Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

9452 FG Hydraulic oil 50 ml

Product information "9452 FG Hydraulic oil 50 ml"

Genuine FG spare/option part. 

Spare part for 9440 and Hydraulic brakes.

Contents:
  • 1 piece / 50 ml

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Customers also bought

Average rating of 0 out of 5 stars

y6107/02 Wheel squares 18 mm HART-COAT, 17 mm wide
Genuine HT spare/option part.Wheel squares made of high-strength aluminum, hardened, with two M6 mounting threads Suitable for most 1/6 and 1/5 rc-cars. Through the use of two 6 mm screws a significantly higher retention force is achieved. Yet it is still recommended to use medium strength thread lock (link y0114)! The hard anodizing (HART-COAT) guarantees much lower wear of the squares! Especially recommended when using wheel mounted brake discs! Four 3x16 dowel pins per square are included which prevent the squares from spinning in the rim. Press fitting them into the wheel squares is optional. The 12, 14 and 17 mm wide squares feature a groove for inserting a C-clip (link 6106/05), which acts as a guide for the brake disk. The narrow 9.5 mm wide squares dont need a clip; the close sitting rim will guide the disk. Measures18 mm square (wheel drive!)17 mm wide, 8.0 mm diameter axle boretwo M6 mounting threads The set includes 2 pieces of 17 mm wide wheel squares and 4 pieces each of M6 grub screws and 3x16 dowel pins.Contents:2 pieces

€18.95*

Similar products

Average rating of 0 out of 5 stars

9452/02 FG Filling and ventilation set
Genuine FG spare/option part. Spare part 9440.

€4.70*

Average rating of 0 out of 5 stars

9438/01 FG Pedestal for hydraulic brakes
Alloy pedestal to mount the master brake cylinder of the hydraulic brakes FG Magura 2, Mecatech Expert and Mecatech twin piston brake systems on the sloped chassis part of Off-Road Buggies and Monster models.Lieferumfang1x Pedestal for hydraulic brakes2x Countersunk screw with torx 4x12 2x Countersunk screw with torx 4x14

€14.40*

Average rating of 0 out of 5 stars

9439/38 FG Angle connector 45° for hydraulic brakes - 1 pce
Genuine FG spare/option part.Spare part for 9439.Contents:1 piece

€16.90*

Average rating of 0 out of 5 stars

9439/12, FG Brake line fitting, 90°, 1 pce.
Spare part for 9439

€13.90*

Average rating of 0 out of 5 stars

9439/30 FG Brake line clear 1 m
Original FG Ersatz-/Tuningteil.Measures:Outer diameter: 4 mmInner diameter: 2 mmContents:1 piece / 1 meter

€9.50*

Average rating of 0 out of 5 stars

9440/04 FG Screw M3x30mm for brake caliper, 4 pieces
Genuine FG spare/option part.Spare part for .Part is delivered in silver or black color from vendor!Content:4 pieces

€1.40*

Average rating of 0 out of 5 stars

9445 FG Brake disk - 2pcs.
Spare part for .Diameter 69 mm x thickness 1.5 mm

€45.90*

Average rating of 0 out of 5 stars

9440/31 Brake line black 1m - 1pce.
Spare part for .These parts are not more available from manufacturer, alternative you can convert complete to the 4mm lining system.To convert the lining of one brake/axle the following parts will be required:1x 4mm brake lining 1mT-connector 1x 90° angle connector3x More parts of this 4mm brake lining system you find here:

€6.90*

Average rating of 0 out of 5 stars

9451/01 FG Syringe - 1pce.
Spare part for .

€3.80*

Average rating of 0 out of 5 stars

9449 FG Brake line cutter - 1pce.
Tool for .

€34.90*

Average rating of 0 out of 5 stars

9445/05 FG GFK brake disk for hydraulic brake
Genuine FG spare/option part. Low weight, temperature stability and a very good dosable progressive brake performance distinguish these GFK brake disks. Suitable for all FG models with hydraulic brake system. Only useable in connection with the steel brake lining .Dimensions:Diameter: 69 mmThickness: 1.5 mmContents:2 pieces

€27.90*

Average rating of 0 out of 5 stars

9440/25 FG Valve
Genuine FG spare/option part. Contents:2 piece

€15.30*

Customers also viewed

Average rating of 0 out of 5 stars

6550 FG Switch for receiver cable
Genuine FG spare/option part. A switch which one well through a hole in the radio box and put on top and bottom can be secured with nuts.Contents:1 piece

€8.50*
%

Average rating of 0 out of 5 stars

y1463/01 MadMax SUPER GRIP 170x80/x60 for HPI+Losi & Co. (24 mm hex) Offer
SUPER GRIP 170 x 80 mm and 170 x 60 mm with black MadMax Extreme rims for 24 mm hex wheel drive, 20 beadlock screws per rim and reinforced orangen beadlock rings. Fits Losi 5ive-T, 5ive Mini, Desert Buggy XL and all HPI Baja 5B and 5T/SC cars.Due to the extreme stress created by the MadMax SUPER GRIP tires, the rim has been optimized again.The tires come with a special rigid insert which transfers the applied forces without tilting; even with the heaviest cars like the Losi 5ive-T.All together, the SUPER GRIP lives up to its name and provides maximum grip, which makes it necessary to use the supplied 3 mm beadlock screws for the MadMax EXTREME rims instead of the usual 2.5 mm screws. Additionally, the seating of these screws should be checked after each use.The MadMax SUPERGRIP tires have been designed especially for use on tarmac. Even on fine-pored tarmac your car will still find enough grip! (As you can see in our video.) On most 1/5 and 1/6 cars the best combination is the use of 60 mm wide front and 80 mm wide rear tires. The Losi 5ive-T Mini should run 60 mm wide MadMax SUPERGRIP tires all around, because the 80 mm wide SUPERGRIP tires are a bit too wide for the Mini body shell.The 80 mm wide MadMax tires are reinforced on the inside of the carcass with a special cross pattern in the tread section and ribs in the outside shoulder.MadMax SUPERGRIP tires are available in the following compounds: (embossed marking on the inside shoulder!)Breite:Soft:Medium:60 mm y1464/01y1464/0280 mm y1464/03y1464/04For running an rc-car on tarmac, the following recommendations apply:The dirtier the track or the colder the weather, the stickier (softer) the rear tires should be.A note for the front tires: 2WD cars should run slightly harder tires in front than in rear.On 4WD cars the same compound front and rear is usually a good choice!Of course, like in full scale motorsport it also applies to the MadMax SUPERGRIP tires that the softer the tire the higher the wear. The medium compound tire lasts significantly longer than the soft version!The MadMax SUPERGRIP has a special on-road tread. These tires have excellent grip even after eating up the tread and can be used after that for a long time as slicks!MadMax SUPERGRIP spare rubber can be found here: MadMax SUPER GRIP spare part Some off-road tires knowledge can be found here!

€119.90* €139.90* (14.3% saved)

Average rating of 0 out of 5 stars

5105 Tuned pipe system Mielke Twin-Power for Carson Wild GP Attack and HPI Baja cars black
This version is black painted The top pipe system for Carson Wild GP Attack and all HPI Baja cars 5B + SS + 2.0 + 5sc + 5T and so on! Twin-PowerBy the Tuned Pipe-Pope M. Mielke The Twin-Power system, does not only look fantastic, but also guarantees an optimum performance from 23ccm up to 30ccm! The double spring-backed, flexible connection guarantees a secure hold, even with leaps and somersaults.The Twin-Power pipe is completely integrated in the original Baja roll bar. The manifold is always black, due to the high temperatures in the immediate area of the exhaust outlet. The price includes the complete Twin-Power system/set !

€249.90*

Average rating of 0 out of 5 stars

DYNS1660 Fuze 1/6th Brushless engine 1200kv
Genuine Losi spare/option part.Dimensions:Motor length without shaft: 87,5 mmDiameter Motor: 57,8 mmDiameter of the shaft: 8 mmLength of the shaft: 27 mmContents:1 piece

€209.99*

Average rating of 0 out of 5 stars

8147 FG Rear wing BMW 320si WTCC, Samba MOCA and BMW M3 Superstars
Complete with mounting kit, side flaps and nuts & bolts. The rear wing comes unpainted (clear). Dimensions wing:Width: 280 mmDepth: 45 mmDimensions wing mounts:Height: 28 mmDimensions side flaps:Width: 50 mmHeight: 30 mmPainting tips:

€26.90*
%

Average rating of 0 out of 5 stars

y0039 Oil for shock absorber, all viscosities, 100 ml
Genuine silicone shock absorber oil for the optimal shock absorber set-up. Content: 100 ml Please note: Factory filling of FG/Losi/Smartech and many other 1/5 and 1/6 scale shocks is done with genuine silicone shock absorber oil. To ensure seal tightness and consistency you should only use genuine silicone shock absorber oil for refilling as well.Most every rc-car shock absorber uses silicone oil of different viscosities. The smaller the number, the lower the viscosity of the silicone oil and the softer the damping. As a rule of thumb: Viscosity 100 = similar to water Viscosity 1.000 = similar to cooking oil Viscosity 5.000 = similar to shampoo Viscosity 10.000 = similar to honey As a reference: The red FG Marder / Off-Road Buggy series shock absorbers are factory filled with 2.000 viscosity oil, the shocks on monster cars with dual shock set-ups (total of 8 shocks) are filled with 1.000 viscosity oil, and the shocks on FG onroad cars come filled with 4.000 viscosity oil. The original filling of the Losi 5ive-T is 350cc silicone oil.FG Silicone oil with 100 ml:FG Item N° 66295/010 = Viscosity: 100 FG Item N° 66295/025 = Viscosity: 250FG Item N° 66295/035 = Viscosity: 350FG Item N° 66295/050 = Viscosity: 500FG Item N° 66295/075 = Viscosity: 750FG Item N° 66295/100 = Viscosity: 1000FG Item N° 66295/150 = Viscosity: 1500FG Item N° 66295/200 = Viscosity: 2000FG Item N° 66295/300 = Viscosity: 3000FG Item N° 66295/400 = Viscosity: 4000FG Item N° 66295/500 = Viscosity: 5000FG Item N° 66295/600 = Viscosity: 6000FG Item N° 66295/700 = Viscosity: 7000FG Item N° 66295/800 = Viscosity: 8000FG Item N° 66295/900 = Viscosity: 9000FG Item N° 66296 = Viscosity: 10000Viscosity of silicone oil at various temperatures.

Content: 100 Milliliter (€129.00* / 1000 Milliliter)

From €12.90* €15.40* (16.23% saved)
Loading...
Upload in progress, please be patient ...
Shopware-Agency Shopware-Plugin Development