Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

EL010 FID-Racing gilmer belt pulley, small

Product information "EL010 FID-Racing gilmer belt pulley, small"

Genuine FID Racing spare/option part.

Replacement part for FID-Racing electric starter with the order number: FID046

Fits pre-November 2014 version (motor with longer shaft).
The current version is press-fitted to the motor shaft and not available separately.

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Alternatives

Average rating of 0 out of 5 stars

EL017/01 FID-Racing starter motor
Genuine FID Racing spare/option part.Replacement part for FID-Racing electric starter with the order number: FID046Contents:1 piece

€69.90*

Customers also viewed

Average rating of 0 out of 5 stars

50144 Friction pads for 2-shoe clutch, 2 pcs.
Replacement part for the Lauterbacher 2-shoe clutchAttention: You must use adhesive y0743 Clutch-Safe when replacing clutch pads!

€14.43*

Average rating of 0 out of 5 stars

EL010/01 FID-Racing gilmer belt pulley, small
Genuine FID Racing spare/option part.Replacement part for FID-Racing electric starter with the order number: FID046Fits pre-November 2014 version (motor with longer shaft).

€19.90*

Average rating of 0 out of 5 stars

TT0990 Top Tuning Failsafe with kill switch and status LED for all transmitters
Genuine TT spare/option part.The new and improved failsafe modul.This kill switch module works with most FM and 2.4 GHz rc-systems. Not compatible with AVC-equipped receivers! You must have a free channel on your rc-system in order to install the module! This means at least a 3-channel radio for standard 1-servo brake/throttle setups or a 4-channel radio for dual brake servos driven by the radio's mixer function. With this module you can stop the engine with your radio. Additionally the module features a failsafe function which stops the engine when the rx-battery's voltage drops below a certain level or the rc-system has a glitch. A kill switch module fulfils two tasks. On the one hand, as a safety device, it is intended to shut off an engine with magneto ignition in case of failure of the remote control, and on the other hand, the engine can be stopped at any time by remote control.While the latter is mainly used for convenience, the safety aspect is what really matters.The failsave circuit integrated in all modern remote controls may brake the vehicle in the event of a radio interference, but this feature is dependent on the basic functionality of the receiver system and its power supply. However, if the receiver, the gas servo or the power supply fails completely, the failsave of the remote control can no longer do its job. The vehicle may be running haywire at full throttle.In these cases, the kill switch will cut the ignition of the engine and the vehicle will roll out without power.Features:Ready to install no soldering requiredRemote LED for easy-to-spot operational status (ignition live/killed)Optically coupled to isolate the ignition from the radio systemThreshold value for undervoltage protection (4V, 5V, 6V) adjustable with jumpers allows adaptation to the rx-battery type (LiPo, LiFePo, NiMH, NiCd)Contents:1 piece

€37.90*
Loading...
Upload in progress, please be patient ...
Shopware-Plugin Development Shopware-Plugin Development