926 products found for "losi_los257001"

rc-car-online - Home

LOS257001 Losi DBXL+MTXL 1:5 4WD Bearing, 10x22x6 mm

Genuine Losi spare/option part. Contents:4 pieces

€16.99*

Details

LOS257006 Losi Ball Bearing 10 x 19 x 5mm

Genuine Losi spare/option part. Contents:2 pieces

€8.99*

LOS257005 Ball Bearing 15 x 24 x 5 mm 6IX

Genuine Losi spare/option part.Content:2 Stück

€15.99*

LOS257007 Losi Sealed Ball Bearing 4 x 8 x 3 mm

Genuine Losi spare/option part. Contents:4 pieces

€19.99*

LOS255001 Losi Cap Head Screw Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. 5 screws each of the following sizes: M3x22 / M5x14 / M5x30 / M5x35 / M5x48 / M6x30Part is delivered in silver or black color from vendor!

€9.99*

LOS256001 Washer/Shim, Set Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Part is delivered in silver or black color from vendor!Contents:1 set

€7.99*

LOS251001 LOSI MINI WRC Right Cage Side

Genuine Losi spare/option part. Contents:1 piece

€28.99*

LOS257003 Ball Bearing 8 x 16 x 5 mm 6IX

Genuine Losi spare/option part.Content:2 Stück

€15.99*

LOS257002 Bushing, 10x7x4 mm, Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part.

€8.99*

LOS257004 Ball Bearing 10 x 19 x 5 mm 6IX

Genuine Losi spare/option part.Content:2 Stück

€15.99*

LOS257000 Losi Bearing, 8x19x6 mm, Losi DBXL+MTXL 1/5 4WD

Genuine Losi spare/option part. Contents:4 pieces

€16.99*

LOS257009 Losi 10x22x6mm Rubber Sealed Ball Bearing

Genuine FG spare/option part. Contents:4 pieces

€19.99*

LOS252001 Driveshaft & Axle Dogbone Losi DBXL 1/5 4WD

Genuine Losi spare/option part. Replacing the pins on DBXL drive shafts LOS252001, LOS252021, LOS252019: Remove set screw completelyOpen bench vise until the pin just fits between the jaws Position shaft on vice, held by a second person if necessaryDrive pin out with light hammer blows using a pin punch or a suitable comparable tool If Loctite was excessively used in the assembly, heating the shaft end may be required. Depending on the thread locking compound, you will strive for a value of 200 - 300°C. The shaft end must not be annealed! An annealed pin will mushroom on impact and make it very difficult to drive it out if not impossible. When installing the new pin from set LOS252020 make sure that the flat section of the pin is positioned under the set screw. The set screw should be just slightly tightened against the pin using high strength thread locker (link). Firm tightening puts the pin under preload and increases the risk of breakage!Contents:2 pieces

€39.99*