WD-40 SPECIALIST contact spray removes oil, dirt, flux and oxidation residues from sensitive electrical or electronic equipment. The product can be used on electrical equipment, contacts, plastic and rubber.

Temperature application range: room temperature

Application:
First disconnect all plugs from equipment to avoid current and allow hot surfaces to cool. Shake the can before use and apply the spray directly on the surface to be treated at a distance of 15 to 20 cm. This will remove any residue that could interfere with electrical contact. Tilt the surface while cleaning and allow excess liquid to dry completely before restoring power. To avoid accidental damage, always check the manufacturer's instructions before applying the product to the equipment. Do not spray product into cavities, openings, crevices or areas of your device where it does not have sufficient airflow to support complete evaporation.

Smart Straw - Product Benefits:
The integrated spray head allows you to switch between large-area and precise spraying. In this case, the tube remains firmly attached to the spray head and is therefore no longer lost during application. For area spraying, the spray tube is simply folded down. With the spray tube folded out, you can reach small spaces and apply the product there with pinpoint accuracy. The 360° valve allows the can to be held upright or even overhead, making any application possible.


WD-40® multifunctional product infiltrates and loosens rusted and stuck screws. It penetrates the threads of hinges and protects against corrosion. WD-40® multifunction product displaces moisture, lubricates and eliminates squeaks.

• Smart Straw®
• Spray system for area and spot spraying
• Fast acting and non-conductive
• Perfect cleaning for electrical/electronic equipment, contacts, plastics or rubber
• Penetrates quickly without leaving residues
• Penetrates even the most difficult to reach areas
• K2 registered #145372

• Electrical assembly
• Circuit boards
• Controls
• Printers & copiers
• Switches

Shut off unit and allow hot surfaces to cool. Disconnect all plugs from unit to avoid power supply. Shake can before use. Apply spray directly to surface to be treated at a distance of 15 to 20cm to remove all residues that may interfere with electrical contact. Tilt surface during cleaning. Allow excess liquid to dry completely before restoring power. To avoid accidental damage, always check manufacturer's instructions before applying product to equipment. Do not spray into cavities, openings, crevices or areas of your equipment where this product does not have sufficient airflow to support complete evaporation. Tilt the surface during cleaning to allow excess liquid to drain and the product to dry completely before returning it to service and connecting it to the electrical circuit.

DOWNLOAD SAFETY DATASHEET