y1558/03 LED module with switch, Spare part

Genuine TT spare/option part.Spare part for Killswitch TopTuning 0990 or Dynamite 1240. Also suitable for other projects at your own discretion.Operating voltage 2.1 Volt, approx. 15 mA2-pole connection cable with PVC insulation and 24 AWG/0.2 mm² cross-section, length approx. 180 mm.Contents:1 piece

Mammoth Supergrip complete gluedMammoth Supergrip for 1/6 and 1/5 offroad carsParking lot / race tires for your offroad car.VersionWidthOuter diameterFront64 mm153 mmRear78 mm153 mmGlued on genuine FG rims (rear tires using extension rings), with foam rubber inserts included. Rim has 18 mm square drive with reinforcement ring.Please note: based on experience we recommend against using other manufacturers rims and extensions. Since the Mammoth tires provide very good grip the rim and the bonding must withstand high loads. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.The Mammoth Supergrip is available in in the following compounds: Super softSoftMediumHardFront tirey0581y0582y0583y0584Rear tirey0591y0592y0593y0594General recommendation:The dirtier the track or the lower the ambient temperatures, the stickier (softer) the rear tires should be.Hint regarding the front tires: 2WD cars should use them one or two grades harder then the rears. 4WD cars usually like the same compound all around.Of course, the softer the tire the higher the wear rate; and this applies to Mammoth Supergrip onroad tires as well.The tires have a special onroad thread pattern but will still provide ideal traction after the pattern has been worn out. The white lettering on the tires has been applied for presentation purpose only. The tires will be delivered with black sidewall.Prices per unit: FrontRearMammoth Supergrip:Pair44,90 EUR49,90 EURTire inserts:Pair13,00 EUR13,00 EURFG rim:Pair14,90 EUR14,90 EURFG extension ring:Pair--.-- EUR14,90 EURMounting:Pair13,00 EUR13,00 EURPrices Total                                                                                          85,80 EUR    105,70 EURAlso suitable for:With the following wheel adapter: y1183 Rim adapter

Genuine HT spare/option part. Dimensions Jägermeister Logo:1 x 170 mm diameter1 x 90 mm diameter4 x 50 mm diameterDimensions Jägermeister lettering:1 x 250 mm width, 4 x 210 mm width,1 x 130 mm width, 2 x 60 mm width, Dimensions Dezent lettering 4x 110 mm width Total dimensions: Width: 490 mm Height: 420 mmIn the shopping cart selection of this large Jägermeister team decal sheet,this is also available in a with an extra charge under item number y0683/01high-quality opaque screen print version, available on a special film.This decor set is especially for decorating on dark Body colors suitable.Contents:1 piece

Formular 1 tire chart from the current series divided into 3 categories 1) Parking lot / hobbyThe durability of the tire is the main focus here.2) Race track / hobbyHere you will find the tire that offers a compromise of durability and performance.3) Race track / competitionHere the racer will find the tires for best lap times on a race track and to win races.Note:The harder a tire compound - the longer it lasts, but the more moderate the performance.The softer a tire compound - the better the performance, but the lower the durability. Hint!As a rule, the same tires can be used for front and rear.If the vehicle tends to oversteer, this can be avoided by using a harder front tire!In wet conditions you should use a rain tire which offers maximum grip under these circumstances.With the use of Magic Rain, a tire traction compound, the grip can be further improved.Check your tires after driving! It can happen that a tire starts to detach from the rim, in this case you should glue this spot immediately with our tire repair kit (y0067), otherwise the tire could detach completely from the rim.So find out which tire is the best for you!Type GWH33 XR1 ,the profile rain tire for the front axle.The most driven Formula 1 tires of the past years were modified for an better tire-to-wheel adhesion. The double tire adhesion on the outside is no longer necessary, only one tire lip has to be glued at this new series. Instead of the optical tire lip a plastic ring has to be glued on. The tires offered as glued are professionally glued from GRP on the wheels and ready to drive. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.Measures:Diameter: 140 mmWidth: 60 mmGlued on white rims. Glued by GRP on original Ellegi rim with 18 mm wheel square fits FG, Harm, RS5, Carson, Smartech, Nutech a.s.o

For converting the Sportsline long touring car into a model with 4WD drive. The conversion kit contains all chassis parts and drive parts that are required for the conversion.