Mammoth Supergrip for HPI Baja offroad cars glued on FG Leopard rim, singel sizes, 1 pairs Mammoth Supergrip for 1/6 and 1/5 offroad carsParking lot / race tires for your offroad car.VersionWidthOuter diameterFront64 mm153 mmRear78 mm153 mmGlued on the new genuine FG Leopard rims (rear tires using extension rings), with foam rubber inserts included. Rim has 18 mm square drive with reinforcement ring.Please note: based on experience we recommend against using other manufacturers rims and extensions. Since the Mammoth tires provide very good grip the rim and the bonding must withstand high loads. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (VersionWidthOuter diameterFront64 mm153 mmRear78 mm153 mmGlued on the new genuine FG Leopard rims (rear tires using extension rings), with foam rubber inserts included. Rim has 18 mm square drive with reinforcement ring.Please note: based on experience we recommend against using other manufacturers rims and extensions. Since the Mammoth tires provide very good grip the rim and the bonding must withstand high loads. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.General recommendation:The dirtier the track or the lower the ambient temperatures, the stickier (softer) the rear tires should be.Hint regarding the front tires: 2WD cars should use them one or two grades harder then the rears. 4WD cars usually like the same compound all around.Of course, the softer the tire the higher the wear rate; and this applies to Mammoth Supergrip onroad tires as well.The tires have a special onroad thread pattern but will still provide ideal traction after the pattern has been worn out. The white lettering on the tires has been applied for presentation purpose only. The tires will be delivered with black sidewall.
Hybrid bearings with silicone nitride balls and steel inner and outer race. The bearings have an extremely low rolling resistance and a longer life than standard bearings. Please note that for installation only a shrink fit or a press fit via the outer race is allowed. Tapping them in will destroy the bearing.
Kit contents:1 pair each of mounted and glued Mammoth Supergrip Front H or M for the front and M or S for the rear.These combinations are recommended for the recreational driver. Glued on FG Leopard Race rims, fits all FG, Smartech, Carson and many other cars. Or for the ambitious driver:Choice of 2 pairs H = hard, M = medium, S = soft or super soft = SS!The softer the compound the more grip the tire will provide, but the harder the compound the longer the tire will last (as in the original Formula 1!) With the same compound for front and rear axle even a 4WD car requires better driving skills! As the saying goes: It turns better ;-) But chances are that you will also produce a more or less gallant spin out every now and then! Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable. It is known that any driver has his own preferred combination! The white lettering on the tires has been applied for presentation purpose only. The tires will be delivered with black sidewall. Measures:Width: 64 mmDiameter: 153 mmAlso suitable for:With the following wheel adapter: y1183 Rim adapterWith the following wheel adapter: y0786 Rim adapter
Genuine FG spare/option part. Axially displaced front uprights, the thread for the upper ball is relocated for 3mm towards the center of the car. This increases negative camber and changes the scrub radius during turns. Fits all touring car and race truck models, does not fit offroad and GT-models with wide front axle.Contents:2 pieces
€128.50*
This website uses cookies to ensure the best experience possible. More information...