Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

4823 Samba BIG BELLY tuned pipe for Losi 5ive-T with up to 32 cm³

Product information "4823 Samba BIG BELLY tuned pipe for Losi 5ive-T with up to 32 cm³"

The Samba 5ive T tuned pipe from the 1/5 world champion!
At the 1/5 World Championship were place 1 to 10 (!) equipped with a samba tuned pipe system.

A proof of competence without equal!

BiG BELLY, special version for the 5ive-T / Monster Truck XL with engines up to 32 cm³ engine. Comes with complete hardware for installation.

Top quality and optimized performance across the entire rpm range of your engine.

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Accessories / Spare parts

Average rating of 0 out of 5 stars

Samba 4806 Manifold for 4820, 4821, 4822, 4823
Genuine Samba spare/option part. Contents:1 piece

€42.90*

Average rating of 0 out of 5 stars

y0564 RC Tech Pipe Protect 400 ml
Genuine HT spare/option part. RC Tech Pipe Protect protects your exhaust against oil and rubber deposit while racing. A clean exhaust gives better resonance, which means better performance from your engine. Thanks to RC Tech Pipe Protect your exhaust system can evacuate the temperature better.Direction of useSpray a relatively thick layer of Pipe Protect from a close distance; +/- 15/20 cm on your new or just-cleaned and preferably polished exhaust pipe. After each ride clean the exhaust pipe with a clean cloth, if necessary slightly sprayed with some Pipe Protect. Treat the exhaust pipe again before each race.Contents:1 piece / 400 ml

Content: 400 Milliliter (€24.75* / 1000 Milliliter)

€9.90*

Average rating of 0 out of 5 stars

y804 HT-flange sealer 518, 50 ml up to 200°C
Especially for installation of all engine gaskets. Temperature resistant from -55 °C to +200 °C. Resistant to water, mineral oils, synthetic lubricants, fuels, organic solvents and refrigerants. info: Hand tight: 10 - 20 minReady to use: 1 - 3 hoursGap fill: 0.5 mmContent: 50 ml Notes for usage: This surface seal is not for use as the sole sealant, it should always be applied in combination with a paper gasket.The HT-surface sealing agent should be sparsely applied over the entire surface, with care being taken that the sealant does not enter the devices internals (e.g. crankcase, differential a.s.o.) during the assembly.

Content: 50 Milliliter (€538.00* / 1000 Milliliter)

€26.90*

Average rating of 0 out of 5 stars

y0482 Anti-vibration spring hose elbow Samba, 2 pcs.
Protects against vibration and dirt which could jeopardize the spring. The spring is not protected by the rubber tube only, but also relieved.product contents: 2 pcs.

€3.90*

Average rating of 0 out of 5 stars

7100/03 Samba sealing ring 70 x 3 mm
Genuine Samba spare/option part.Contents:2 piece

€3.90*

Similar products

Average rating of 0 out of 5 stars

4822 Samba BIG POWER tuned pipe for Losi 5ive-T/2.0 up to 32 cm³
The Samba 5ive T tuned pipe from the 1/5 world champion!At the 1/5 World Championship were place 1 to 10 (!) equipped with a samba tuned pipe system.A proof of competence without equal!BiG BELLY, special version for the 5ive-T / Monster Truck XL with engines up to 32 cm³ engine. Comes with complete hardware for installation.Top quality and optimized performance across the entire rpm range of your engine.

€239.00*

Average rating of 0 out of 5 stars

5187/XL2.0 Mielke Losi DBXL 2.0 tuned pipe exhaust system for 26 - 32 cm³
Genuine Mielke spare/option part.The tuned pipe system from premium manufacturer M. Mielke was specifically designed for Losi DBXL 2.0 in combination with large displacement and modified engines.The elaborate, angled design, makes best use of the available space in the DBXL 2.0 allowing for optimum performance! When designing the system, it was especially important to maximize the distance to the battery box of the DBXL 2.0 in order to minimize the thermal load on the battery. At the same time, the large distance improves access to Box. Contents:1 set

€279.00*

Average rating of 0 out of 5 stars

4820/32 Samba Competition tuned pipe for Losi 5ive-T/ 2.0 until 32 cm³
Genuine Samba spare/option part. The Samba 5ive T tuned pipe from the multiple world champion.The Samba Competition version!Top quality and optimized performance across the entire rpm range of your engine. The tuned pipe is designed for engines from 26 cm³ to 32 cm³ and is available in black painted! b> Contents:1 set

€239.00*

Average rating of 0 out of 5 stars

LOS55000 Tuned Exhaust Pipe, 23-30 cm³ Gas Engines for DBXL/2.0/MTXL
The most popular option part for a 1/5-scale gasoline-powered RC vehicle is a tuned pipe. For the Desert Buggy / Monster Truck XL, this is no different. We have been working with one of the most experienced aftermarket tuned pipe designers and we have a very effective solution. This tuned pipe was specifically designed for the Desert Buggy / Monster Truck XL to provide a 1-2 horsepower increase in performance and to give the Desert Buggy / Monster Truck XL the sound it deserves.DBXL 2.0 Tech Notes:For compatibility with the DBXL 2.0 model (LOS05008T1/T2), you must install DYNR0112 Aluminum Throttle Servo Arm.FeaturesSimple bolt-on installationInstant horsepower and performance increaseSounds amazing!Included all mounting hardware and fixtures

€229.99*

Customers also viewed

Average rating of 0 out of 5 stars

5187/XL2.0 Mielke Losi DBXL 2.0 tuned pipe exhaust system for 26 - 32 cm³
Genuine Mielke spare/option part.The tuned pipe system from premium manufacturer M. Mielke was specifically designed for Losi DBXL 2.0 in combination with large displacement and modified engines.The elaborate, angled design, makes best use of the available space in the DBXL 2.0 allowing for optimum performance! When designing the system, it was especially important to maximize the distance to the battery box of the DBXL 2.0 in order to minimize the thermal load on the battery. At the same time, the large distance improves access to Box. Contents:1 set

€279.00*

Average rating of 0 out of 5 stars

LO5T153 GPM Piggyback reservoir Shocks Losi 5ive-T/2.0/B/Mini, front set
Genuine GPM spare/option part. The GPM piggyback reservoir shocks increase the oil volume and the separate vent screw makes filling the shocks easier. Shocks come in pairs including all-metal lower ball joints, spring perches and springs with 2.75 mm wire diameter.These technically demanding, excellently manufactured GPM Piggyback shocks come ready for use, assembled and filled with 1000 viscosity silicone oil. For a possible fine tuning (less damping with lower viscosity, more with higher viscosity) we recommend our silicone oils y0038 (50 ml) or y0039 (100 ml). Approximately 23 cm³ of oil is required to fill one shock absorber.Suitable for Losi 5ive-T, 5ive-B and Mini.The shocks are compatible with all springs offered for these vehicles such as Front:Length extended/compressed (center-to-center of mounting points): approx. 156 mm/110 mm.Contents:2 pieces / 1 pairs

€139.90*

Average rating of 0 out of 5 stars

4822 Samba BIG POWER tuned pipe for Losi 5ive-T/2.0 up to 32 cm³
The Samba 5ive T tuned pipe from the 1/5 world champion!At the 1/5 World Championship were place 1 to 10 (!) equipped with a samba tuned pipe system.A proof of competence without equal!BiG BELLY, special version for the 5ive-T / Monster Truck XL with engines up to 32 cm³ engine. Comes with complete hardware for installation.Top quality and optimized performance across the entire rpm range of your engine.

€239.00*

Average rating of 0 out of 5 stars

4820/32 Samba Competition tuned pipe for Losi 5ive-T/ 2.0 until 32 cm³
Genuine Samba spare/option part. The Samba 5ive T tuned pipe from the multiple world champion.The Samba Competition version!Top quality and optimized performance across the entire rpm range of your engine. The tuned pipe is designed for engines from 26 cm³ to 32 cm³ and is available in black painted! b> Contents:1 set

€239.00*

Average rating of 0 out of 5 stars

LOSR 8020 Tuned Exhaust Pipe, for 23-30cc Gas Engines 5ive-T/2.0 and Mini
The Losi LOSR8020 tuned pipe is dollar-for-dollar the easiest and cheapest performance upgrade you can buy for your 5ive-T/Mini. This complete exhaust system uses advanced two-stroke tuning technology to dramatically increase the low and mid range power and throttle response allowing any common 23-31cc engine to reach peak RPMs much quicker. The development was done over hundreds of laps and many hours by the Losi development team with the help of one the premier 1/5 scale engine/pipe builders. This design features a separate conical header and an ultra smooth tooled expansion chamber with a telescoping fit for both reliability as well as performance. The use of advanced precise tooling to produce both the header and the pipe optimizes the shock wave effect of the expansion chamber system as well as maximizing the durability. The hi-quality steel alloy is coated with a rust and heat resistant black finish for added protection and appearance. The compact design offers plenty of room for access to chassis parts and, since the pipe bolts directly and securely to the engine, gear changes and service on the clutch or engine is extremely easy. All mounting hardware, exhaust gasket and coupler are included as well as being available separately.Attention:Contrary to all other pipes from our range, this tuned pipe system has no silencer! Therefore it is very noisy and not allowed on most every official race track!FeaturesSeparate conical header and an ultra smooth tooled expansion chamberConstructed of hi-quality steel alloy and is coated with a rust and heat resistant black finish for added protection and appearanceRace inspired exhaust provides increase in power and performanceCreates a Racer like exhaust tone which is thrilling for the user as well as the spectatorImproves performance and provides powerful exhaust note

€229.99*

Average rating of 0 out of 5 stars

y1589/01 Subaru Impreza Ralley Monte-Carlo 99 Body shell, painted
The body shell is complete painted for 1/5 cars with 510/515 mm wheelbase.With rear wing and decal sets.The body shell does not come with drilled mounting holes to make it possible to fit any 1/5 car with 510/515 mm wheelbase. Dimensions: Length: ca. 900 mm Width: ca. 370 mm Height: ca. 250 mm Required body mounts: Front bumper: 7020/16 and 7011/01 Front side: 8013 Rear side: 3014 Rear mount: 2x 7152/01 and 1x 7153 Contents:1 piece

€299.00*
Loading...
Upload in progress, please be patient ...
Shopware-Agency Shopware-Agency