16 products found for "y19047_02"

rc-car-online - Home

y19047/02 O-rings for y19047

y19047_02 Size: for (red) buggy shocks, y19047/01

Genuine HT spare/option part. Replacement o-rings for aluminum shock pistons no. y19047.Contents:4 pieces

€3.90*

y19047/01 Alloy shock pistons for buggy shocks

Genuine HT spare/option part. O-ring piston for the red FG buggy shocks for optimum shock performance.These pistons cause almost no wear to the shock body. Because of this we recommend a break-in period of a couple of gas tanks for the shocks with the original piston to smoothen the body's surface. Then swap the pistons for the new o-ring piston. Doing so will give you the best results possible.Fits standard piston rods! Of course, piston rods are not included.Contents:4 pieces

€26.30*

y19043 HT-Racin Oil

Fully synthetic 2-stroke engine oil, one bottle per 2.5 liters of gas.100ml bottle

Content: 100 Milliliter (€76.50* / 1000 Milliliter)

€7.65* €8.50* (10% saved)

y19049/01 Upper shock quick mount SW8

Genuine HT spare/option part. The upper shock quick mount makes it easier to change the shocks. No tool is needed, since a small body clip replaces the previously used nylock nut SW8.Fits front and rear axle. Including bolts and body clips.Contents:2 pieces

€10.20*

y19013 K&N Air filter oil

Genuine K&N spare/option part. The K+N air filter oil is only suitable for all K+N air filters, foam preliminary filters and filter inserts.Content:1 piece / 204 ml

Content: 204 Milliliter (€78.97* / 1000 Milliliter)

€16.11* €17.90* (10% saved)

Foam precleaner, y19017 - 1pce.

For the smaller K&N filter

€2.70*

HT-Airbox Evo, y19028 - 1pce.

HT-airboxes, very small, low height design and low weight; but with a large (45 mm diameter) filter element. The boxes will fit on a FG car under a Porsche GT3 body and weighs even less than a FG Formula 1 airbox. The filter mounts directly above the carburetor and remains there, even when the box itself has been removed.The Evo-airbox has a higher flow rate, which is important for the high revving engines in onroad cars. Its diameter (100 mm) will usually allow an installation only in a few buggies with a vertically mounted engine, like Gas Devil / Titan / Helldevil.All parts available separately.

€51.20*

battery monitor, y19004

The battery monitor allows to check battery voltage and servo load. Different connectors available, your choice of 6 or 7,2 volts version.

€37.90*

Venturi adaptor, y19021 - 1pce.

luftf_0026 Engine: Solo

Adaptor from the sets above, without filter or airbox.

€41.00*

y19018 FG/Carson/Smartech 2WD ball bearing set, sealed, set

lager_0002 Car: y19600-RS Version for plastic diff excepting F1

Contains all bearings for the specified FG-car.Complete ball bearing set for all FG touring and offroad 2WD cars (your choice of plastic or alloy diff case). Not suitable for WB535 Modelle.The set includes:wheel bearing, 8 pcs., 8x22x7 mmclutch bell bearing, 2 pcs., 10x22x6 mmlayshaft bearing, 2 pcs., 10x19x7 mmdiff bearing, 2 pcs., 12x28x8 mm for plastic diff case or 15x28x7 mm for aluminum diff case.

€69.90*

Hose clamps, y19032 - 2pcs.

Sold per pair, max. inner diameter 21 mm. Narrow version, especially for securing the spark plug cap shield.

€3.90*

Replacement o-ring for HT venturi adaptors, y19022 - 2pcs.

Fits both buggy and street venturi adaptors.Pack of 2.

€5.10*

y19015 Bindulin Dichtfix (untill 180°!)

Bindulin liquid rubber - very high elasticitySuitable for additional sealing of tuned pipes and exhaust / manifold connections .Temperature resistant from -60 ° to + 180 ° CResistant against diluted acids.Also for sealing threaded joints, electric lines and cable lead-throughs in receiver boxes.The surfaces must be clean, grease free and dry (brake cleaner).Contents:1 piece / 45 grams

Content: 45 Gramm (€331.11* / 1000 Gramm)

€14.90*

Filter element HT-Airbox, y19025 - 1pce.

Replacement filter cartridge

€20.50*

y19031/01 Silicone exhaust hose extrem reinforced 22/30 mm

Genuine HT spare/option part. Very strong, multiple glas fiber layers, nevertheless very stretchable. Resist maximum temperatures up to 250°C (482°F) from.Needs hose clamps with at least 35 mm inner diameter! Maße:Inside diameter: 22 mm Outside diameter: 30 mmWall thickness: 4 mmLength: 50 mmContents:1 piece

€9.90*

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Adaptor blocks for carbon RC-plate, y19005/01 - 1pce.

Alloy adaptor blocks for the RC-plate above.When you use MPX Jumbos or Hitec 5735/5745 for brake throttle, these blocks will bring the servos to the correct height.

€12.30*

16 products found for "y19047_02"

Filter products

rc-car-online - Home