Skip to main content Skip to search Skip to main navigation
EXTRA 20% off Outlet*. Use Code: EXTRA20 at checkout!!
+49 2151 820200 Mon-Fri 9 am - 6 pm, Sa 9 am - 1 pm

s23022, Spark plug wrench PT 23/28, 1 pce.

Product information "s23022, Spark plug wrench PT 23/28, 1 pce."

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Customers also bought

Average rating of 0 out of 5 stars

y0813 Motul 800 Racing Oil
Fully synthetic oil, available in three blends. 1-liter bottle.The optimal 2-stroke oil for 23-30 cm³ engines/cars Motul Racing Oil is available in three different blends: On-Road for high revving onroad cars Off-Road for cars with high torque enginesMixing ratio for 1/5 & 1/6 applications: We recommend a mix with about 4% oil, which means 200 cc of oil to 5 litres of gas (1:25 ratio). With one litre of Motul oil you can mix about 25 litres of optimal fuel for your 1/5 or 1/6 car. That's enough for well over 20 hours of driving fun! Oil / Gas Oil percent Oil per 1 liter of gasoline Oil per 2 liter of gasoline Oil per 3 liter of gasoline Oil per 4 liter of gasoline Oil per 5 liter of gasoline 1:20 5% 50 ml 100 ml 150 ml 200 ml 250 ml 1:25 4% 40 ml 80 ml 120 ml 160 ml 200 ml 1:30 3,33% 33 ml 67 ml 100 ml 134 ml 167 ml 1:33 3% 30 ml 60 ml 90 ml 120 ml 150 ml 1:35 2,86% 29 ml 58 ml 86 ml 115 ml 143 ml 1:40 2,5% 25 ml 50 ml 75 ml 100 ml 125 ml 1:50 2% 20 ml 40 ml 60 ml 80 ml 100 ml

From €24.00*

Average rating of 0 out of 5 stars

y1478 pump for re-fueling and de-fueling
The pump will fill and empty the fuel tank within seconds.The pump has a vent valve to avoid overpressure. Do not store gasoline for longer than 60 minutes in the gun.Occasionally lubricate the rubber seal of the piston with some grease. To do this, the handle-side cap of the cylinder can be unscrewed and the pump can be disassembled.The clear hose has been blackened in the picture for presentation purpose only.Color: blue.Filling capacity:500 mlContent:1 piece

€19.90*

Average rating of 0 out of 5 stars

69265 FG plastic-wishbone front bottom 2WD/4WD, 530, 2 pcs.
Item-No. 69265plastic-wishbone front bottom 2WD/4WD, 530, 2 pcs.Original plastic-wishbone, front bottom.For older 2WD models that are not based on the 4WD models, please refer to Sportsline 2008. or if an RC plate is no longer fitted, check Sportsline 13 in Parts Scout.There you will find the right spare parts for your vehicle.

€25.90*

Average rating of 0 out of 5 stars

69225 FG A-arm, rear upper 2WD/4WD, plastic ,530, 2 pcs.
Item N° 69225 A-arm, rear upper 2WD/4WD, plastic, 530, 2 pcs. For older 2WD models that are not based on the 4WD models, please refer to Sportsline 2008. or if an RC plate is no longer fitted, check Sportsline 13 in Parts Scout.There you will find the right spare parts for your vehicle.

€21.90*

Average rating of 0 out of 5 stars

68265/01 FG Front lower plastic wishbone 4WD, 1:6
Genuine FG spare/option part.New version with more steering.Contents:2 pieces

€25.90*

Average rating of 0 out of 5 stars

66287 FG Shock tower front 2WD/4WD
Genuine FG spare/option part. FG Shock tower front 2WD/4WDFor older 2WD models that are not based on the 4WD models, please refer to Sportsline 2008. or if an RC plate is no longer fitted, check Sportsline 13 in Parts Scout.There you will find the right spare parts for your vehicle.Contents:1 piece

€9.90*

Average rating of 0 out of 5 stars

7020/17 FG Front bumper for Porsche 911 GT3R
Genuine FG spare/option part. Suitable for Porsche 911 GT3R.Dimensions:Length: 135 mmWidth: 390 mmContents:1 piece

€29.90*

Similar products

Average rating of 0 out of 5 stars

y1380 High performance starter rope, carbon grey
3 mm high performance starter rope; with a breaking strength of almost a metric ton it is far superior to any other starter rope available. Even large displacement high compression engines are no match for this rope. Please note:The usual fusion of cutting edges and knots on standard starter ropes using a flame is mostly unrewarding with this rope! We therefore recommend securing the knots with 2 - 3 drops of superglue on the outside. Length approx. 80 cm; fits all current pull starters.

€8.90*

Average rating of 0 out of 5 stars

7354/08 FG Spacer plate for CY / Zenoah / Fuelie
Genuine FG spare/option part.Installs between carb and air filter/airbox to assure choke flap clearance.Contents:1 piece

€11.30*

Average rating of 0 out of 5 stars

7304/02 FG Ball bearing for CY / Zenoah / Fuelie
Genuine FG spare/option part.Dimensions:12 x 28 x 8 mmContents:2 pieces

€25.90*

Average rating of 0 out of 5 stars

7303/08 FG Seal ring for CY / Zenoah / Fuelie
Genuine FG spare/option part.Spare partvv for CY / Zenoah G230/260.One each 1x 12 x 28 x 7 mm and 12 x 22 x 7 mmContents:2 pieces

€19.90*

Average rating of 0 out of 5 stars

s23019, Exhaust gasket PT 23/28
Actual product may be of different color. We have no bearing on this since we are not the manufacturer.Please note:It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. We also recommend:y0804 HT-flange sealer 518 y0994 Marston sealery0807 MD-Sil RTV silicone sealer

€2.95*

Average rating of 0 out of 5 stars

903190, Engine kill switch
Please note:The usual spare parts supply is not yet available for these engines. Therefore the parts may come from disassembled new engines. Since every single engine is tested at the factory, the parts may show some minor signs of "use".

€6.80*

Average rating of 0 out of 5 stars

s23013, Carburetor spacer plate PT 23/28, set
Spacer plate with 2 gaskets.

€4.90*

Average rating of 0 out of 5 stars

s23021 Carburetor gasket PT 23/28
Genuine Smartech spare/option part.Please note: It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. Actual product may be of different color. We have no bearing on this since we are not the manufacturer.Please note:It is recommended to use a gasket sealer with every gasket on an engine. This gives better sealing anda longer lasting gasket. We also recommend:y0804 HT-flange sealer 518 y0994 Marston sealery0807 MD-Sil RTV silicone sealerContent:1 piece

€5.90*

Average rating of 0 out of 5 stars

s23024, Needle bearing PT 23/28, 1 pce.

€7.90*

Average rating of 0 out of 5 stars

903197, Flywheel
Please note:The usual spare parts supply is not yet available for these engines. Therefore the parts may come from disassembled new engines. Since every single engine is tested at the factory, the parts may show some minor signs of "use".

€35.99*

Average rating of 0 out of 5 stars

s23007, Clutch set PT 23/28
Clutch shoes with spring, mounting bolts and washers.

€27.70*

Average rating of 0 out of 5 stars

903184, Clutch set
Complete clutch with spring, carrier and bolts.Please note:The usual spare parts supply is not yet available for these engines. Therefore the parts may come from disassembled new engines. Since every single engine is tested at the factory, the parts may show some minor signs of "use".

€27.70*

Customers also viewed

Average rating of 0 out of 5 stars

2012-35 Mecatech Fixing wheel Nut
Genuine Mecatech spare/option part for the FW01.Content:4 pieces

€4.00*

Average rating of 0 out of 5 stars

TW-04 Mecatech Winter jacket
mec_tw_04 Size: L - Large
Genuine Mecatech spare/option part. Please note:Due to the variety of sizes, the garments will be ordered from Mecatech only after receipt of payment and usually arrive at our shop after approx. two weeks. We ask for your understanding. Available sizes:Contents:1 piece

€159.90*

Average rating of 0 out of 5 stars

y1610 SPEED TEC Expert 7-port Zenoah G320 modified engine
The SPEED TEC 7-port genuine Zenoah engine is optimized for performance by hand with sophisticated craftsmanship and guarantees, besides greatly increased performance, excellent workmanship and stamina. More power and torque through the three additional transfer ports.SPEED TEC V 7-port version modifications: Cylinder:Cylinder bottom modified for higher compressionenlarged and flow-optimized transfer portsmachining of three additional transfer ports raises number of ports from 4 to 7intake and exhaust ports optimized and matchedport timing modifiedCrankshaft:is adjusted, aligned and balancedFlywheel and ignition:Weight reduced and checked for run-out.Gaskets:Premium quality gaskets installed. Cylinder gasket installed using elastic gasket sealer.With the new "K & N" version of the Losi DBXL there is another detail, which need to be considered.From the very beginning the hole pattern for the engine installation in the DBXL chassis plate was no precise match to the hole pattern of the engine, even when delivered in stock form with standard engine. Now with the "K&N" version the engine mount has been changed to eliminate this discrepancy. However, all aluminum engine mounts available on the market share their dimensions with the previous plastic engine mount. For the installation of a G320 Zenoah in a "K&N" -DBXL two possible combinations exist in order to obtain the correct hole pattern:When using the standard (new) plastic engine mount a shortened clutch housing is required as in a 5ive-TWhen using an aluminum engine mount a stock length clutch housing is requiredSeparately, it is recommended to enlarge the cutout in the body panel in front of the K & N air filter for about 2 - 3 mm to ensure that the panel cannot chafe on the air filter.For all HPI Baja 5 cars the G320RCer clutch housing has to be shortened at the mounting base, for Losi 5ive- T and Desert Buggy XL cars the clutch housings overall length must be shortened to CY size.When installing the air filter you must pay attention to the length of the screws.For use on Losi and HPI we recommend M5x45 screws (like H94763); you can also cut existing screws to length, of course.When ordering with a modified clutch housing we will include these screws!In our shop you can select from Zenoah G320RC engines already modified to fit your HPI or Losi car.The installation of a Zenoah G320RC in a Smartech C5 onroad car is possible without modifications. However, due to the engines performance aluminum engine mounts (set # y0189) are mandatory!The installation of the Zenoah G320RC in other cars (like FG or Smartech buggies / monsters a.s.o.) is not even remotely straightforward, since the layshaft pinion (the small pinion in front of the big differential spur gear) is in the way for the larger Zenoah G320RC crankcase.Compatibility Zenoah / Losi 5ive-T:Please note that for installation in a Losi 5ive the fan cover must be swapped for a Losi or CY cover #5341 in order to fit the chassis" bolt pattern.If you want to install a Zenoah engine into the Losi 5ive, you usually have to use a fan cover from the CY engine.However, there is a workaround to maintain Zenoah fan cover.The adjustment is done via the pinion specific mounting plates for the engine. The change always affects only the rear, outer (carburetor side) plate under the fan cover. This is rotated by 180°; so that the embossed number on this plate faces the exhaust side of the engine!18T pinion: use 20T plate, rotated 180°19T pinion: use 19T plate, rotated 180°20T pinion: use 18T plate, rotated 180°On the plus side you gain the opportunity to easily mount a Zenoah engine keeping the original fan cover. On the other hand there will be the disadvantage of the necessity to combine two different sets of engine mounting plates when installing any pinion other than the stock 19T version. Therefore we do not recommend this workaround for everyday use. Nevertheless it works perfectly should ever the need arise. Attention! We recommend to run exclusively fully synthetic 2-stroke engine oil, like y0813 Motul 800 racing oil.

€809.00*

Average rating of 0 out of 5 stars

y0568 Bowden cable mount 1/5, 2 pcs.

€12.60*
Loading...
Upload in progress, please be patient ...
Shopware-Plugin Development Shopware-Agency