305143 Countersunk screw M4x25mm - 5pcs.
€2.90
Available
Product information "305143 Countersunk screw M4x25mm - 5pcs."
Login
Customers also bought
Genuine HT spare/option part.Wheel squares made of high-strength aluminum, hardened, with two M6 mounting threads Suitable for most 1/6 and 1/5 rc-cars. Through the use of two 6 mm screws a significantly higher retention force is achieved. Yet it is still recommended to use medium strength thread lock (link y0114)! The hard anodizing (HART-COAT) guarantees much lower wear of the squares! Especially recommended when using wheel mounted brake discs! Four 3x16 dowel pins per square are included which prevent the squares from spinning in the rim. Press fitting them into the wheel squares is optional. The 12, 14 and 17 mm wide squares feature a groove for inserting a C-clip (link 6106/05), which acts as a guide for the brake disk. The narrow 9.5 mm wide squares dont need a clip; the close sitting rim will guide the disk. Measures18 mm square (wheel drive!)17 mm wide, 8.0 mm diameter axle boretwo M6 mounting threads The set includes 2 pieces of 17 mm wide wheel squares and 4 pieces each of M6 grub screws and 3x16 dowel pins.Contents:2 pieces
Fits for FG Evolution / Competition with the new 09 short chassis.
Genuine FG spare/option part.Counternut for track rod, 3,8 mm thick.Part is delivered in silver or black color from vendor!Contents:2 pieces
Genuine FG spare/option part.Counter nut for track rod, 3,8 mm thick.Part is delivered in silver or black color from vendor!Contents:2 pieces
Genuine FG spare/option part.Self locking wheel nuts with serrated base.Part is delivered in silver or black color from vendor!Contents:10 pieces
Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Content:10 pieces
Genuine FG spare/option part.Part is delivered in silver or black color from vendor!Content:10 pieces
Customers also viewed
For ball bearings (diameter 8 x 22 mm) in steering blocks and uprights.Instructions:Remove the M5 bolt until the gap between the bolt's head and the top of the spindle is slightly more than the the width of the bearingInsert the spindle with the bolt into the bearing and srew the bolt in with an allen key from the opposite (do not tighten the bolt!)Now remove the bearing by just turning the spindle ccw
Genuine HT spare/option part. A must-have for 1/5 on-road racing! Even though it looks funny at first sight for uninitiated people! ;-) Just like in full-size racing our tires need a certain temperature to provide the necessary grip that is needed to achieve good lap times. Usually this means that the car will get really fast times only after a few laps. The driver who uses preheated tires has a considerably advantage. With cold outside temperatures or low grip tracks, like a not so clean parking lot, it often not possible at all to bring the tire temperature up to the required range just by driving. As a result the car will be difficult to control! Measures:maximum outer diameter of 130 mm maximum tire width of 80 mmThat includes all standard 1/5 touring car tires! ( ) Instructions: The tire warmers may be operated only on 12 to 13.8 volts AC or DC. In order to reach optimum operating temperature, a power supply with a 12 - 13.8 volts AC or DC and at least 10 amps output power should be used. The T2m Powerbase y1352 is the perfect solution for this application. The operation of the tire warmers directly from a 12 volt car battery (without Powerbase) is also possible, of course. In order to prevent damaging the filament inside the blanket, they must not be bent and not used without tires!Contents:1 set