68401/01 FG Rear lower alloy wishbone, TW

Item N° 32486 Roll cage part D - 2pcs.Lenght: 140 mmDiameter: 10 mmThread top/buttom: M5Delivery includes: 2 pcs.

Splitted Alloy servoarm for a more protecting screw connection (with a 2,0 mm allen head screw driver) causing stiffness on the servo output shaftSuitable for all servos with an output shaft with 15 tooth spline shaft, for example:Multiplex RhinoHitec 805Savöx SV-0236MGLOSB 0886 S901T (Original Losi 5ive-T throttle Servo servo)LOSB 0884 S900S (Original Losi 5ive-T steering servo)and many more!holes for linkage with M3 threadWhen you count the teeth of your servo you can check if this alloy arm will fit to your servo. Alloy servoarms are indispensable by strong digital servos, as used on big scale models for example, to optimize the servo forces being transferred.Content:1 pieces

Splitted Alloy servoarm for a more protecting screw connection (with a 2,0 mm allen head screw driver) causing stiffness on the servo output shaftSuitable for all servos with an output shaft with 25 tooth spline shaft, for example:y2006 Digital Big-Scale Servo D-21HVNearly all Robbe/Futaba servosMega Power servoThunder Tiger DS1015Savöx servosand many more!holes for linkage with 3 mm diameterWhen you count the teeth of your servo you can check if this alloy arm will fit to your servo. Alloy servoarms are indispensable by strong digital servos, as used on big scale models for example, to optimize the servo forces being transferred.

Freaking expensive, but it is damned fine.ASONIC HQ 72-102 is a synthetic high-temperature lubricating grease, for use in limited slip differentials. Due to the careful selection of product components and the clean manufacturing environment, ASONIC HQ 72-102 is a rolling bearing grease with a particularly low noise level.Benefits for your application:High-temperature lubricating grease for rolling bearingsHigh purityLow noiseGood water resistanceContent:1 piece, tube with 30g

For ball bearings (diameter 8 x 22 mm) in steering blocks and uprights.Instructions:Remove the M5 bolt until the gap between the bolt's head and the top of the spindle is slightly more than the the width of the bearingInsert the spindle with the bolt into the bearing and srew the bolt in with an allen key from the opposite (do not tighten the bolt!)Now remove the bearing by just turning the spindle ccw

Genuine Top Tuning spare/option part. Spare part for electric conversion kit TT1021 or for your own designs.Contents:2 pieces