66226 FG Turnbuckle M10/M8x84mm 4WD, 2 pcs.
€15.90
% €18.90 (15.87% saved)
Available
Product information "66226 FG Turnbuckle M10/M8x84mm 4WD, 2 pcs."
Contents:
- 2 pieces
Lebacher Strasse 4
66113 Saarbrücken
Germany
Login
Alternatives
Genuine FG spare/option part.Burnished M8/M10 steel turnbuckles.Contents:2 pieces
Customers also bought
Dimensions:Inner diameter: 2 mmOuter diameter: 4 mmContents:1 piece
Genuine Mecatech spare/option part. Replacement part for Mecatech twin piston hydraulic brake.Contents:1 piece / 50 ml
Genuine FG spare/option part. Securing ring for positioning the brake disk on 11.5, 14 and 17mm square drives.Inner diameter unstretched 19.5 mm.Part is delivered in silver or black color from vendor!Contents:4 pieces
These adjusting clips allow a faster adjustment of the wishbones. Suitable for front and rear suspension. The set contains 16 adjusting clips in 2 and 6mm size for 6 mm axles.
Genuine FG spare/option part. Necessary for 6183 and 6184.Contents:2 pieces
Genuine FG spare/option part. Contents:2 pieces
Customers also viewed
Genuine HT spare/option part.Charging cable for batteries with XT60 connector, length approx. 30 cm, silicone insulated cable with gold-plated connectors.Contents:1 piece
Genuine FG spare/option part. You can check and adjust the inclination of front and rear wheels with the inclination-goniometer. In connection with the measuring bench you can also check toe-in of the rear axle. Suitable for all FG models and also other makes scale 1:8-1:5.Delivery content is only the inclination - goniometer.Contents:1 piece
Genuine FG spare/option part. The advantage of a one-way clutch over conventional or limited slip differentials is the combination of maximum propulsion and outstanding agility in the turns. This results in a 4WD vehicle with the quick turning-in of a 2WD while retaining the advantages of 4WD traction when accelerating out of corners.This applies to offroad and street cars alike.The inner races in the one-way clutch feature the internal spline drive to accept FG differential shafts. They are made of high strength steel, hardened and ground to very close tolerances. Combined with the large one-way clutches, this guarantees the transfer of the high maximum torque.Installation is pretty easy; the one-way clutch unit replaces the bevel gears in the diff including the satellite gear shaft and is inserted as a single piece into the differential case. You just have to take care that the side where the writing on the clutch can be seen goes to the left hand side (in the direction of travel).Fits FG-plastic differential case and HT- or FG-aluminum cases for non-self-locking differential versions.For vehicles not equipped with in-wheel brakes it should be noted that there will be no more braking action in front from the layshaft brake when running the one-way clutch as a front differentialOnly for 4WD models. Suitable for all differential housings except viscous and Powerlock diff.Contents:1 piece
Genuine FG spare/option part.Burnished M8/M10 steel turnbuckles.Contents:2 pieces
To mount the rear upper alloy wishbones short 1074/5 and the short alloy upright extension on the EVO chassis the 54 mm camber rods are needed.
Genuine FG spare/option part.steel version, 40 mm. Fits all FG except Formula 1.Contents:2 pieces