LOS252053 Losi Dogbone, Center MTXL
€34.99
Currently unavailable
Product information "LOS252053 Losi Dogbone, Center MTXL"
Contents:
- 2 pieces
Login
Customers also viewed
Original Smartech Ersatz-/Tuningteil.Dimensions:Diameter: 6 mmBall diameter: 9,8 mmTotal length: 206 mmInhalt:2 Stück
DYNB501 Dynamite Reaktion Lipo Receiver Pack 4000mAh 2S 7,4V 15C with EC3 and Universal electric wire.Specifications:Cells: 2SCapacity: 4000 mAhVoltage: 7.4 VLength: 105 mmWidth: 34 mmHeight: 27 mmWeight: approx. 190 gramsBalance connection: XPH (XH) Warning:- Use only under direct supervision of adults- Charge only in a suitable charging bag / protective bag- Do not store battery discharged (at least 50% charge is recommended)
Genuine Losi spare/option part. Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:1 piece