7102/05 FG Front wishbone pin hardened 6x87mm
Product information "7102/05 FG Front wishbone pin hardened 6x87mm"
Genuine FG spare/option part.
Precision wishbone pin hardened and grounded, extremly solid. Not suitable for Formula 1. Suitable for all 1:5 models and Trucks for the front wishbone.
Contents:
Precision wishbone pin hardened and grounded, extremly solid. Not suitable for Formula 1. Suitable for all 1:5 models and Trucks for the front wishbone.
Contents:
- 2 pieces
Login
Kunden haben auch gesehen
Kunden haben auch gesehen
Genuine FG spare/option part.Suitable for all FG Monster models with twin shock setup. Four mm wire diameter, links with 12 mm hole spacing.Fit not for FG 4WD Models.Contents:1 piece
Genuine GPM spare/option part. Use a high strength two-component adhesive (e.g. Clutch-Safe) to glue in the pads and lock them with the countersunk screws M3x5 (part no. y0730/03)Part no. 02 for GPM Big-Scale clutch.For replacing the friction pads please proceed as follows:1. Remove clutch from engine2. Disassemble clutch3. Remove the screws fixing the friction pads4. Remove remains of old glue and clean the surface to be bonded of the shoes to bare metal 5. Thoroughly degrease the bonding area of clutch shoes and new pads6. You must use the special adhesive y0743 Clutch-Safe!7. Apply a sufficient and complete layer of the adhesive to the bonding surfaces8. Insert the lining into the clutch shoe and align9. Fix the pad in place with screw y0730/03, just hand-tighten it10. Remove excessive glue with a rag11. Preheat oven to 120 °C.12. Put the clutch shoes into the preheated oven for exactly one hour; let the parts cool down13. Reassemble clutch and install it onto the engine14. Wait at least one hour after the gluing process before using the clutchy0730y0731Content:3 pieces
Suitable for the 1:6 models Marder, Beetle On-/Off-Road, Pajero and Monster.3 mm wire diameter, links with 12 and 29 mm hole spacing.Fit not for FG 4WD Models. 4wd Stabilizer you find here:6626066261
The Set contains the front body, the main body, the rear body, the spoiler-set and the body screws. The body shell is vac-formed from 2 mm Lexan.The body shell does not come with drilled mounting holes to make it possible to fit any 1/5 car with 530/535 mm wheelbase. The set is delivered as shown.Required body mounts:Mount front: FG 7020/12 Front bumperRear body mount: FG 7152/01 Rear body mount Side body mount front: FG 7014 Body mountsSide body mount rear: FG 7014 Body mountsMeasures:Length: 890 mmWidth: 392 mmHeigth: 260 mmWheelbase: 530 mm