8538 FG mounting device

Genuine FG spare/option part.Auxiliary tool to mount and dismount the ball-type nipples 4466, a jaming is impossible. The use is only in connection with the FG mounting device 8538 possible.

For ball bearings (diameter 8 x 22 mm) in steering blocks and uprights.Instructions:Remove the M5 bolt until the gap between the bolt's head and the top of the spindle is slightly more than the the width of the bearingInsert the spindle with the bolt into the bearing and srew the bolt in with an allen key from the opposite (do not tighten the bolt!)Now remove the bearing by just turning the spindle ccw

Original FG tool  For pressing the ball joints into and out of the plastic ball sockets.  1 piece

Key FeaturesContains most every tool needed in order to maintain a vehiclePackaged in a zippered tool pouchCompact, complete and affordableFits ASC 1/18th scale vehicles and Losi 1/8th and 1/10th scale vehicles (excluding the Losi LST platform which uses a mix of US and metric fasteners)OverviewDynamite’s startup tool sets come in either metric or US sizes and are packaged in a convenient zipper pouch providing users with the ultimate in utility and flexibility. Containing almost every tool needed in order to maintain a vehicle these tool sets are the perfect add on for users looking for an easy and affordable tool set for their RC collection.Compatible with the following brands:ARRMA, Axial, Traxxas, Kyosho, Ofna, Tamiya, HPI, Hot Bodies, Mugen, CEN, GS Racing, Associated, and Losi minis.Includes:NUT DRIVERS- 4, 5, 5.5, 7, & 8mmHEX DRIVERS- 1.5, 2, 2.5, 3, 3.5 & 4mmPHILLIPS- #0, #00 & #1FLATBLADE- #2, #3 & #4BOX WRENCH- 3, 4, 5.5, 6mm

The Lightscale Camber Gauge is a black anodised alloy block that features 8  different angled planes in 0.5° steps from 0.5° to 4° on different surfaces.
The gauge is to be layed down beside a tyre for negative camber angles and any 90° part is put on one of the planes an pulled towards the tyre. Doing so you can easily check the camber of your tyres. To check positive camber, just turn around the gauge.
Turning the gauge upside down will make it a 10mm high block to support you measuring the droop of any 1/5, 1/6 and 1/10 scale Electric or nitro car. Those are usually put on 10mm support blocks and beeing measured their droop with a special tool. The Lightscale ride height gauge (50160200) is a droop gauge as well and will do the job for you.

Servosaver blocking pin to block the servosaver in a middle position for a accurately setup of the front suspension.Fits on FG EVO Touring Cars 06, 07, 08 and Competition 07.