LOS252126 Drive Pin Rebuild Set DBXL-E 2.0
€9.99
Currently unavailable
Product information "LOS252126 Drive Pin Rebuild Set DBXL-E 2.0"
Login
Customers also bought
Genuine FG spare/option part. Zenoah bolts 7318 are required for installation.Content:2 pieces
Genuine HT spare/option part. Hardened pins made of 100Cr6 steel for driveshafts, differentials, wheel drives and similar applications. Pack of ten. Sizes available:y1345/01: 4 x 18 mm, e.g. for Losi 5ive-T/Mini and HPI Baja differentials or HPI Baja layshafty1345/02: 4 x 20 mm, e.g. for Losi 5ive-T/Mini CVD jointsy1345/03: 4 x 24 mm, e.g. for Losi DBXL and HPI Baja wheel hexy1345/04: 5 x 24 mm, e.g. for Losi 5ive-T/Mini wheel hexContents:10 pieces
Genuine Losi spare/option part. Contents:10 pieces
Genuine Losi spare/option part.Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:1 set
Customers also viewed
Genuine Losi spare/option part. Contents:1 pair / 2 pieces
Genuine Losi spare/option part. Contents:1 piece
Genuine Top Tuning spare/option part.Lens for the Losi DBXL-E, 5ive-T 2.0 front light bar. It protects the LED strip against dirt.The lens replaces the black stock frame.When using on the 5ive-T 2.0 light bar, please note that the support spacers of the lens must be cut off (only a pair of scissors is required). Contents:1 piece
Genuine HT spare/option part. Hardened pins made of 100Cr6 steel for driveshafts, differentials, wheel drives and similar applications. Pack of ten. Sizes available:y1345/01: 4 x 18 mm, e.g. for Losi 5ive-T/Mini and HPI Baja differentials or HPI Baja layshafty1345/02: 4 x 20 mm, e.g. for Losi 5ive-T/Mini CVD jointsy1345/03: 4 x 24 mm, e.g. for Losi DBXL and HPI Baja wheel hexy1345/04: 5 x 24 mm, e.g. for Losi 5ive-T/Mini wheel hexContents:10 pieces
Genuine Losi spare/option part. Contents:2 pieces
Genuine Losi spare/option part.