905046 Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set

€129.90*

Prices incl. VAT plus shipping costs

Available

Product number: cs_905046

EAN: 4058575011354

Product information "905046 Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set"

Item N° 905046
Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set

Low mounting alloy pipe, installs between the wheels. Comes complete with manifold and mounting hardware.
When installing this pipe on a Thunderbolt some minor modifications to the body shell are necessary to clear the manifold.

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

Display reviews in current language only.

No reviews found. Share your insights with others.

Accessories / Spare parts

y0564 RC Tech Pipe Protect 400 ml

Genuine HT spare/option part. RC Tech Pipe Protect protects your exhaust against oil and rubber deposit while racing. A clean exhaust gives better resonance, which means better performance from your engine. Thanks to RC Tech Pipe Protect your exhaust system can evacuate the temperature better.Direction of useSpray a relatively thick layer of Pipe Protect from a close distance; +/- 15/20 cm on your new or just-cleaned and preferably polished exhaust pipe. After each ride clean the exhaust pipe with a clean cloth, if necessary slightly sprayed with some Pipe Protect. Treat the exhaust pipe again before each race.Contents:1 piece / 400 ml

Content: 400 Milliliter (€24.75* / 1000 Milliliter)

€9.90*

y804 HT-flange sealer 518, 50 ml up to 200°C

Especially for installation of all engine gaskets. Temperature resistant from -55 °C to +200 °C. Resistant to water, mineral oils, synthetic lubricants, fuels, organic solvents and refrigerants. info: Hand tight: 10 - 20 minReady to use: 1 - 3 hoursGap fill: 0.5 mmContent: 50 ml Notes for usage: This surface seal is not for use as the sole sealant, it should always be applied in combination with a paper gasket.The HT-surface sealing agent should be sparsely applied over the entire surface, with care being taken that the sealant does not enter the devices internals (e.g. crankcase, differential a.s.o.) during the assembly.

Content: 50 Milliliter (€538.00* / 1000 Milliliter)

€26.90*

Customers also viewed

20150/11 FG Body shell set Monster-Truck 2WD / 4WD

Genuine spare/option part.The Set contains the front body, the main body and the body screws.Comes unpainted without decals! Dimensions:Length: 660 mmWidth: 290 mmHeight: 195 mmWheelbase: 460 mmContents:1 piecePainting tips:

€107.90*

s054320, Smartech tuning brake Gas/Hell Devil/CRT 4x4/Thunderbolt / Titan, set

Set includes 2 rotors, 4 brake pads and 4 return springs. The steel rotors will last significantly longer on the differential drive cups, wear between rotors and brake pads is reduced as well.

€49.90*

FG Sportsline 2WD-465 with Porsche GT2 body shell, 23cm³ Engine

The 2WD-465 Sportsline model is built on the short chassis with double a-arms suspension front and rear. The vehicle is equippedwith the 2-shocks front suspension as standard, which ensures optimum traction for both front wheels.On the GT2, the front axle has been widened to 384 mm. The rear axle is 395 mm wide.Technical description:The model has a 465 wheelbase. The models are built on a 4mm alloy chassis with double wishbones at front and rear axle. All borings of the alloy chassis are countersunk to prevent the screw heads from bearing out. The models are serial equipped with the 2-damper front axle which guarantees an optimal traction of both front wheels. At the front/rear axle you can adjust through track rods or adjusting screws with right-/left-handed thread the king pin angle, trailing effect and toe-in. Further equipment points are front disk brakes, differential gear, easy-running FG ball drive, alloy brake calliper with big brake disk, stabilizer bar front and rear, tuned pipe muffler, rear brace, 24T steel pinion, spark plug cap suppression cover, latest version (Evo) oil-pressure shock absorbers with volume control and external adjusting ring for the initial spring preload. All rotating parts as shafts, axles and clutch bells a.s.o. are supported by ball bearings. You can select the car with complete RTR-equipment from the options menu. RTR-equipment RTR = Ready to Run. The RTR version comes ready to use with the 2,4 GHz rc-system already installed. Transmitter 2,4 GHzReceiverHigh power servo for throttle and brakeLargescale servo for steeringTx-battery, rx-battery The models are equipped with a powerful 23ccm combustion engine. The engine needs a 2-stroke petrol oil mixture. One tank filling gives you about 45 minutes driving fun. The power is transmitted over the well-tried system: from the engine over the 2-block clutch over radial tooth wheels on to the rear axle which is equipped with the bevel differential gear with pluggable axles. RC-plate with receiver box.To complete the models all merchantable servos and radio control systems are suitable. The RTR version comes with complete factory installed rc-system, including Ni-Cads! The car comes with an unpainted body shell.The FG 5164 decor sheet is not included!Also available painted in the shop selection!Dimensions: Length: 840 mm Width: 395 mm Height: 250 mm Wheelbase: 465 mm Touring cars in action!Painting tips:

From €1,159.95*

Configure now

32777 Spur gear carrier 52 mm

Genuine Smartech spare/option part.Fits Carson/Smartech - C5 (on road).Content:1 piece

€13.90*

8180 FG Body set BMW M3 ALMS, clear 2 mm for 530/535 mm wheelbase

The Set contains the front body, the main body, the rear body, the spoiler-set and the body screws. The body shell is vac-formed from 2 mm Lexan.The set is delivered not painted. Required body mounts:Mount front: FG 7020/12 Front bumperRear body mount: FG 7152/01 Rear body mount Side body mount front: FG 7014 Body mountsSide body mount rear: FG 7014 Body mountsMeasures:Length: 890 mmWidth: 392 mmHeigth: 260 mmWheelbase: 530 mmPainting tips:

€219.95*

Details

9046/01 FG Air filter insert for flat air filter oiled - 2pcs.

Replacement foam filter element, oiled and ready for use.Fits 9043, 9044, 9045

€8.90*

32420 Roll cage part C - 2pcs.

Genuine Carson spare part.

€9.90*

905046 Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set

Product information "905046 Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set"

Item N° 905046 Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set

Login

Item N° 905046
Carson tuned pipe for Carson Gas Devil + CRT 4x4, Conrad Hell Devil, Smartech Titan - set