LOS252050 Losi Wheel Hex Black with Pin MTXL

€39.99*

Prices incl. VAT plus shipping costs

Available

Product number: losi_los252050

EAN: 605482624968

Product information "LOS252050 Losi Wheel Hex Black with Pin MTXL"

Genuine Losi spare/option part.

Contents:

4 pieces

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

Display reviews in current language only.

No reviews found. Share your insights with others.

Alternatives

DBXL024 ATOP Aluminum axle extenders all Losi DBXL / DBXL-E / 2.0 / MTXL, with closed nuts

Genuine ATOP spare/option part.CNC-machined from 6061-T6 aluminum by ATOP RC.Increases track width by 25 mm. Fits all versions of DBXL / DBXL-E / 2.0 (brushless and gas) and MTXL. 2 mm O-rings protect against drive pin loss.Set of four including O-rings, drive pins and closed wheel nuts (wrench size 24 mm!).Contents:1 set

€64.90*

Details

Similar products

LOS252067 Losi Diff Rebuild Kit, Al Diff Housing, DBXL-E

Genuine Losi spare/option part. Contents:1 set

€29.99*

Details

LOS252120 Losi Axle Boot Set 5mm Drive Pins DBXL-E 2.0

Genuine Losi spare/option part. Contents:10 pieces

€29.99*

LOS254006 Losi Suspension Arm Set Losi DBXL/DBXL-E/DBXL 2.0 1/5 4WD

Genuine Losi spare/option part. Content:4 pieces

€59.99*

LOS254010 Losi Hinge Pin, Set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:1 set

€19.99*

LOS252020 Universal Rebuild Kit (2): 1:5 4wd DBXL+MTXL

Genuine Losi spare/option part.Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:1 set

€11.99*