y0081 Spark plug cap shield
€14.90
Available
Product information "y0081 Spark plug cap shield"
Spark plug cap shield, the 2-piece shield will be but around the stock spark plug cap and crimped together. Very effective, solves all ignition related radio problems!
Fits Zenoah G230/240/260/270/290/320 and Chung Yang, Losi, HPI engines; for Smartech/Carson PT engines the cylinder shroud has to be modified slightly.
Content:
- 1 piece
Login
Customers also viewed
Genuine HT spare/option part.Affectionately custom-made hand-sewn overalls suitable for the H.A.R.M Kart RK-1. It is tailor-made and can be exchanged directly against the stock overalls.Available in three different color combinations: y1496/01 - yellowy1496 / 02 - blue y1496 / 03 - red Contents:1 piece
The spark plug tester wiil be put in line between the spark plug in the engine and the spark plug cap. When the spark plug is in good working order, pulling the recoil starter will produce a spark easily visible in the clear section of the tester (see video!).
Genuine Losi spare/option part. Contents:12 pieces
This reed valve system converts a normal piston-port engine into a reed valve engine. It offers the advantage of increased intake duration for a better charge for more power. As a positive side effect no fresh gas loss occurs during the downward movement of the piston because the membranes close this path.The reed valve block replaces the usual stock insulator. To use the advantage of the reed system, it is necessary to modify the piston skirt on the intake side. Depending on the engine it is advantageous for best results, to slightly match the cylinders intake port to the Epoxy insulator plate at the bottom of the reed valve system. Both steps are described in the installation instructions for Zenoah and Chung Yang engines. Our thanks for these instructions go to our customer Thomas Hoenicke.Note: For the time being the epoxy insulator plate must be slightly reworked to fit a G320 Zenoah engine. The manual has been written with the conversion of a G320, the affected area for modification is therefore shown.The unit is 24.5 mm high.