with a width of 420mm, f.e. CLK-GTR, Porsche GT1, GT2, GT3, for the Formula 1 and all 1:6 Buggy and Monster models. For rear axle only! 4WD cars must use GPM ball drive set GPM66275 for the front.For Marder and Beetle models until Nov'03 the raised uprights 6077 bzw. 6478 are needed.Content:1 set
Customers also viewed
Set not included mounting parts. Replacement part for Frontspoiler No. 10265
Genuine FG spare/option part. Powerfull servo for 2WD and 4WD 1/5 and 1/6 cars. Ballraced, with metal gears.Technical data:Voltage : 6.0-7.4VSpeed : 0.14s-0.12s/60°Torque: 9-10kgcmDimensions : 40.8 x 20.1 x 38 mmWeight : 56 gContents:1 piece
Genuine FG spare/option part. Spare part for Zenoah ZG22, G230RC, G230RC 04 and G260RC.Zenoah bolts 7318 are required for installation.Contents:2 pieces
Genuine HT spare/option part.Wheel squares made of high-strength aluminum, hardened, with two M6 mounting threads Suitable for most 1/6 and 1/5 rc-cars. Through the use of two 6 mm screws a significantly higher retention force is achieved. Yet it is still recommended to use medium strength thread lock (link y0114)! The hard anodizing (HART-COAT) guarantees much lower wear of the squares! Especially recommended when using wheel mounted brake discs! Four 3x16 dowel pins per square are included which prevent the squares from spinning in the rim. Press fitting them into the wheel squares is optional. The 12, 14 and 17 mm wide squares feature a groove for inserting a C-clip (link 6106/05), which acts as a guide for the brake disk. The narrow 9.5 mm wide squares dont need a clip; the close sitting rim will guide the disk. Measures18 mm square (wheel drive!)9,5 mm wide, 8.0 mm diameter axle boretwo M6 mounting threads The set includes 2 pieces of 9,5 mm wide wheel squares and 4 pieces each of M6 grub screws and 3x16 dowel pins.Contents:2 pieces
Genuine FG spare/option part. Spare part for 10456.Content:1 piece