Skip to main content
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

6267 FG Battery holder - set

Product information "6267 FG Battery holder - set"

Battery holder and pedestals for installation on chassis plates.
Bracket
Length 157 mm
Width 24 mm
Distance between mounting holes 140 mm
Pedestals
Diameter 8 mm
Height until top of platform 65 mm
Total height 75 mm

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Customers also bought

Average rating of 0 out of 5 stars

6022/01 FG Flexible antenna with mount
Genuine FG spare/option part. FG antenna tube with mount.Tube measures:Inner diameter: 2,2 mmOutside diameter: 4 mmLength: 190 mmContents:1 piece

€7.50*
%

Average rating of 0 out of 5 stars

TT0990 Top Tuning Failsafe with kill switch and status LED for all transmitters
Genuine TT spare/option part.The new and improved failsafe modul.This kill switch module works with most FM and 2.4 GHz rc-systems. Not compatible with AVC-equipped receivers! You must have a free channel on your rc-system in order to install the module! This means at least a 3-channel radio for standard 1-servo brake/throttle setups or a 4-channel radio for dual brake servos driven by the radio's mixer function. With this module you can stop the engine with your radio. Additionally the module features a failsafe function which stops the engine when the rx-battery's voltage drops below a certain level or the rc-system has a glitch. A kill switch module fulfils two tasks. On the one hand, as a safety device, it is intended to shut off an engine with magneto ignition in case of failure of the remote control, and on the other hand, the engine can be stopped at any time by remote control.While the latter is mainly used for convenience, the safety aspect is what really matters.The failsave circuit integrated in all modern remote controls may brake the vehicle in the event of a radio interference, but this feature is dependent on the basic functionality of the receiver system and its power supply. However, if the receiver, the gas servo or the power supply fails completely, the failsave of the remote control can no longer do its job. The vehicle may be running haywire at full throttle.In these cases, the kill switch will cut the ignition of the engine and the vehicle will roll out without power.Features:Ready to install no soldering requiredRemote LED for easy-to-spot operational status (ignition live/killed)Optically coupled to isolate the ignition from the radio systemThreshold value for undervoltage protection (4V, 5V, 6V) adjustable with jumpers allows adaptation to the rx-battery type (LiPo, LiFePo, NiMH, NiCd)Contents:1 piece

€34.90* €42.90* (18.65% saved)

Average rating of 0 out of 5 stars

7088/01 FG Oil seal
Genuine FG spare/option part. Content:4 pieces

€9.90*

Average rating of 0 out of 5 stars

8461 FG Brake lever and servo rods - 2pcs.
Spare part for , , , , , , , , , , and .

€6.10*

Average rating of 0 out of 5 stars

y1101 Servo horn mounting screws, 10 pcs
y1101 Application: y1101/02 Hitec / MPX RHINO, M2.5x10
Item N° y1101 Servo horn mounting screws, 10 pcsReplacement screws for mounting the servo horn on the servo shaft.Part is delivered in silver or black color from vendor!Choises:y1101/01Fit:Multiplex Jumbo and Power MCFG 6598 Savöx-Servo SC-0251MGFG 6599 Savöx-Servo SC-1256TG Measures: M3 x 8 mmy1101/02Fit:Multiplex RhinoHitec 805 MGHitec 9805 MGFutaba S3152 Measures: M2,5 x 10 mm Torxy1101/03Fit:Futaba und Robbe diverse ServosPlease check the required dimensions! Measures: M2,5 x 6 mm Torxy1101/04Fit:402115 Mega Power-Servo, metal gears Measures: M3 x 10 mm y1101/05Fit:Ace DS1015 Super Torque Digital Servo, y1051 Measures: M3 x 10 mm

€2.00*

Average rating of 0 out of 5 stars

Alloy servoarms, for 25 teeth multi-tooth shaft
y0700_alle Version: y0700 Double sided alloy servoarm+ 2EUR
y0700 Double sided alloy servoarm: 9,90 EURy0700/01 Single-sided alloy servoarm: 7,90 EURy0701 Double sided split alloy servoarm: 14,90 EURy0701/01 Single-sided split alloy servoarm: 12,90 EURFor y0700, y0700/01, y0701 and y0701/01:Splitted Alloy servoarm for a more protecting screw connection (with a 2,0 mm allen head screw driver) causing stiffness on the servo output shaft Suitable for all servos with an output shaft with 25 teeth multi-tooth shaft, for example:y2006 Digital Big-Scale Servo D-21HVy2007 Digital large scale Brushless Servo CYS9130Nearly all Ribbe/Futaba servosMega Power servoThunder Tiger DS1015And many more!holes for linkage with M3 threadWhen you count the teeth of your servo you can check if this alloy arm will fit to your servo. Alloy servoarm are indispensable by strong digital servos, as used on big scale models for example, to optimize the servo forces being transferred.

Variants from €9.90*
€11.90*

Similar products

Average rating of 0 out of 5 stars

6350/01 FG Rubber gaskets.
Genuine FG spare/option part.Suitable for FG 6350.Contents:2 pieces

€4.70*

Average rating of 0 out of 5 stars

6350 FG Fuel tube - 1pce.
Fits Zenoah Tank 7348ID 3 mm x L 470 mm

€9.70*

Average rating of 0 out of 5 stars

6268 FG Battery holder - 1pce.

€13.90*

Average rating of 0 out of 5 stars

6402/01 FG Exhaust hose
Genuine FG spare/option part. Heavy gauge teflon tube for connection between exhaust manifold and tuned pipe with da inside diameter from 21 mm and a length from 50 mm.You may have to heat the tube with a cigarette lighter for installation.Contents:1 piece

Content: 5 Zentimeter (€244.00* / 100 Zentimeter)

€12.20*

Average rating of 0 out of 5 stars

6349 FG In-tank fuel filter, 1 pce.
Clunk felt filter, protects the carb against debris in the fuel.

€13.10*

Average rating of 0 out of 5 stars

6403 FG Spring band clamps 24 mm
Genuine FG spare/option part. Recommended accessory for installation of tuned pipes using teflon tube connectors. Contrary to standard hose clamps this version is self-readjusting down until 20 mm inner diameter!Width 12 mm.Content:2 pieces

€6.90*

Average rating of 0 out of 5 stars

6407/05 FG Mini pin M / OR tires, glued, white, 2 pcs.
Item N° 06407/05 Mini pin M / OR tires, glued, white, 2 pcs.Spare part for the Leopard 2010 2WD/4WD versionThe new FG Mini Pin tires are designed for harder grounds. They grant the model a lot of stability and tremendous grip in curves. 153 mm diameter64 mm wideThe version M is suitable for cooler temperatures lower than 20°, die version H is for temperatures over 20°. The tires are glued ready to run on the widened 1:6 wheels.These wheels are suitable for the FG Marder, Beetle, Off-Road Buggy and the monster models. Due to the high torque load on the bonding of tires on largescale cars, checking the bonding from time to time and re-glueing (y0067) if necessary is unavoidable.

€59.95*

Average rating of 0 out of 5 stars

6299/04 FG Fabric tube Ø24 x 23 f. 06299, 1pce.
Item N° 06299/04 Fabric tube Ø24 x 23 f. 06299, 1pce.Spare part for:

€9.50*

Average rating of 0 out of 5 stars

6299 FG Steel-Power 1:6 Tuning pipe FG 2WD and 4WD Off-Road
Genuine FG spare/option part. Newly developed tuned pipe made of strong steel sheet, with plug connecting system. The pipe mounts close to the car for best protection possible and versatile usability. Suitable for:FG 2WD and 4WD 1:6 Off-RoadSmartech 2WD off-road And for many other brand's 1/6 carsNot suitable for:FG Leopard2 2+4 WD Sportsline and CompetitionOn several pictures the pipe is shown with a silicone tube tailpipe extension, which is not included. It can be ordered separately as an accessory with part number 6299/03 or y0995.Content:1 piece

€249.95*

Average rating of 0 out of 5 stars

6423 FG Gear protector for 42/44/46/48 T spur gears
Genuine FG spare/option part. Gearwheel protection in transparent polycarbonate for all 1:6 Off-Road, Monster-Beetle, Big-Foot and Truck models with the gearwheels 43, 44, 46, 48 teeth. Protects the driving gearwheels almost from dirt, sand and stones. We recommend the mounting when driving on car parks and Off-Road ground. Not suitable for Formel 1, Leopard 2 + 4 Competition, Competition and Competition Evolution models.Contents:1 piece

€39.90*

Average rating of 0 out of 5 stars

6422/01 FG Plastic gearwheel 44 teeth 2-speed - 1pce.
44 teeth plastic main gear for the layshaft with 2-speed gear.Diameter 69 mmWidth 15.5 mmTooth width 12 mmModule: m=1,5

€17.90*

Average rating of 0 out of 5 stars

6299/05 FG Extension spring f. 06299/01, 3pcs.
Item N° 06299/05 Extension spring f. 06299/01, 3pcs.

€13.90*

Customers also viewed

Average rating of 0 out of 5 stars

6268 FG Battery holder - 1pce.

€13.90*

Average rating of 0 out of 5 stars

6350 FG Fuel tube - 1pce.
Fits Zenoah Tank 7348ID 3 mm x L 470 mm

€9.70*

Average rating of 0 out of 5 stars

6118 FG Radio plate 04 for 1:6 models
Genuine FG spare/option part. Radio plate with a new design. Suitable for all FG 1:6 Off-Road models except Leopard. This set includes the battery mount.Contents:1 set

€23.90*

Average rating of 0 out of 5 stars

6118/08 FG Aluminum battery mount 80mm - 1 pce
Length 96 mmWidth 20 mmThickness 2 mmBore 8.2 mm, spaced 80 mm

€4.80*
Loading...
Upload in progress, please be patient ...
Shopware-Theme Development Shopware-Agency