6731/04 FG Tallow-drop screw M3x4 mm, 15 pieces
€2.10
Available
Product information "6731/04 FG Tallow-drop screw M3x4 mm, 15 pieces"
Part is delivered in silver or black color from vendor!
Content:
- 15 pieces
Lebacher Strasse 4
66113 Saarbrücken
Germany
Login
Customers also bought
Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Content:5 pieces
Genuine TLR spare/option part.Dimensions:M2,5 x 8 mmContents:10 piecest
Genuine FG spare/option part.Contents:2 pieces
Genuine FG spare/option part.Standard carburetor for Zenoah G230/260. Carb has integrated choke.Typ: Walbro WT603B.Contents:1 piece
A nice tool to create clean circular cuts in Lexan bodies. Adjustable for diameters from 10 to 150 mm. Storage compartment with six blades.Inhalt:Circle cuttersix replacement blades
Customers also viewed
Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Content:10 pieces
Item N° 50353011Support Blocks for the Lightscale Droop Gauge front, 1 pce.This is an Alloy Support Block anodized in black colour with 30mm height.The Support Block is manufactured as a rectangle and so can used a 30mm, depending on which side you choose.The front block uses a single point of support while the rear one comes with two of those. Due to this 3 point support it is assured that even a little tweak in your chassis (none of them is 100% straight) will not affect the result of your measurement. Remove the wheels and tyres from your car and put the car onto the support blocks. Ideally the rear block is positioned to the back of car and the front one just where the servo saver is fixed to the chassis. The car is now propped on the support blocks safely and cannot bounce. Please make sure that no dirt or rubber is trapped between the Support blocks and the chassis.Now you can easily and correctly measure the droop of each axle and adjust the cars` tweak.To do so please use the Lightscale Droop Gauge (50835400)The use of Lightscales` Droop Gauge Support Blocks prevents incorrect measurements and therefore is absolutely reliable. Measurements which are done using a flat surface where the chassis is resting on, like you would use in the pits are usually incorrect due to a slightly tweaked chassis because dirt underneath the chassis will falsify the measurement and lead to a irregular setup. The use of Support Blocks which are based on 4 support points will result in the same incorrect results and downgrade the performance of your car which is why we 100% recommend the use of our support block because as racers ourselves we know all about the problems you may face.