y1445/02 MadMax Maxi Pin tyres on HPI Super Star rims 24mm hex, 1 pair

Mammoth Supergrip onroad 60 and 80 mm tires on white FG rims complete glued, 1 pair.Mammoth Supergrip onroad tires on FG rims for 1/6 and 1/5 offroad cars.Suitable for asphalt surfaces such as car parks and race tracks.   Racing tyres for your off-road model.VersionWidthOuter diameterFront64 mm153 mmRear78 mm153 mmGlued on genuine FG rims (rear tires using extension rings outside ), with foam rubber inserts included. Rim has 18 mm square drive with reinforcement ring.Please note: based on experience we recommend against using other manufacturers rims and extensions. Since the Mammoth tires provide very good grip the rim and the bonding must withstand high loads. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.The Mammoth Supergrip is available in in the following compounds: Super softSoftMediumHardFront tirey0581y0582y0583y0584Rear tirey0591y0592y0593y0594General recommendation:The dirtier the track or the lower the ambient temperatures, the stickier (softer) the rear tires should be.Hint regarding the front tires: 2WD cars should use them one or two grades harder then the rears. 4WD cars usually like the same compound all around.Of course, the softer the tire the higher the wear rate; and this applies to Mammoth Supergrip onroad tires as well.The tires have a special onroad thread pattern but will still provide ideal traction after the pattern has been worn out. The white lettering on the tires has been applied for presentation purpose only. The tires will be delivered with black sidewall.Prices per unit: FrontRearMammoth Supergrip:Pair44,90 EUR49,90 EURTire inserts:Pair13,00 EUR13,00 EURFG rim:Pair14,90 EUR14,90 EURFG extension ring:Pair--.-- EUR14,90 EURMounting:Pair13,00 EUR13,00 EURPrices Total                                                                                          85,80 EUR    105,70 EUR

Can be used as reinforcement for genuine HPI and Losi rims as well.Set includes:Two pieces of reinforced outside ringsTwo pieces of reinforced inside ringsand 40 pieces of 3 mm allen head screws (for 2,5 mm allen wrench)Colours:y1418/02 - Bluey1418/03 - Redy1418/05 - Yellow

See photos for scope of delivery.  1 pair of new tyres 80 mm with fine tread for solid ground and roads.  The rims have a 24 mm hexagon mount, suitable for HPI Baja 5B, Losi and Carson Wild GP Attack.

MadMax MAXI PIN tyres have been specially developed for carpet race tracks!  The special block tread pattern, with 480 knobs per tyre, provides excellent grip, but also puts extreme strain on the tyre and the rim. The 3-piece Super Star rims from HPI ensure that the tyre fits perfectly on the rim. This means that no adhesive is required to fix the tyre in place and the rim can be used again and again with new tyres. To stabilise the tyre, the outside of the tyre shoulder is equipped with vertical ribbing on the side, which minimises tilting under load and counteracts the shear forces that occur in bends. Furthermore, the MAXI PIN tyres have knobs positioned on the side of the outer side, which particularly support the steering behaviour of your RC car in bends. Taken together, the MAXI PIN tyres provide maximum grip. The set comes with inserts and orange rim rings, including screws.  On request, we can fit the tyres for an additional charge; see the options above.  Dimensions tyres :  - Outer diameter: 185 mm  - Tyre width at the outer edge of the tread: 75 mm Dimensions rims :- Outer diameter: 120 mm- with: 60 mm 2 pair 

CROSS BOND 170 x 60 mm tires mit MadMax Extreme 20 bolt-beadlock rims with 18 mm wheel square and reinforced beadlock rings were designed for use on loose surfaces. The extremely rigid and differently structured lugs of the CROSS BOND ensure optimum power transmission and also allow for excellent grip on loose surfaces, such as sand and soil. The lugs are raised at the treads outside, and therefore provide maximum grip, particularly when cornering where the tire is canted to the outside. Due to the extreme load created by the MadMax CROSS BOND tires the rim was optimized again with a reinforcement ring.The tires are fitted with a special rigid insert, which can handle the cornering forces and maintain the tires shape even on heavy cars. We recommend to check the beadlock screws after the run. Dimensions:Outer diameter: 170 mmFront tire width: 60 mmReinforced 18 mm square wheel driveThe video shows the 18 mm square drive version. Also available with 24 mm hex. Some off-road tires knowledge can be found here!