Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

6496/04 FG Guide bushing - 8pcs.

Product information "6496/04 FG Guide bushing - 8pcs."


6 mm bore

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Customers also bought

Average rating of 0 out of 5 stars

1097/01 FG Flanged bushing
Genuine FG spare/option part.Dimensions:6 x 8 x 7,5 mmContents:6 pieces

€5.50*

Average rating of 0 out of 5 stars

1213/11 FG Steering linkage l./r., M4 x 42 mm
Genuine FG spare/option part. Contents:2 pieces

€19.95*

Average rating of 0 out of 5 stars

1080/01 FG Insert nuts for 1080
Genuine FG spare/option part. Are needed for the installation of the CFK chassis reinforcement (1080).For every bar are needed four nuts.Contents:4 pieces

€15.90*

Average rating of 0 out of 5 stars

y1036 HT rose joints with conical spacers
Genuine HT spare/option part. Dimensions:A = 5 mmB = 6 mmC = 8 mmD = 13 mmContents:2 pieces rose joints4 pieces conical spacers

€24.90*

Average rating of 0 out of 5 stars

6038 FG Engine mount washers for M4 and M4 screws
Genuine FG spare/option part. Washers for the screws (M4 / M5) that hold the engine mounts to the chassis. Suitable for all FG models.Dimensions:Outside diameter: 15 mmInside diameter: 6 mmContents:4 pieces

€6.50*

Average rating of 0 out of 5 stars

DYNE1240 Dynamite Large Scale Safety Kill Switch
Genuine Dynamite spare/option part.Key Features:Kills your 2-cycle gas engine on command, loss of radio signal, low battery, or total battery power lossComes ready to install no soldering requiredOptically Coupled to isolate your ignition system from your radio systemBuilt-in LED for easy-to-spot operational status3-Channel Radio System RequiredNot Compatible with AVC-Equipped ReceiversContents:1 piece

€39.99*

Similar products

Average rating of 0 out of 5 stars

6464/04 FG Foam filter
Genuine FG spare/option part.Spare part for FG no.: 6464.Dimensions:Inner diameter: 20 mmHeight: 71 mmContent:2 pieces

€11.50*

Average rating of 0 out of 5 stars

6464/05 FG Foam filter oiled
Genuine FG spare/option part.Spare part for FG no.: 6464.Dimensions:Outer diameter 61 mmInner diameter 20 mmHeight 71 mmContent:2 pieces

€13.50*

Average rating of 0 out of 5 stars

6465 FG air filter for 1:6 Off-Road models complete - set
Item N° 6465 FG air filter for 1:6 Off-Road models complete - setYou will need the adapter plate 6451/03 for installation.

€34.50*

Average rating of 0 out of 5 stars

6492 FG Steel spur gear 46T with adapter - set
Hardened steel spur gear for FG 1/6 off-road models, spur gear diameter 72 mm.Module: m=1,5

€84.90*

Average rating of 0 out of 5 stars

6496 FG Alloy front bulkhead 2WD A and B
Genuine FG spare/option part.CNC-manufactured front axle mounts A and B in alloy with rebound stop. The borings for the wishbone pins are equipped with guide bushes. Suitable for Marder, Marder Race, Beetle On-/Off-Road and Monster models.Contents:1 set

€78.95*

Average rating of 0 out of 5 stars

6477/03 FG Upright pin 4 mm
Genuine FG spare/option part.Spare part for 6477. Dimensions:Length 19 mmDiameter: 4 mmContents:2 pieces

€6.30*

Average rating of 0 out of 5 stars

6485/01 FG Alloy engine mount small for 1:6/CY / Zenoah alloy - 1pce.
Item N° 6485/01 Alloy engine mount small for 1:6/CY / Zenoah alloy - 1pce.Small alloy engine mount suitable for FG 2WD and 4WD 1/6 cars and Porsche 4WD with CY / Zenoah G230/240/260/270 engine.

€43.90*

Average rating of 0 out of 5 stars

6493 FG Steel spur gear 48T with adapter
Genuine FG spare/option part. Hardened steel gearwheels for the gears of the 1/6 off-road models.Module: m=1,5Contents:1 set

€84.95*

Average rating of 0 out of 5 stars

6479 FG Rear alloy uprights 08
Alloy upright for a ball fastening at the upper wishbone. Adjustable at the lower wishbone (wishbone pin), too. Fits the rear axle of all FG offroad cars (2WD and 4WD) and all Carson / Smartech cars.Content:Bearing seats: 22 x 7 mmHinge pin bore: 6 mmDistance wheel shaft/hinge pin: 25 mm

€109.50*

Average rating of 0 out of 5 stars

6462 FG Air filter adapter for 6460 and 6461 - 1pce.

€16.70*

Average rating of 0 out of 5 stars

6493/01 FG Steel spur gear 48T - 1 pce.
Item N° 6493/01 Steel spur gear 48T - 1 pce.Outer diameter: 75 mmInner diameter: 26 mmBolt circle: 3 x 35 mmWidth: 10 mmModule: m=1.5

€56.70*

Average rating of 0 out of 5 stars

6489/03 FG Left Upright raiser
Genuine FG spare/option part. Content:2 pieces

€43.50*

Customers also viewed

Average rating of 0 out of 5 stars

1097/01 FG Flanged bushing
Genuine FG spare/option part.Dimensions:6 x 8 x 7,5 mmContents:6 pieces

€5.50*

Average rating of 0 out of 5 stars

y0700/01 Single-sided alloy servoarm, 1 pce.
Item N° y0700/01 Single-sided alloy servoarm, 1 pce.Suitable for all servos with an output shaft with 25 teeth multi-tooth shaft, for example:y2006 Digital Big-Scale Servo D-21HVNearly all Robbe/Futaba servosMega Power servoThunder Tiger DS1015Savöx servosand many more!When you count the teeth of your servo you can check if this alloy arm will fit to your servo. Alloy servoarms are indispensable by strong digital servos, as used on big scale models for example, to optimize the servo forces being transferred.

€13.90*

Average rating of 0 out of 5 stars

1076/01 FG Rear shock tower front for Evo 2020.2
Genuine FG spare/option part. for FG Evo 2020.2 models.Contents:1 piece

€43.50*

Average rating of 0 out of 5 stars

y0305 Colored flexible fuel line, top quality, 1 meter
y0305 Color: y0305/04 - Green
High quality flexible fuel line in your choice of blue, red, yellow, orange and green. Size:Length: approx. 1 meterOuter diameter: approx. 6.3 mmInner diameter: approx. 3.2 mmDiameters are 100% identical to the Zenoah Tygon hose #7352!

€5.90*
%

Average rating of 0 out of 5 stars

68510 FG Electric conversion kit 1:6 2WD for 465 Wheelbase, set
Item N° 68510 Electric conversion kit 1:6 2WD for 465 Wheelbase, setSuitable for 2WD Buggy and Monster models as Marder, Beetle, Monster-Truck, Hummer, Jeep a.s.o with 465 mm wheelbase.This conversion kit is suitable for the 2WD FG models Marder, Beetle, Off-Road Buggy and Monster models with 465mm wheelbase. Suitable for the electric engines from FG Modellsport, Leopard BL engines and Castle Creation. The conversion kit includes gear and engine mount, fixing parts for cruise control and LiPo batteries. Cruise control, BL engine and LiPo batteries are not included. During the conversion several fixing holes have to be applied to the chassis. Gear transmission has to be changed accordingly to the use of the electric engine.For easy mounting we recommend LiPo batteries with a max. length of 150mm and 50mm width.The conversion kits include all mechanical parts (except electric engine with speed control, Lipo batteries) to convert your FG model scale 1:5 and 1:6 to an electric powered system.

€189.99* €199.99* (5% saved)
Loading...
Upload in progress, please be patient ...
Shopware-Agency Shopware-Agency